Ford M. Wagner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ford M. Wagner has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Michael B. Johnston
Department of Physics, University of Oxford, Clarendon Laboratory, Parks Road, Oxford, OX1 3PU, UK
2 shared publications - Chawit Uswachoke
Electrical Engineering Division, Department of Engineering, University of Cambridge 3 , Cambridge CB3 0FA
1 shared publication - Chennupati Jagadish
The Australian National University
1 shared publication Djamshid A. Damry
Department of Physics, Clarendon Laboratory, University of Oxford 1 , Parks Road, Oxford OX1 3PU
1 shared publication- Edoardo Galli
The MacDiarmid Institute for Advanced Materials and Nanotechnology, School of Physical and Chemical Sciences, University of Canterbury, Christchurch, 8140, New Zealand
1 shared publication - Hannah J. Joyce
University of Cambridge
1 shared publication
Latest Publications
- Open Access
- 28 September 2025
- Published by Wiley in Advanced Optical Materials
- Vol. 13 (30)
Control Over the Microstructure of Vapor‐Deposited CsPbBr 3 Enhances Amplified Spontaneous Emission
Inorganic cesium‐based metal halide perovskite (MHP) semiconductors have great potential as active layers in optoelectronic devices, such as perovskite light‐emitting diodes (PeLEDs) and perovskite lasers. However, precise control of crystal type, quality, and thickness is required to create high‐performance and reproducible devices. Vapor‐phase vacuum deposition enables fabrication of MHP thin films and devices with excellent uniformity and control over layer thickness, although a full understanding of crystal growth mechanisms and products has proved elusive. Here, conditions of vapor co‐deposition of CsBr and PbBr are related with the optical performance and atomic microstructure of resulting CsPbBr 3 thin films. It is found that the structure is predominantly photoactive γ‐CsPbBr 3 over a wide range of conditions, but the presence of impurity phases and Ruddlesden–Popper (RP) planar defects both degrade optical performance as quantified through measured amplified spontaneous emission (ASE) thresholds. Furthermore, the atomic structure of the dominant impurity phases is resolved: CsPb 2 Br 5 and Cs 4 PbBr 6 . It is revealed that a small nominal excess of CsBr‐precursor flux during co‐evaporation can significantly enhance the nucleation of thin films, resulting in well‐defined grains greater than 500 nm in size and the relative suppression of RP planar defects. Such films exhibit intensified photoluminescence (PL) emission and a reduced ASE threshold of 30.9 µJ cm −2 .
- 28 September 2025
- Published by Wiley in Advanced Optical Materials
- Vol. 13 (30)
Open AccessControl Over the Microstructure of Vapor‐Deposited CsPbBr 3 Enhances Amplified Spontaneous Emission
Inorganic cesium‐based metal halide perovskite (MHP) semiconductors have great potential as active layers in optoelectronic devices, such as perovskite light‐emitting diodes (PeLEDs) and perovskite lasers. However, precise control of crystal type, quality, and thickness is required to create high‐performance and reproducible devices. Vapor‐phase vacuum deposition enables fabrication of MHP thin films and devices with excellent uniformity and control over layer thickness, although a full understanding of crystal growth mechanisms and products has proved elusive. Here, conditions of vapor co‐deposition of CsBr and PbBr are related with the optical performance and atomic microstructure of resulting CsPbBr 3 thin films. It is found that the structure is predominantly photoactive γ‐CsPbBr 3 over a wide range of conditions, but the presence of impurity phases and Ruddlesden–Popper (RP) planar defects both degrade optical performance as quantified through measured amplified spontaneous emission (ASE) thresholds. Furthermore, the atomic structure of the dominant impurity phases is resolved: CsPb 2 Br 5 and Cs 4 PbBr 6 . It is revealed that a small nominal excess of CsBr‐precursor flux during co‐evaporation can significantly enhance the nucleation of thin films, resulting in well‐defined grains greater than 500 nm in size and the relative suppression of RP planar defects. Such films exhibit intensified photoluminescence (PL) emission and a reduced ASE threshold of 30.9 µJ cm −2 .
- Open Access
- 27 August 2025
- Published by Elsevier in Neural Networks
- Vol. 193, 108031
Complexity of brain-like signals in self-organised nanoscale networks
- 27 August 2025
- Published by Elsevier in Neural Networks
- Vol. 193, 108031
Open AccessComplexity of brain-like signals in self-organised nanoscale networks
- Open Access
- 1 July 2025
- Published by AIP Publishing in APL Photonics
- Vol. 10 (7)
The influence of subwavelength geometry on extracting the electrical properties of semiconductors by terahertz spectroscopy
Terahertz (THz) spectroscopy is a non-contact technique well-suited for probing the ultrafast electrical conductivity of semiconductor nanostructures, where conventional methods are often impractical. However, geometric resonances in these nanostructures can distort the measured THz response, complicating the extraction of the intrinsic material properties. Here, we use THz spectroscopy to study GaAs nanowires of varying lengths and observe that the resonant frequency increases as the nanowire length decreases. Further measurements on a model system of well-defined GaAs microsquares (ranging in size from 500 × 500 to 7 × 7 μm2) confirmed the relationship between structure size and resonant frequency. We verify that a plasmon-based model successfully separates the geometric response from the intrinsic charge-carrier response. Thus, the model allows for the accurate evaluation of critical material properties in nanostructured semiconductors, such as electron mobility. Fluence-dependent measurements and finite-difference time-domain simulations confirm the plasmonic nature of the resonances.
- 1 July 2025
- Published by AIP Publishing in APL Photonics
- Vol. 10 (7)
Open AccessThe influence of subwavelength geometry on extracting the electrical properties of semiconductors by terahertz spectroscopy
Terahertz (THz) spectroscopy is a non-contact technique well-suited for probing the ultrafast electrical conductivity of semiconductor nanostructures, where conventional methods are often impractical. However, geometric resonances in these nanostructures can distort the measured THz response, complicating the extraction of the intrinsic material properties. Here, we use THz spectroscopy to study GaAs nanowires of varying lengths and observe that the resonant frequency increases as the nanowire length decreases. Further measurements on a model system of well-defined GaAs microsquares (ranging in size from 500 × 500 to 7 × 7 μm2) confirmed the relationship between structure size and resonant frequency. We verify that a plasmon-based model successfully separates the geometric response from the intrinsic charge-carrier response. Thus, the model allows for the accurate evaluation of critical material properties in nanostructured semiconductors, such as electron mobility. Fluence-dependent measurements and finite-difference time-domain simulations confirm the plasmonic nature of the resonances.