Md. Mahmodul Hassan Pranto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Md. Mahmodul Hassan Pranto has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Shadman Mostafa
Department of Electrical and Electronic Engineering, University of Dhaka, Dhaka-1000, Bangladesh
2 shared publications - Ahsan Habib
Department of Electrical and Electronic Engineering, University of Dhaka, Dhaka, Bangladesh
1 shared publication - Harinarayan Das
Bangladesh Atomic Energy Commission, Dhaka-1000, Bangladesh
1 shared publication - Mahmudur Rahman
Department of Electrical and Electronic Engineering, Dhaka University of Engineering & Technology, Gazipur-1707, Bangladesh
1 shared publication Mohammad Atiqul Islam
Prime University
1 shared publicationPranto
1 shared publication
Latest Publications
- 30 September 2025
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 42 (10) , 2306
Design of a highly sensitive Ag–TiO2-coated photonic crystal fiber-based refractive index sensor for anemia and diabetes detection
To detect anemia and diabetes type from in vitro samples, a simple structured solid-core photonic crystal fiber (PCF) refractive index biosensor based on surface plasmon resonance (SPR) was designed and investigated. Silver and TiO2 nanolayers were coated over the PCF for external sensing. The sensing characteristics of this sensor are analyzed using the finite element method (FEM). The proposed device detects analytes with refractive indices ranging from 1.28 to 1.38 with a maximum wavelength sensitivity of 34,000 nm/RIU. The amplitude sensitivity (AS) of the sensor reaches 1026RIU−1 with a resolution of 5.55×10−6RIU. Our design incorporates a miniature center air hole in the PCF to excite core-guided mode, and reduced air hole diameter along the vertical plane enhances the phase coherence between the plasmonic and the core-guided mode for y-polarized light for a narrow spectrum, ensuring higher FOM and hence greater sensitivity.
- 30 September 2025
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 42 (10) , 2306
Design of a highly sensitive Ag–TiO2-coated photonic crystal fiber-based refractive index sensor for anemia and diabetes detection
To detect anemia and diabetes type from in vitro samples, a simple structured solid-core photonic crystal fiber (PCF) refractive index biosensor based on surface plasmon resonance (SPR) was designed and investigated. Silver and TiO2 nanolayers were coated over the PCF for external sensing. The sensing characteristics of this sensor are analyzed using the finite element method (FEM). The proposed device detects analytes with refractive indices ranging from 1.28 to 1.38 with a maximum wavelength sensitivity of 34,000 nm/RIU. The amplitude sensitivity (AS) of the sensor reaches 1026RIU−1 with a resolution of 5.55×10−6RIU. Our design incorporates a miniature center air hole in the PCF to excite core-guided mode, and reduced air hole diameter along the vertical plane enhances the phase coherence between the plasmonic and the core-guided mode for y-polarized light for a narrow spectrum, ensuring higher FOM and hence greater sensitivity.
- Open Access
- 5 August 2025
- Published by Royal Society of Chemistry (RSC) in Nanoscale Advances
- Vol. 7 (18) , 5589-5600
Annealing-induced optimization of green-synthesized ZnO nanoparticles for improved nanopriming in sustainable agriculture
Being a very simple and cost-effective way to improve crop growth, nanopriming has been widely adopted as an efficient and advanced technology in agriculture. In recent years, there has been a drive to use green synthesized metal oxide nanoparticles (NPs) for nanopriming, which promotes an eco-friendly approach to material synthesis. Among various factors that influence the properties of NPs, annealing plays a critical role in altering their structural and functional characteristics. However, the role of annealing in optimizing green-synthesized NPs for effective nanopriming remains largely unexplored. Here, we present the first report on the effect of annealing on green-synthesized ZnO NPs for effective nanopriming. We analyze surface morphology, crystallinity, elemental composition, and colloidal stability by varying the annealing temperature of as-synthesized ZnO NPs. We show that colloidally stable smaller NPs (annealed at 400 °C) exhibit optimal performance in nanopriming. This finding is supported by practical data showing a significant improvement in germination percentage (up to 61.7%) and shoot length (up to 85.3%) of Momordica charantia seeds treated with 120 mg L−1 of ZnO NP annealed at 400 °C. This study not only provides information on the specialized synthesis of ZnO NPs but also paves the way for sustainable agricultural practices to increase food production.
- 5 August 2025
- Published by Royal Society of Chemistry (RSC) in Nanoscale Advances
- Vol. 7 (18) , 5589-5600
Open AccessAnnealing-induced optimization of green-synthesized ZnO nanoparticles for improved nanopriming in sustainable agriculture
Being a very simple and cost-effective way to improve crop growth, nanopriming has been widely adopted as an efficient and advanced technology in agriculture. In recent years, there has been a drive to use green synthesized metal oxide nanoparticles (NPs) for nanopriming, which promotes an eco-friendly approach to material synthesis. Among various factors that influence the properties of NPs, annealing plays a critical role in altering their structural and functional characteristics. However, the role of annealing in optimizing green-synthesized NPs for effective nanopriming remains largely unexplored. Here, we present the first report on the effect of annealing on green-synthesized ZnO NPs for effective nanopriming. We analyze surface morphology, crystallinity, elemental composition, and colloidal stability by varying the annealing temperature of as-synthesized ZnO NPs. We show that colloidally stable smaller NPs (annealed at 400 °C) exhibit optimal performance in nanopriming. This finding is supported by practical data showing a significant improvement in germination percentage (up to 61.7%) and shoot length (up to 85.3%) of Momordica charantia seeds treated with 120 mg L−1 of ZnO NP annealed at 400 °C. This study not only provides information on the specialized synthesis of ZnO NPs but also paves the way for sustainable agricultural practices to increase food production.