Ta-Chung Liu
Research Subjects
Research Interests
Ta-Chung Liu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Hsin-Chiao Wu
Department of Biomedical Engineering
2 shared publicationsChia-Chen Lin
Department of Biomedical Engineering
1 shared publicationChu-Hsin Yang
Department of Biomedical Engineering
1 shared publicationDai-Jin Li
Department of Biomedical Engineering, National Yang Ming Chiao Tung University, 155 Lin-Ong St., Taipei, Taiwan 11221, ROC
1 shared publicationHuai-Hsaun Shao
Department of Biomedical Engineering, National Yang Ming Chiao Tung University, 155 Lin-Ong St., Taipei, Taiwan 11221, ROC
1 shared publicationPei-Chen Lo
Department of Biomedical Engineering, National Yang Ming Chiao Tung University, 155 Lin-Ong St., Taipei, Taiwan 11221, ROC
1 shared publication
Latest Publications
- Open Access
- 2 October 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (41) , 56991-57001
Enhanced Zn/ZnO Heterointerfaces via Pulsed-Potential Electrochemical Reconstruction for Highly Selective CO2 Reduction
The electrochemical carbon dioxide reduction reaction (CO2RR) demands advanced low-cost cathodes that can overcome the intrinsic scaling limits of single-phase metals. Accordingly, we report a pulsed-potential-based square wave voltammetry (SWV) strategy to reconstruct ZnO nanoparticles into metallic Zn nanoislands embedded on the ZnO wurtzite surface, generating an enhanced density of Zn/ZnO heterointerfaces. TEM/FFT and XPS analyses confirmed more finely discrete metallic Zn domains with a balanced Zn(0)/Zn(II) ratio for the SWV-ZnO electrocatalyst. At these heterojunctions, they preferentially stabilized the *COOH intermediate and weakened *H adsorption, thereby suppressing the competing hydrogen evolution reaction. The SWV-ZnO delivered a peak CO Faradaic efficiency of 90% with a CO partial current density of 5.3 mA/cm2 at -1.05 V versus RHE in the H-cell, outperforming the pristine zinc nanoparticles and the previously reported potentiostatic reconstruction strategies (CA-ZnO). This work demonstrated that pulsed-potential electrochemical reconstruction offered a rapid and scalable route to engineer heterointerfaces, providing a practical blueprint for advancing sustainable CO2-to-CO conversion technologies.
- 2 October 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (41) , 56991-57001
Open AccessEnhanced Zn/ZnO Heterointerfaces via Pulsed-Potential Electrochemical Reconstruction for Highly Selective CO2 Reduction
The electrochemical carbon dioxide reduction reaction (CO2RR) demands advanced low-cost cathodes that can overcome the intrinsic scaling limits of single-phase metals. Accordingly, we report a pulsed-potential-based square wave voltammetry (SWV) strategy to reconstruct ZnO nanoparticles into metallic Zn nanoislands embedded on the ZnO wurtzite surface, generating an enhanced density of Zn/ZnO heterointerfaces. TEM/FFT and XPS analyses confirmed more finely discrete metallic Zn domains with a balanced Zn(0)/Zn(II) ratio for the SWV-ZnO electrocatalyst. At these heterojunctions, they preferentially stabilized the *COOH intermediate and weakened *H adsorption, thereby suppressing the competing hydrogen evolution reaction. The SWV-ZnO delivered a peak CO Faradaic efficiency of 90% with a CO partial current density of 5.3 mA/cm2 at -1.05 V versus RHE in the H-cell, outperforming the pristine zinc nanoparticles and the previously reported potentiostatic reconstruction strategies (CA-ZnO). This work demonstrated that pulsed-potential electrochemical reconstruction offered a rapid and scalable route to engineer heterointerfaces, providing a practical blueprint for advancing sustainable CO2-to-CO conversion technologies.
- Open Access
- 8 September 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (37) , 52064-52076
Ultrathin Hybridized ZnOHF Nanowires with Enriched Oxygen Vacancies for High Selective CO2-to-CO Electrocatalytic Conversion
Electrochemical CO2 reduction reaction (CO2RR) has emerged as a key negative-emission technology, yet its industrial adoption hinges on cathode catalysts that deliver high selectivity and production rates at low cost. Herein, we reported a facile hydrothermal route to synthesize different scales of ZnOHF ultrathin nanowires with hybridized ZnO/ZnOHF heterointerfaces, where the 40 nm variant (NW40-ZnOHF) showed a high FE of 93 % and a jCO of -17.2 mA/cm2 at -1.0 V vs RHE. The excellent intrinsic electrocatalytic properties of NW40-ZnOHF were verified, presumably owing to its high-level surface concentration of oxygen vacancies preexisted in the pristine structure and formed during CO2RR. This work highlights the significance of the synergistic effect of heterointerface and fluorine incorporation engineering for guiding the optimized design of low-cost electrocatalysts for CO2RR technology.
