Zijun Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zijun Zhou has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Yue Huang
Xiamen University
7 shared publications - Han Peng
School of Aerospace Engineering, Xiamen University, Xiamen 361005, China
6 shared publications Yancheng You
4 shared publications- Yancheng You
Xiamen University
3 shared publications - Jiangeng Ma2 shared publications
- Yechen Wang
School of Aerospace Engineering, Xiamen University , Xiamen 361102
2 shared publications
Latest Publications
- 22 September 2026
- Published by Elsevier in Combustion and Flame
- Vol. 294
Analysis of mode transition in liquid-fueled rotating detonation under varying inflow conditions
- 22 September 2026
- Published by Elsevier in Combustion and Flame
- Vol. 294
Analysis of mode transition in liquid-fueled rotating detonation under varying inflow conditions
- 22 September 2026
- Published by Elsevier in Combustion and Flame
- Vol. 294
Detonation evolution and cellular dynamics under symmetric and asymmetric wall heating
- 22 September 2026
- Published by Elsevier in Combustion and Flame
- Vol. 294
Detonation evolution and cellular dynamics under symmetric and asymmetric wall heating
- 1 July 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (7)
Heat release characteristics of rotating detonation in an afterburner under high-temperature low-oxygen inflow conditions
Rotating detonation afterburner (RDA) is a promising approach for thrust augmentation in turbofan engines, yet its heat release characteristics under high-temperature, low-oxygen inflow remain poorly understood. This study employs a two-dimensional Eulerian–Lagrangian method to simulate kerosene/air rotating detonation under typical afterburner inlet conditions (total temperature 795–1329 K and oxygen mass fraction 13.4%–18.9%). Under a baseline condition (1061 K and 16.4% O2), the RDA sustains stable single-wave propagation with a “lean-rich-lean” fuel vapor stratification driven by droplet evaporation lag. Decreasing oxygen content thickens the detonation wave front, reducing peak heat release rate while preserving total detonation heat release through wave broadening. Increasing total temperature triggers single-to-multi-wave transitions, sharply intensifying parasitic combustion and degrading evaporation at excessive temperatures due to reduced droplet residence time. Under coupled parameter variation within the present two-dimensional model, the velocity deficit exhibits a non-monotonic trend and reaches a minimum of 6.8% at 1061 K and 16.4% O2. Conventional threshold-based detonation/deflagration classification fails under these conditions, necessitating more refined identification approaches. These findings clarify the governing mechanisms of RDA heat release and support future afterburner design.
- 1 July 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (7)
Heat release characteristics of rotating detonation in an afterburner under high-temperature low-oxygen inflow conditions
Rotating detonation afterburner (RDA) is a promising approach for thrust augmentation in turbofan engines, yet its heat release characteristics under high-temperature, low-oxygen inflow remain poorly understood. This study employs a two-dimensional Eulerian–Lagrangian method to simulate kerosene/air rotating detonation under typical afterburner inlet conditions (total temperature 795–1329 K and oxygen mass fraction 13.4%–18.9%). Under a baseline condition (1061 K and 16.4% O2), the RDA sustains stable single-wave propagation with a “lean-rich-lean” fuel vapor stratification driven by droplet evaporation lag. Decreasing oxygen content thickens the detonation wave front, reducing peak heat release rate while preserving total detonation heat release through wave broadening. Increasing total temperature triggers single-to-multi-wave transitions, sharply intensifying parasitic combustion and degrading evaporation at excessive temperatures due to reduced droplet residence time. Under coupled parameter variation within the present two-dimensional model, the velocity deficit exhibits a non-monotonic trend and reaches a minimum of 6.8% at 1061 K and 16.4% O2. Conventional threshold-based detonation/deflagration classification fails under these conditions, necessitating more refined identification approaches. These findings clarify the governing mechanisms of RDA heat release and support future afterburner design.
- 1 July 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (7)
Evolution of secondary shock wave system in a hollow rotating detonation afterburner with two-dimensional nozzle
A three-dimensional numerical investigation was conducted to study the propagation characteristics and operational performance of a C2H4–air hollow rotating detonation afterburner (RDA) with a two-dimensional nozzle. Two sets of numerical cases were studied: the first examined the operational modes under different turbine inlet temperatures (1500, 1700, 1900 K) at a cruise condition (Mach 1.5, 10 km altitude), while the second evaluated the engine performance across a wide range of flight conditions (Mach 0.5–2.5). The results demonstrate the formation of a complex secondary shock wave system, originating from the reflection of detonation-induced oblique shock waves at the contoured walls of the circular-to-rectangular transition section. This secondary shock wave system, comprising reflected shock waves and doubled-reflected shock waves, propagates upstream, disrupts the fresh mixture injection layer, and induces pre-burning phenomena. This interaction significantly destabilizes the detonation wave, leading to unstable propagation, mode transitions, such as quenching and re-initiation (including the emergence of a counter-rotating detonation wave). Furthermore, the two-dimensional nozzle effectively reduces the flow non-uniformity at the exit. Both the detonation wave speed and peak pressure were found to increase with higher inlet pressure. The thrust coefficient increases with the flight Mach number, exceeding 0.8 under optimal conditions. This study provides insights into the combustion dynamics and performance of a hollow RDA with a two-dimensional nozzle, revealing the process of wave interaction in the circular-to-rectangular transition section.
