Francesca Santangeli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Francesca Santangeli has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Marta De Luca
Physics Department Sapienza University of Rome Rome Italy
3 shared publications - Andrea Macchia
YOCOCU APS—Youth in Conservation of Cultural Heritage, Via Tasso 108, 00185 Rome, Italy
2 shared publications - Anna Neri
Department of Biomedicine and Prevention, Tor Vergata University, Viale Montpellier 1, 00133 Rome, Italy
2 shared publications - Antonella Canini
Department of Biology, University of Rome “Tor Vergata”, Rome, Italy
2 shared publications - Camilla Zaratti
Sciences and Chemical Technologies Department, Tor Vergata University Rome, via della Ricerca Scientifica 1, 00133 Rome, Italy
2 shared publications - Dumitrita Filimon
Sciences and Chemical Technologies Department, Tor Vergata University, via della Ricerca Scientifica 1, 00133 Rome, Italy
2 shared publications
Latest Publications
- Open Access
Bandgap Engineering On Demand in GaAsN Nanowires by Post‐Growth Hydrogen Implantation
Bandgap engineering in semiconductors is required for the development of photonic and optoelectronic devices with optimized absorption and emission energies. This is usually achieved by changing the chemical or structural composition during growth or by dynamically applying strain. Here, the bandgap in GaAsN nanowires grown on Si is increased post‐growth by up to 460 meV in a reversible, tunable, and non‐destructive manner through H implantation. Such a bandgap tunability is unattained in epilayers and enabled by relaxed strain requirements in nanowire heterostructures, which enables N concentrations of up to 4.2% in core–shell GaAs/GaAsN/GaAs nanowires resulting in a GaAsN bandgap as low as 0.97 eV. Using ‐photoluminescence measurements on individual nanowires, it is shown that the high bandgap energy of GaAs at 1.42 eV is restored by hydrogenation through the formation of N–H complexes. By carefully optimizing the hydrogenation conditions, the photoluminescence efficiency increases by an order of magnitude. Moreover, by controlled thermal annealing, the large shift of the bandgap is not only made reversible but also continuously tuned by breaking up N–H complexes in the hydrogenated GaAsN. Finally, local bandgap tuning by laser annealing is demonstrated, opening up new possibilities for developing novel, locally and energy‐controlled quantum structures in GaAsN nanowires.
Open AccessBandgap Engineering On Demand in GaAsN Nanowires by Post‐Growth Hydrogen Implantation
Bandgap engineering in semiconductors is required for the development of photonic and optoelectronic devices with optimized absorption and emission energies. This is usually achieved by changing the chemical or structural composition during growth or by dynamically applying strain. Here, the bandgap in GaAsN nanowires grown on Si is increased post‐growth by up to 460 meV in a reversible, tunable, and non‐destructive manner through H implantation. Such a bandgap tunability is unattained in epilayers and enabled by relaxed strain requirements in nanowire heterostructures, which enables N concentrations of up to 4.2% in core–shell GaAs/GaAsN/GaAs nanowires resulting in a GaAsN bandgap as low as 0.97 eV. Using ‐photoluminescence measurements on individual nanowires, it is shown that the high bandgap energy of GaAs at 1.42 eV is restored by hydrogenation through the formation of N–H complexes. By carefully optimizing the hydrogenation conditions, the photoluminescence efficiency increases by an order of magnitude. Moreover, by controlled thermal annealing, the large shift of the bandgap is not only made reversible but also continuously tuned by breaking up N–H complexes in the hydrogenated GaAsN. Finally, local bandgap tuning by laser annealing is demonstrated, opening up new possibilities for developing novel, locally and energy‐controlled quantum structures in GaAsN nanowires.
- Open Access
TiO2 and CaCO3 Microparticles Produced in Aqueous Extracts from Satureja montana: Synthesis, Characterization, and Preliminary Antimicrobial Test
The possibility of modifying the surface chemistry of materials and synthetizing inorganic particles in natural aqueous extracts of plants (avoiding calcination), opens the doors to undoubtedly interesting scenarios for innovative functionalization strategies that are increasingly eco-sustainable and rich in interesting chemical–physical and biochemical properties. Among the aerial plants, Satureja montana exhibits interesting antibacterial, antifungal, antimicrobial, and antioxidant activities due to the rich volatile and non-volatile compounds (characterized by gas chromatography–mass spectrometry), contained in the aqueous extracts. For the first time, the latter was applied for the green synthesis of TiO2 and CaCO3 particles, characterized by X-ray diffraction, Raman, infrared spectroscopies, and scanning electron microscopy, coupled with microanalysis. Screening through antimicrobial assays under indoor passive sedimentation conditions showed opposite trends for two kinds of particles. TiO2 anatase spherical particles (400 < φ < 600 nm) increase microbial growth, proportionally to increasing particle concentration. Instead, S. montana-functionalized CaCO3 prismatic microparticles (1 µm × 1 µm × 1 µm) exhibit strong and dose-dependent antimicrobial activities, achieving near-complete inhibition at 50 mg/mL.
Open AccessTiO2 and CaCO3 Microparticles Produced in Aqueous Extracts from Satureja montana: Synthesis, Characterization, and Preliminary Antimicrobial Test
The possibility of modifying the surface chemistry of materials and synthetizing inorganic particles in natural aqueous extracts of plants (avoiding calcination), opens the doors to undoubtedly interesting scenarios for innovative functionalization strategies that are increasingly eco-sustainable and rich in interesting chemical–physical and biochemical properties. Among the aerial plants, Satureja montana exhibits interesting antibacterial, antifungal, antimicrobial, and antioxidant activities due to the rich volatile and non-volatile compounds (characterized by gas chromatography–mass spectrometry), contained in the aqueous extracts. For the first time, the latter was applied for the green synthesis of TiO2 and CaCO3 particles, characterized by X-ray diffraction, Raman, infrared spectroscopies, and scanning electron microscopy, coupled with microanalysis. Screening through antimicrobial assays under indoor passive sedimentation conditions showed opposite trends for two kinds of particles. TiO2 anatase spherical particles (400 < φ < 600 nm) increase microbial growth, proportionally to increasing particle concentration. Instead, S. montana-functionalized CaCO3 prismatic microparticles (1 µm × 1 µm × 1 µm) exhibit strong and dose-dependent antimicrobial activities, achieving near-complete inhibition at 50 mg/mL.