- 8 September 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (37) , 52064-52076
Open AccessUltrathin Hybridized ZnOHF Nanowires with Enriched Oxygen Vacancies for High Selective CO2-to-CO Electrocatalytic Conversion
Electrochemical CO2 reduction reaction (CO2RR) has emerged as a key negative-emission technology, yet its industrial adoption hinges on cathode catalysts that deliver high selectivity and production rates at low cost. Herein, we reported a facile hydrothermal route to synthesize different scales of ZnOHF ultrathin nanowires with hybridized ZnO/ZnOHF heterointerfaces, where the 40 nm variant (NW40-ZnOHF) showed a high FE of 93 % and a jCO of -17.2 mA/cm2 at -1.0 V vs RHE. The excellent intrinsic electrocatalytic properties of NW40-ZnOHF were verified, presumably owing to its high-level surface concentration of oxygen vacancies preexisted in the pristine structure and formed during CO2RR. This work highlights the significance of the synergistic effect of heterointerface and fluorine incorporation engineering for guiding the optimized design of low-cost electrocatalysts for CO2RR technology.
- Open Access
- 5 December 2024
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 9 (12) , 6520-6530
Tuning the Localized Microenvironment near a Continuous Glucose Meter to Ensure Monitoring Accuracy and Longevity by Plasma-Induced Grafting Zwitterionic Brushes
Diabetes mellitus is a metabolic disorder that affects millions of individuals worldwide. Continuous glucose monitoring (CGM) offers a prevalent method for continuously monitoring interstitial glucose levels instead of traditional self-monitoring of blood glucose (BG), eliminating the need for finger pricking and providing only discrete data. However, challenges in accuracy persist in CGM, including substantial noise interference and tissue fluid erosion, as well as the pH fluctuations in the localized ISF microenvironment during acute inflammation periods. Herein, we reported a facile atmospheric plasma-induced grafting technique to surface functionalize a zwitterionic brush coating on the sensor, with the aim to adjust the sensor's microenvironmental chemistry. The zwitterionic brush-coated CGM (Z-coated CGM) could regulate pH values with a good glucose response in the pH range from 6.2 to 7.6 and a prolonged sensor life over the uncoated sensor. We evaluated the rat practice that the Z-coated CGM consistently outperformed the uncoated in tracking BG fluctuations, with higher correlation coefficients and significant noise reduction for both non-recalibration and recalibration. This technology holds substantial implications for subcutaneous embedded glucose monitors and facilitates CGMs in achieving independence from routine BG fingerstick calibrations.
- 5 December 2024
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 9 (12) , 6520-6530
Open AccessTuning the Localized Microenvironment near a Continuous Glucose Meter to Ensure Monitoring Accuracy and Longevity by Plasma-Induced Grafting Zwitterionic Brushes
Diabetes mellitus is a metabolic disorder that affects millions of individuals worldwide. Continuous glucose monitoring (CGM) offers a prevalent method for continuously monitoring interstitial glucose levels instead of traditional self-monitoring of blood glucose (BG), eliminating the need for finger pricking and providing only discrete data. However, challenges in accuracy persist in CGM, including substantial noise interference and tissue fluid erosion, as well as the pH fluctuations in the localized ISF microenvironment during acute inflammation periods. Herein, we reported a facile atmospheric plasma-induced grafting technique to surface functionalize a zwitterionic brush coating on the sensor, with the aim to adjust the sensor's microenvironmental chemistry. The zwitterionic brush-coated CGM (Z-coated CGM) could regulate pH values with a good glucose response in the pH range from 6.2 to 7.6 and a prolonged sensor life over the uncoated sensor. We evaluated the rat practice that the Z-coated CGM consistently outperformed the uncoated in tracking BG fluctuations, with higher correlation coefficients and significant noise reduction for both non-recalibration and recalibration. This technology holds substantial implications for subcutaneous embedded glucose monitors and facilitates CGMs in achieving independence from routine BG fingerstick calibrations.