Shinichi Morisaka
Research Subjects
Shinichi Morisaka has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Ryutaro Ohira
QuEL, Inc. 1 , Hachioji ON Building 5F, 4-7-14 Myojincho, Hachioji, Tokyo
4 shared publications - Takefumi Miyoshi
QuEL, Inc. 1 , Hachioji ON Building 5F, 4-7-14 Myojincho, Hachioji, Tokyo
4 shared publications - Atsushi Noguchi
The University of Tokyo
2 shared publications - Ippei Nakamura
Komaba Institute for Science (KIS), The University of Tokyo 4 , 3-8-1 Komaba, Meguro, Tokyo 153-8902
2 shared publications - Utako Tanaka
Graduate School of Engineering Science, The University of Osaka, Toyonaka, Japan
2 shared publications - Yoshinori Kurimoto
QuEL, Inc. 1 , Hachioji ON Building 5F, 4-7-14 Myojincho, Hachioji, Tokyo
2 shared publications
Latest Publications
- 31 August 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (9)
Cryogenic time-division-multiplexed voltage control for scalable trapped-ion quantum processors
Trapped-ion quantum computers based on the quantum charge-coupled device architecture require on the order of ten trap electrodes per qubit, making the number of vacuum feedthroughs a bottleneck at the system scale. Time-division multiplexed (TDM)-based voltage control for trap electrodes provides a natural route to alleviate this constraint. However, previous studies have been limited to architectural proposals for static trap-potential compensation and room-temperature demonstrations of dynamic-electrode control, leaving cryogenic operation of TDM-based voltage control for static and dynamic electrodes experimentally unexplored. In this study, we develop and cryogenically validate TDM-based voltage control schemes for two distinct electrode classes. For static electrodes used in trap-potential compensation, we implement a 32-channel demultiplexed system operating at approximately 27 K, achieving an effective voltage update rate of 37.5 kHz with an output range of ±10 V per channel. For dynamic electrodes used in ion operations, such as shuttling, we implement a four-channel demultiplexed system operating at approximately 14 K, achieving an effective voltage update rate of 1 MHz with a comparable output range. These results establish TDM-based voltage control as a practical approach for both electrode classes, providing a path for mitigating the vacuum feedthrough bottleneck in scalable trapped-ion quantum processors.
- 31 August 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (9)
Cryogenic time-division-multiplexed voltage control for scalable trapped-ion quantum processors
Trapped-ion quantum computers based on the quantum charge-coupled device architecture require on the order of ten trap electrodes per qubit, making the number of vacuum feedthroughs a bottleneck at the system scale. Time-division multiplexed (TDM)-based voltage control for trap electrodes provides a natural route to alleviate this constraint. However, previous studies have been limited to architectural proposals for static trap-potential compensation and room-temperature demonstrations of dynamic-electrode control, leaving cryogenic operation of TDM-based voltage control for static and dynamic electrodes experimentally unexplored. In this study, we develop and cryogenically validate TDM-based voltage control schemes for two distinct electrode classes. For static electrodes used in trap-potential compensation, we implement a 32-channel demultiplexed system operating at approximately 27 K, achieving an effective voltage update rate of 37.5 kHz with an output range of ±10 V per channel. For dynamic electrodes used in ion operations, such as shuttling, we implement a four-channel demultiplexed system operating at approximately 14 K, achieving an effective voltage update rate of 1 MHz with a comparable output range. These results establish TDM-based voltage control as a practical approach for both electrode classes, providing a path for mitigating the vacuum feedthrough bottleneck in scalable trapped-ion quantum processors.
- 1 March 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (3)
Microwave output stabilization of a qubit controller via device-level temperature control
We present the design and performance of QuEL-1 SE, which is a multichannel qubit controller developed for superconducting qubits. The system incorporates the active thermal stabilization of critical analog integrated circuits, such as phase-locked loops, amplifiers, and mixers, to suppress the long-term amplitude and phase drift. To evaluate the amplitude and phase stability, we simultaneously monitor 15 microwave output channels over 24 h using a common analog-to-digital converter. Across the channels, the normalized amplitude exhibits standard deviations of 0.09%–0.22% (mean: 0.15%), and the phase deviations are 0.35°–0.44° (mean: 0.39°). We further assess the impact of these deviations on quantum gate operations by estimating the average fidelity of an Xπ/2 gate under the coherent errors corresponding to the deviations. The resulting estimated contribution to the Xπ/2 gate infidelity due to amplitude noise (2 × 10−6) and phase misalignment (2 × 10−5) is significantly lower than typical fault-tolerance thresholds such as those of the surface [Fowler et al., Phys. Rev. A 86, 032324 (2012)]. These results demonstrate that the amplitude and phase stability of QuEL-1 SE enable reliable long-duration quantum operations, thus highlighting its utility as a scalable control platform for superconducting and other qubit modalities.