- Open Access
- 7 August 2025
- Published by MDPI AG in Preprints.org
TiO2 and CaCO3 Microparticles Produced in Aqueous Extracts from Satureja montana: Synthesis, Characterization and Preliminary Antimicrobial Test
The possibility of modifying the surface chemistry of materials, synthetizing inorganic particles in natural aqueous extracts of plants (at low temperature, avoiding calcination), opens the doors to undoubtedly very interesting scenarios for innovative functionalization strategies that are increasingly eco-sustainable and rich in interesting chemical-physical and biochemical properties. Among the aerial plant, Satureja montana exhibits interesting antibacterial, antifungal, antimicrobial and antioxidant activities due to the rich volatile and non-volatile compounds (as activators/phase controllers characterized by Gas Chromatography-Mass Spectrometry, GC-MS), contained in the aqueous extracts. For the first time, the aqueous extract of Satureja montana plant was applied for the green synthesis of TiO2 and CaCO3 particles, characterized by X-Ray diffraction (XRD), Raman, Infrared/IR spectroscopies, and Scanning Electron Microscopy-SEM/coupled by microanalysis EDX. Screening through antimicrobial assays under indoor passive sedimentation conditions showed opposite trends for both kind of inorganic particles. TiO₂ Anatase spherical particles (400<<600 nm) increase microbial growth, proportionally to increasing particles concentration (dose-dependent response). Probably, the low surface area (1.20 m2/g), low porosity (pore volume 0.0023 cm3/g; pore size of 560 nm) and smooth spherical morphology, don’t provoke chemical or physical damages to microorganisms, and therefore microbial growth is not inhibited. This occurs in the presence of medium/low concentrations of ROS (oxygenated radical species), which are chemically active in generating oxidative stress and cell death. In fact, the chemically reactive defects found in these TiO2/Anatase particles are predominantly carbonyl in nature, less reactive than carboxylic ones in producing ROS. Instead, S. montana-functionalized CaCO₃ prismatic microparticles (1µm x 1µm x 1µm) exhibit strong and dose-dependent antimicrobial activities, achieving near-complete inhibition at 50 mg mL⁻¹. This could be related to the molecular activators/phase controllers that induced defects, edges, dislocations and chemical active surface functionalities on the prismatic calcite particles, making them capable of inhibiting microbial activity. In particular, the presence of carboxyl groups C=(O)-OH, recorded by FTIR on the prismatic surfaces of CaCO3 MPs/SM particles, could be responsible for the production of ROS, the latter known to be dangerous sentinels of oxidative stress and cell death.
- 7 August 2025
- Published by MDPI AG in Preprints.org
Open AccessTiO2 and CaCO3 Microparticles Produced in Aqueous Extracts from Satureja montana: Synthesis, Characterization and Preliminary Antimicrobial Test
The possibility of modifying the surface chemistry of materials, synthetizing inorganic particles in natural aqueous extracts of plants (at low temperature, avoiding calcination), opens the doors to undoubtedly very interesting scenarios for innovative functionalization strategies that are increasingly eco-sustainable and rich in interesting chemical-physical and biochemical properties. Among the aerial plant, Satureja montana exhibits interesting antibacterial, antifungal, antimicrobial and antioxidant activities due to the rich volatile and non-volatile compounds (as activators/phase controllers characterized by Gas Chromatography-Mass Spectrometry, GC-MS), contained in the aqueous extracts. For the first time, the aqueous extract of Satureja montana plant was applied for the green synthesis of TiO2 and CaCO3 particles, characterized by X-Ray diffraction (XRD), Raman, Infrared/IR spectroscopies, and Scanning Electron Microscopy-SEM/coupled by microanalysis EDX. Screening through antimicrobial assays under indoor passive sedimentation conditions showed opposite trends for both kind of inorganic particles. TiO₂ Anatase spherical particles (400<<600 nm) increase microbial growth, proportionally to increasing particles concentration (dose-dependent response). Probably, the low surface area (1.20 m2/g), low porosity (pore volume 0.0023 cm3/g; pore size of 560 nm) and smooth spherical morphology, don’t provoke chemical or physical damages to microorganisms, and therefore microbial growth is not inhibited. This occurs in the presence of medium/low concentrations of ROS (oxygenated radical species), which are chemically active in generating oxidative stress and cell death. In fact, the chemically reactive defects found in these TiO2/Anatase particles are predominantly carbonyl in nature, less reactive than carboxylic ones in producing ROS. Instead, S. montana-functionalized CaCO₃ prismatic microparticles (1µm x 1µm x 1µm) exhibit strong and dose-dependent antimicrobial activities, achieving near-complete inhibition at 50 mg mL⁻¹. This could be related to the molecular activators/phase controllers that induced defects, edges, dislocations and chemical active surface functionalities on the prismatic calcite particles, making them capable of inhibiting microbial activity. In particular, the presence of carboxyl groups C=(O)-OH, recorded by FTIR on the prismatic surfaces of CaCO3 MPs/SM particles, could be responsible for the production of ROS, the latter known to be dangerous sentinels of oxidative stress and cell death.