Richong Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Richong Liu has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Takeshi Asai
Faculty of Health and Sports Sciences, University of Tsukuba, Tsukuba, Japan
3 shared publications Adam C. Clansey
University of British Columbia
1 shared publication- Gabriel Lozano-Berges
Universidad de Zaragoza
1 shared publication Hiroki Hakata
1 shared publication- Hiroki Hakata
Hosei University
1 shared publication - John Eric Goff
Department of Physics, University of Lynchburg , Lynchburg, Virginia 24501
1 shared publication
Latest Publications
- Open Access
- 13 July 2026
- Published by Elsevier in Football Studies
- Vol. 2
Kinematic factors associated with first-touch control and trap-to-pass transition in football during a dynamic receive-to-pass task
- 13 July 2026
- Published by Elsevier in Football Studies
- Vol. 2
Open AccessKinematic factors associated with first-touch control and trap-to-pass transition in football during a dynamic receive-to-pass task
- 26 May 2026
- Published by SAGE Publications in International Journal of Sports Science & Coaching
Influence of ball launch angle and velocity on flight distance in youth elite goalkeepers’ goal kicks
This study aimed to clarify how ball launch angle and initial velocity influence flight distance in goal kicks performed by elite youth soccer goalkeepers, and to identify the launch angles associated with maximal distance. Six goalkeepers from the same elite youth team performed maximal-effort place kicks on a stationary ball, simulating goal-kick conditions. The three-dimensional ball motion was recorded using an optical motion capture system (500 Hz), and launch angle and initial velocity were calculated. For each participant, a linear regression model describing the angle–velocity relationship was constructed. Flight distance was then estimated using two-dimensional numerical trajectory simulations under a no-spin assumption. Across all participants, initial velocity consistently decreased as launch angle increased, although the strength of this relationship and the regression characteristics varied markedly between individuals. Simulations based on measured launch angles and velocities showed that flight distance increased with launch angle within the observed range. When the launch angle range was extrapolated from 5° to 50°, the angle–distance relationship exhibited a quadratic pattern, with maximal flight distances typically occurring at launch angles between approximately 25° and 30°. These findings indicate that the optimal launch angle for goal kicks is not uniform, but instead depends on each goalkeeper's individual angle–velocity characteristics. This study highlights the importance of individualized, biomechanics-based optimization of launch conditions, rather than relying on a single, standardized angle, for maximizing goal-kick distance in soccer.
- 26 May 2026
- Published by SAGE Publications in International Journal of Sports Science & Coaching
Influence of ball launch angle and velocity on flight distance in youth elite goalkeepers’ goal kicks
This study aimed to clarify how ball launch angle and initial velocity influence flight distance in goal kicks performed by elite youth soccer goalkeepers, and to identify the launch angles associated with maximal distance. Six goalkeepers from the same elite youth team performed maximal-effort place kicks on a stationary ball, simulating goal-kick conditions. The three-dimensional ball motion was recorded using an optical motion capture system (500 Hz), and launch angle and initial velocity were calculated. For each participant, a linear regression model describing the angle–velocity relationship was constructed. Flight distance was then estimated using two-dimensional numerical trajectory simulations under a no-spin assumption. Across all participants, initial velocity consistently decreased as launch angle increased, although the strength of this relationship and the regression characteristics varied markedly between individuals. Simulations based on measured launch angles and velocities showed that flight distance increased with launch angle within the observed range. When the launch angle range was extrapolated from 5° to 50°, the angle–distance relationship exhibited a quadratic pattern, with maximal flight distances typically occurring at launch angles between approximately 25° and 30°. These findings indicate that the optimal launch angle for goal kicks is not uniform, but instead depends on each goalkeeper's individual angle–velocity characteristics. This study highlights the importance of individualized, biomechanics-based optimization of launch conditions, rather than relying on a single, standardized angle, for maximizing goal-kick distance in soccer.
- Open Access
- 14 March 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (6) , 2808
Trionda: Enhanced Surface Roughness Relative to Previous FIFA World Cup Match Balls
Wind-tunnel experiments were conducted on Trionda, the official match ball of the 2026 FIFA World Cup. Aerodynamic force coefficients derived from these measurements were incorporated into numerical trajectory simulations of kicked balls. The resulting aerodynamic characteristics and simulated flight behavior were compared with those of the four previous World Cup match balls: Al Rihla (2022), Telstar 18 (2018), Brazuca (2014), and Jabulani (2010). Relative to its predecessors, Trionda exhibits a drag crisis at lower flow speeds, consistent with an apparently rougher surface. Although its turbulent-regime drag coefficient is more stable than those of earlier designs, its magnitude is modestly larger. Trajectory simulations therefore indicate the potential for small but perceptible reductions in range for long kicks. This study therefore provides the first aerodynamic characterization of the 2026 FIFA World Cup match ball (Trionda) and places its drag-crisis behavior and flight characteristics in direct quantitative comparison with those of recent World Cup balls examined under identical experimental conditions.