- 1 July 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (7)
Evolution of secondary shock wave system in a hollow rotating detonation afterburner with two-dimensional nozzle
A three-dimensional numerical investigation was conducted to study the propagation characteristics and operational performance of a C2H4–air hollow rotating detonation afterburner (RDA) with a two-dimensional nozzle. Two sets of numerical cases were studied: the first examined the operational modes under different turbine inlet temperatures (1500, 1700, 1900 K) at a cruise condition (Mach 1.5, 10 km altitude), while the second evaluated the engine performance across a wide range of flight conditions (Mach 0.5–2.5). The results demonstrate the formation of a complex secondary shock wave system, originating from the reflection of detonation-induced oblique shock waves at the contoured walls of the circular-to-rectangular transition section. This secondary shock wave system, comprising reflected shock waves and doubled-reflected shock waves, propagates upstream, disrupts the fresh mixture injection layer, and induces pre-burning phenomena. This interaction significantly destabilizes the detonation wave, leading to unstable propagation, mode transitions, such as quenching and re-initiation (including the emergence of a counter-rotating detonation wave). Furthermore, the two-dimensional nozzle effectively reduces the flow non-uniformity at the exit. Both the detonation wave speed and peak pressure were found to increase with higher inlet pressure. The thrust coefficient increases with the flight Mach number, exceeding 0.8 under optimal conditions. This study provides insights into the combustion dynamics and performance of a hollow RDA with a two-dimensional nozzle, revealing the process of wave interaction in the circular-to-rectangular transition section.
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Effects of detonation wave direction and moment of inertia on the performance and flow structures of a disk rotating detonation combustor
This study presents a systematic investigation of turbine-coupled disk rotating detonation combustor (RDC) dynamics, establishing novel relationships between detonation wave direction, turbine inertia, and flow field characteristics. A two-dimensional simulation of stoichiometric hydrogen–air mixtures is performed using a six degrees of freedom solver. The results indicate that both the direction of the detonation wave and the turbine's moment of inertia significantly affect the reflection characteristics of the oblique shock wave (OSW) and the turbine's choking effect, thereby influencing the characteristics of the detonation. An increase in the angle between the OSW and the blade chord, coupled with a decrease in the moment of inertia, reduces the reflected shock wave intensity and the choking effect. Furthermore, the rotating detonation flow has the potential to directly drive the rotor, suggesting a possible reduction in engine mass. This research proposes three formation mechanisms for multiple detonation modes, as well as an attenuation mechanism for the number of rotating detonation waves, which is dominated by hot spots. Three types of coupling effects between the detonation wave and the reflected wave, along with a stable spiral shock wave system, have been identified, and the relationship between the spatial position of the shock wave and the physical dimensions of the combustor has been established. These findings offer new insights for optimizing the design of disk RDCs and their integration with downstream turbines.
- 1 August 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (8)
Effects of detonation wave direction and moment of inertia on the performance and flow structures of a disk rotating detonation combustor
This study presents a systematic investigation of turbine-coupled disk rotating detonation combustor (RDC) dynamics, establishing novel relationships between detonation wave direction, turbine inertia, and flow field characteristics. A two-dimensional simulation of stoichiometric hydrogen–air mixtures is performed using a six degrees of freedom solver. The results indicate that both the direction of the detonation wave and the turbine's moment of inertia significantly affect the reflection characteristics of the oblique shock wave (OSW) and the turbine's choking effect, thereby influencing the characteristics of the detonation. An increase in the angle between the OSW and the blade chord, coupled with a decrease in the moment of inertia, reduces the reflected shock wave intensity and the choking effect. Furthermore, the rotating detonation flow has the potential to directly drive the rotor, suggesting a possible reduction in engine mass. This research proposes three formation mechanisms for multiple detonation modes, as well as an attenuation mechanism for the number of rotating detonation waves, which is dominated by hot spots. Three types of coupling effects between the detonation wave and the reflected wave, along with a stable spiral shock wave system, have been identified, and the relationship between the spatial position of the shock wave and the physical dimensions of the combustor has been established. These findings offer new insights for optimizing the design of disk RDCs and their integration with downstream turbines.