- 1 March 2026
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 97 (3)
Microwave output stabilization of a qubit controller via device-level temperature control
We present the design and performance of QuEL-1 SE, which is a multichannel qubit controller developed for superconducting qubits. The system incorporates the active thermal stabilization of critical analog integrated circuits, such as phase-locked loops, amplifiers, and mixers, to suppress the long-term amplitude and phase drift. To evaluate the amplitude and phase stability, we simultaneously monitor 15 microwave output channels over 24 h using a common analog-to-digital converter. Across the channels, the normalized amplitude exhibits standard deviations of 0.09%–0.22% (mean: 0.15%), and the phase deviations are 0.35°–0.44° (mean: 0.39°). We further assess the impact of these deviations on quantum gate operations by estimating the average fidelity of an Xπ/2 gate under the coherent errors corresponding to the deviations. The resulting estimated contribution to the Xπ/2 gate infidelity due to amplitude noise (2 × 10−6) and phase misalignment (2 × 10−5) is significantly lower than typical fault-tolerance thresholds such as those of the surface [Fowler et al., Phys. Rev. A 86, 032324 (2012)]. These results demonstrate that the amplitude and phase stability of QuEL-1 SE enable reliable long-duration quantum operations, thus highlighting its utility as a scalable control platform for superconducting and other qubit modalities.
- 8 December 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (23)
Trapping an atomic ion using time-division multiplexed digital-to-analog converters
Independent control of numerous electrodes in quantum charge-coupled device architectures presents a significant challenge for wiring and hardware scalability. To address this issue, we demonstrate a voltage control method based on time-division multiplexing (TDM). This approach utilizes a single high-update-rate digital-to-analog converter (DAC) to sequentially generate control signals for multiple electrodes, thereby reducing both the number of required DACs and associated wiring. We experimentally validate this concept by developing a 10-channel system that operates with only two DACs. The developed TDM-based voltage control system is applied to a surface electrode trap, where we successfully trap a single 40Ca+ ion and demonstrate a simple ion transport primitive. This approach offers a resource-efficient and scalable solution for advanced quantum computing systems based on trapped ions.
- 8 December 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (23)
Trapping an atomic ion using time-division multiplexed digital-to-analog converters
Independent control of numerous electrodes in quantum charge-coupled device architectures presents a significant challenge for wiring and hardware scalability. To address this issue, we demonstrate a voltage control method based on time-division multiplexing (TDM). This approach utilizes a single high-update-rate digital-to-analog converter (DAC) to sequentially generate control signals for multiple electrodes, thereby reducing both the number of required DACs and associated wiring. We experimentally validate this concept by developing a 10-channel system that operates with only two DACs. The developed TDM-based voltage control system is applied to a surface electrode trap, where we successfully trap a single 40Ca+ ion and demonstrate a simple ion transport primitive. This approach offers a resource-efficient and scalable solution for advanced quantum computing systems based on trapped ions.
- Open Access
- 9 April 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (14)
Development of a bipolar 50 V output digital-to-analog converter system for ion-shuttling operations
The quantum charge-coupled device (QCCD) is one of the notable architectures to achieve large-scale trapped-ion quantum computers. To realize QCCD architecture, ions must be transported quickly while minimizing motional excitation. High-voltage sources are necessary to achieve such high-quality ion transport through a high secular frequency. In this study, we report the development of a field programmable gate array-based digital-to-analog converter (DAC) system with an output voltage range of ±50 V and demonstrate its effectiveness in ion transport operations. The device provides a 16-channel analog output, a maximum update rate of 16 mega updates per second, a slew rate of 20 V/μs, and a bandwidth of >200 kHz. By optimizing the voltage sets with quadratic programming, we experimentally confirmed that this DAC system can achieve more than twice the secular frequency attainable when its output range is restricted to ±10 V, which is consistent with the fact that scaling all electrode voltages by a factor of 5 will scale the secular frequency by 5. Since the output range of many commercially available DACs is commonly limited to ±10 V, this increase is effective for ion-shuttling operations, such as transport, split, and merge. The developed DAC system has the potential to increase the speed of ion transport thereby reducing processing times in QCCD-based quantum computers.
- 9 April 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (14)
Open AccessDevelopment of a bipolar 50 V output digital-to-analog converter system for ion-shuttling operations
The quantum charge-coupled device (QCCD) is one of the notable architectures to achieve large-scale trapped-ion quantum computers. To realize QCCD architecture, ions must be transported quickly while minimizing motional excitation. High-voltage sources are necessary to achieve such high-quality ion transport through a high secular frequency. In this study, we report the development of a field programmable gate array-based digital-to-analog converter (DAC) system with an output voltage range of ±50 V and demonstrate its effectiveness in ion transport operations. The device provides a 16-channel analog output, a maximum update rate of 16 mega updates per second, a slew rate of 20 V/μs, and a bandwidth of >200 kHz. By optimizing the voltage sets with quadratic programming, we experimentally confirmed that this DAC system can achieve more than twice the secular frequency attainable when its output range is restricted to ±10 V, which is consistent with the fact that scaling all electrode voltages by a factor of 5 will scale the secular frequency by 5. Since the output range of many commercially available DACs is commonly limited to ±10 V, this increase is effective for ion-shuttling operations, such as transport, split, and merge. The developed DAC system has the potential to increase the speed of ion transport thereby reducing processing times in QCCD-based quantum computers.