Jesús Ortiga-Fibla
Research Subjects
Jesús Ortiga-Fibla has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Ana Cros
Materials Science Institute, University of Valencia, P.O. Box 22085, 46071 Valencia, Spain
2 shared publications - Eldad Bahat Treidel
Ferdinand-Braun-Institut (FBH), Berlin, Germany
2 shared publications - Frank Brunner
Ferdinand-Braun-Institut (FBH)
2 shared publications - Oliver Hilt
Ferdinand-Braun-Institut, Leibniz-Institut fr Hchstfrequenztechnik, Berlin, Germany
2 shared publications - Albert Ferrando
Instituto de Ciencia de los Materiales Universidad de Valencia Paterna Spain
1 shared publication Ana Cros
1 shared publication
Latest Publications
- Open Access
- 5 March 2026
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 209
Thermal strain, lattice parameters and thermal expansion coefficients of GaN structures for power devices analyzed by Raman microscopy
- 5 March 2026
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 209
Open AccessThermal strain, lattice parameters and thermal expansion coefficients of GaN structures for power devices analyzed by Raman microscopy
- 10 November 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (19)
Generalized Purcell factor enhancement of perovskite nanocrystals in an open cavity at room temperature
Cavity interactions are crucial to several high-efficiency photonic devices, such as resonant cavity light-emitting diodes and vertical cavity surface emitting lasers. In particular, optical microcavities are conventionally used to achieve sufficiently bright single photon sources to be utilized in modern photonic quantum technologies. We present a study of the cavity-funneling effect of the optical emission from an ensemble of CsPbBr3 PNCs embedded in an open optical plano–convex microcavity at room temperature with two different radii of curvature of the convex mirror. A generalized Purcell factor of F*=30 is found. The increase in Purcell factor as a function of the cavity radius of curvature (RoC) is compared to the decrease in the effective mode volume with RoC, obtained via a 3D simulation of the two cavity configurations with radii of curvature of 12 and 99 μm. The effective mode volume reduction going from the 99 μm to the 12 μm RoC configuration is identified as the most plausible origin for the greater optical emission enhancement observed in the smaller RoC cavity. Other secondary factors such as an increased coupling to single transverse modes or the increase in the Q-factor are discussed and placed in context, as the basis for future designs of more effective cavity systems for perovskite nanocrystals at room temperature.
- 10 November 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (19)
Generalized Purcell factor enhancement of perovskite nanocrystals in an open cavity at room temperature
Cavity interactions are crucial to several high-efficiency photonic devices, such as resonant cavity light-emitting diodes and vertical cavity surface emitting lasers. In particular, optical microcavities are conventionally used to achieve sufficiently bright single photon sources to be utilized in modern photonic quantum technologies. We present a study of the cavity-funneling effect of the optical emission from an ensemble of CsPbBr3 PNCs embedded in an open optical plano–convex microcavity at room temperature with two different radii of curvature of the convex mirror. A generalized Purcell factor of F*=30 is found. The increase in Purcell factor as a function of the cavity radius of curvature (RoC) is compared to the decrease in the effective mode volume with RoC, obtained via a 3D simulation of the two cavity configurations with radii of curvature of 12 and 99 μm. The effective mode volume reduction going from the 99 μm to the 12 μm RoC configuration is identified as the most plausible origin for the greater optical emission enhancement observed in the smaller RoC cavity. Other secondary factors such as an increased coupling to single transverse modes or the increase in the Q-factor are discussed and placed in context, as the basis for future designs of more effective cavity systems for perovskite nanocrystals at room temperature.
- Open Access
- 24 July 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (4)
Phonon–plasmon coupled modes in GaN vertical power structures: Carrier concentration and mobility analysis
Confocal Raman microscopy is proposed as a non-invasive method for determining carrier density and mobility in GaN structures used in vertical power devices. The electronic properties of two GaN epilayers grown on 100 mm c-plane sapphire substrates via metal–organic chemical vapor deposition are investigated by analyzing the longitudinal phonon–plasmon (LPP) modes of the highly conductive GaN bottom layer, the drain layer of the device. Due to the wide range of device architectures, two scenarios are considered: (1) direct optical access to the drain, where LPPs are measured from the side, and (2) no direct access, where LPPs are measured from the top, in a buried layer. In the latter case, the effect of aberrations introduced by the refractive index mismatch at the air–GaN interface is discussed. The LPPs are fitted using a theoretical model incorporating strain and three electron–phonon interaction mechanisms: electro-optical, deformation potential, and charge density fluctuations. The relative impact of these contributions is discussed, revealing that charge density fluctuations dominate and must be considered for the accurate correlation of the experiment and model. Finally, the carrier density and mobility values are extracted and compared with available data, showing the method’s potential for characterizing vertical GaN-based power-device structures.
- 24 July 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (4)
Open AccessPhonon–plasmon coupled modes in GaN vertical power structures: Carrier concentration and mobility analysis
Confocal Raman microscopy is proposed as a non-invasive method for determining carrier density and mobility in GaN structures used in vertical power devices. The electronic properties of two GaN epilayers grown on 100 mm c-plane sapphire substrates via metal–organic chemical vapor deposition are investigated by analyzing the longitudinal phonon–plasmon (LPP) modes of the highly conductive GaN bottom layer, the drain layer of the device. Due to the wide range of device architectures, two scenarios are considered: (1) direct optical access to the drain, where LPPs are measured from the side, and (2) no direct access, where LPPs are measured from the top, in a buried layer. In the latter case, the effect of aberrations introduced by the refractive index mismatch at the air–GaN interface is discussed. The LPPs are fitted using a theoretical model incorporating strain and three electron–phonon interaction mechanisms: electro-optical, deformation potential, and charge density fluctuations. The relative impact of these contributions is discussed, revealing that charge density fluctuations dominate and must be considered for the accurate correlation of the experiment and model. Finally, the carrier density and mobility values are extracted and compared with available data, showing the method’s potential for characterizing vertical GaN-based power-device structures.
- 6 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Confocal Micro-Raman Spectroscopy Study of Phonon-Plasmon Modes in GaN Structures for Power Devices
Confocal micro-Raman spectroscopy is presented as a non-invasive tool to address different material properties of semiconductors for power devices. In the present work, the quantification of carrier concentration and mobility are addressed by studying the evolution of different phonon modes and their coupling with the plasmon.
- 6 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Confocal Micro-Raman Spectroscopy Study of Phonon-Plasmon Modes in GaN Structures for Power Devices
Confocal micro-Raman spectroscopy is presented as a non-invasive tool to address different material properties of semiconductors for power devices. In the present work, the quantification of carrier concentration and mobility are addressed by studying the evolution of different phonon modes and their coupling with the plasmon.