- 14 March 2026
- Published by MDPI AG in Applied Sciences
- Vol. 16 (6) , 2808
Open AccessTrionda: Enhanced Surface Roughness Relative to Previous FIFA World Cup Match Balls
Wind-tunnel experiments were conducted on Trionda, the official match ball of the 2026 FIFA World Cup. Aerodynamic force coefficients derived from these measurements were incorporated into numerical trajectory simulations of kicked balls. The resulting aerodynamic characteristics and simulated flight behavior were compared with those of the four previous World Cup match balls: Al Rihla (2022), Telstar 18 (2018), Brazuca (2014), and Jabulani (2010). Relative to its predecessors, Trionda exhibits a drag crisis at lower flow speeds, consistent with an apparently rougher surface. Although its turbulent-regime drag coefficient is more stable than those of earlier designs, its magnitude is modestly larger. Trajectory simulations therefore indicate the potential for small but perceptible reductions in range for long kicks. This study therefore provides the first aerodynamic characterization of the 2026 FIFA World Cup match ball (Trionda) and places its drag-crisis behavior and flight characteristics in direct quantitative comparison with those of recent World Cup balls examined under identical experimental conditions.
- 27 June 2025
- Published by SAGE Publications in International Journal of Sports Science & Coaching
- Vol. 21 (1) , 216-226
Motion characteristics of directional ball-trapping techniques in soccer: A comparative study of advanced and intermediate players
This study investigated the motion characteristics of ball-trapping techniques in soccer, focusing on directional changes in spaces between the defense and midfield lines by comparing advanced and intermediate university-level players. Effective ball-trapping techniques are critical for maintaining stability during play and for enabling offensive strategies. Although limited studies have been conducted on ball trapping, often using oversimplified and closed-skill environments, this study identified the technical factors that enhance these skills to improve performance in match settings. Motion-capture technology focuses on ball-to-foot contact control, pelvic orientation, and ankle-eversion angular speed. Ten advanced and eight intermediate soccer players participated in this study, and each performed multiple directional ball-trapping trials under standardized conditions. The advanced group demonstrated significantly shorter total trapping times than the intermediate group ( p < 0.05). The vertical distance between the center of the ball and the ball-to-foot contact point was larger and the horizontal distance was smaller in the advanced group ( p < 0.05). Additionally, the advanced players exhibited pelvic orientational angles that were more parallel to the ball trajectory and demonstrated higher ankle-eversion angular speeds during impact ( p < 0.05). These results suggest that advanced players minimize trapping errors through precise ball-to-foot contact adjustment, proactive pelvic rotation, and effective utilization of ankle flexibility and strength. These technical elements enable smoother transitions and improved directional changes during play. The findings provide valuable insights for coaching, emphasizing drills to enhance ball-to-foot contact precision, pelvic rotation, and ankle flexibility, improving overall trapping performance.
- 27 June 2025
- Published by SAGE Publications in International Journal of Sports Science & Coaching
- Vol. 21 (1) , 216-226
Motion characteristics of directional ball-trapping techniques in soccer: A comparative study of advanced and intermediate players
This study investigated the motion characteristics of ball-trapping techniques in soccer, focusing on directional changes in spaces between the defense and midfield lines by comparing advanced and intermediate university-level players. Effective ball-trapping techniques are critical for maintaining stability during play and for enabling offensive strategies. Although limited studies have been conducted on ball trapping, often using oversimplified and closed-skill environments, this study identified the technical factors that enhance these skills to improve performance in match settings. Motion-capture technology focuses on ball-to-foot contact control, pelvic orientation, and ankle-eversion angular speed. Ten advanced and eight intermediate soccer players participated in this study, and each performed multiple directional ball-trapping trials under standardized conditions. The advanced group demonstrated significantly shorter total trapping times than the intermediate group ( p < 0.05). The vertical distance between the center of the ball and the ball-to-foot contact point was larger and the horizontal distance was smaller in the advanced group ( p < 0.05). Additionally, the advanced players exhibited pelvic orientational angles that were more parallel to the ball trajectory and demonstrated higher ankle-eversion angular speeds during impact ( p < 0.05). These results suggest that advanced players minimize trapping errors through precise ball-to-foot contact adjustment, proactive pelvic rotation, and effective utilization of ankle flexibility and strength. These technical elements enable smoother transitions and improved directional changes during play. The findings provide valuable insights for coaching, emphasizing drills to enhance ball-to-foot contact precision, pelvic rotation, and ankle flexibility, improving overall trapping performance.