Yuma Sato
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Yuma Sato has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Eun-Ae Choi
Extreme Materials Research Institute, Korea Institute of Materials Science (KIMS), Changwon 51508, Republic of Korea
2 shared publications - Hirokazu Kadobayashi
Japan Synchrotron Radiation Research Institute (JASRI), Sayo, Hyogo 679-5198, Japan
2 shared publications - Saori Imada Kawaguchi
Japan Synchrotron Radiation Research Institute (JASRI), Sayo, Hyogo 679-5198, Japan
2 shared publications - Seung Zeon Han
Extreme Materials Research Institute Korea Institute of Materials Science (KIMS) Changwon 51508 Korea
2 shared publications - Yasutomo Arai
Japan Aerospace Exploration Agency 6 , Tsukuba, Ibaraki 305-8505
2 shared publications - Yoshifumi Ikoma
Department of Materials Science and Engineering, Kyushu University
2 shared publications
Latest Publications
- 18 August 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (7)
High-pressure phase transformation and metastable phases of a Si0.29Ge0.71 alloy using a diamond anvil cell
We investigated the high-pressure phase transformation of a Si0.29Ge0.71 alloy grown by a traveling liquidus-zone (TLZ) method. The TLZ-grown Si0.29Ge0.71 alloy was subjected to high pressures of up to ∼15 GPa using a diamond anvil cell. In situ synchrotron X-ray diffraction (XRD) and micro-Raman measurements revealed the appearance of a tetragonal β-Sn phase at 12.1 GPa. A weakened residual diamond-cubic (dc) diffraction peak together with dominant β-Sn peaks was present at 15.2 GPa. Upon depressurization, a metastable rhombohedral r8 phase appeared at 8.4 GPa. When depressurized to ambient pressure, the XRD profile showed an almost body-centered-cubic bc8 phase with residual weak r8 and dc diffraction peaks. No appreciable Raman peaks were observed upon depressurization down to 4.1 GPa, but weak peaks appeared at ∼283 and ∼396 cm−1 at ambient pressure. Theoretical calculations based on density functional perturbation theory indicated that the observed peaks were not related to bc8 but rather to hexagonal diamond (hd). These results indicate that a bc8 → hd phase transformation was induced by laser heating during the Raman measurement.
- 18 August 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 127 (7)
High-pressure phase transformation and metastable phases of a Si0.29Ge0.71 alloy using a diamond anvil cell
We investigated the high-pressure phase transformation of a Si0.29Ge0.71 alloy grown by a traveling liquidus-zone (TLZ) method. The TLZ-grown Si0.29Ge0.71 alloy was subjected to high pressures of up to ∼15 GPa using a diamond anvil cell. In situ synchrotron X-ray diffraction (XRD) and micro-Raman measurements revealed the appearance of a tetragonal β-Sn phase at 12.1 GPa. A weakened residual diamond-cubic (dc) diffraction peak together with dominant β-Sn peaks was present at 15.2 GPa. Upon depressurization, a metastable rhombohedral r8 phase appeared at 8.4 GPa. When depressurized to ambient pressure, the XRD profile showed an almost body-centered-cubic bc8 phase with residual weak r8 and dc diffraction peaks. No appreciable Raman peaks were observed upon depressurization down to 4.1 GPa, but weak peaks appeared at ∼283 and ∼396 cm−1 at ambient pressure. Theoretical calculations based on density functional perturbation theory indicated that the observed peaks were not related to bc8 but rather to hexagonal diamond (hd). These results indicate that a bc8 → hd phase transformation was induced by laser heating during the Raman measurement.