Nelli Abrahamyan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nelli Abrahamyan has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Arevik Vardanyan
Department of Microbiology, SPC “Armbiotechnology” of the National Academy of Sciences of Armenia, 14 Gyurjyan Str., Yerevan 0056, Armenia
3 shared publications - Narine Vardanyan
Department of Microbiology, SPC “Armbiotechnology” of the National Academy of Sciences of Armenia, 14 Gyurjyan Str., Yerevan 0056, Armenia
2 shared publications - Sona Barseghyan
Institute of Microbiology, SPC “Armbiotechnology” NAS of Armenia, Yerevan 0056, Armenia
2 shared publications - Zaruhi Melkonyan
Institute of Microbiology, SPC “Armbiotechnology” NAS of Armenia, Yerevan 0056, Armenia
2 shared publications - Anna Khachatryan
Department of Microbiology, SPC “Armbiotechnology” of the National Academy of Sciences of Armenia, 14 Gyurjyan Str., Yerevan 0056, Armenia
1 shared publication - Jesus Angel Muñoz
Departamento de Ciencia de Materiales, Facultad de Química, Universidad Complutense, 28040 Madrid, Spain
1 shared publication
Latest Publications
- Open Access
Biosorption of Cu2+ and Zn2+ by Rhodotorula sp. Kt, a Yeast Isolated from Acid Mine Drainage
Acid mine drainages (AMDs) enriched with toxic metals pose a significant environmental risk. Microbial bioremediation offers a sustainable and cost-effective approach for metal removal from AMD. In this study, a wild yeast isolated from the Kavart abandoned mine, identified as Rhodotorula sp., was evaluated for its copper (Cu2+) and zinc (Zn2+) biosorption ability. Biosorption was strongly pH-dependent. Cu2+ and Zn2+ removal was most efficient (48.1% or 10.07 mg/g and 35.7% or 6.07 mg/g, respectively) at pH 6. Increasing the biomass to 3 g/L at the same pH enhanced Cu2+ removal to 71.5% (26 mg/g). Biosorption kinetic analysis showed an excellent fit to the pseudo-second-order model (R2 > 0.99), indicating that the mechanism is chemisorption-dominated. Equilibrium data followed the Langmuir isotherm (R2 = 0.93), consistent with monolayer adsorption on homogeneous binding sites. SEM-EDS analysis confirmed Cu2+ association with the yeast surface, supporting the ICP-OES results. The results demonstrate the isolate as a promising biosorbent, particularly for Cu2+, and highlight its potential application in the remediation of AMD-contaminated waters.
Open AccessBiosorption of Cu2+ and Zn2+ by Rhodotorula sp. Kt, a Yeast Isolated from Acid Mine Drainage
Acid mine drainages (AMDs) enriched with toxic metals pose a significant environmental risk. Microbial bioremediation offers a sustainable and cost-effective approach for metal removal from AMD. In this study, a wild yeast isolated from the Kavart abandoned mine, identified as Rhodotorula sp., was evaluated for its copper (Cu2+) and zinc (Zn2+) biosorption ability. Biosorption was strongly pH-dependent. Cu2+ and Zn2+ removal was most efficient (48.1% or 10.07 mg/g and 35.7% or 6.07 mg/g, respectively) at pH 6. Increasing the biomass to 3 g/L at the same pH enhanced Cu2+ removal to 71.5% (26 mg/g). Biosorption kinetic analysis showed an excellent fit to the pseudo-second-order model (R2 > 0.99), indicating that the mechanism is chemisorption-dominated. Equilibrium data followed the Langmuir isotherm (R2 = 0.93), consistent with monolayer adsorption on homogeneous binding sites. SEM-EDS analysis confirmed Cu2+ association with the yeast surface, supporting the ICP-OES results. The results demonstrate the isolate as a promising biosorbent, particularly for Cu2+, and highlight its potential application in the remediation of AMD-contaminated waters.
- Open Access
Bacterial Tolerance and Bioleaching in the Presence of Chloride
Chloride ions can enhance the bioleaching of copper minerals, yet most biomining microorganisms are highly sensitive to chloride and cannot survive or colonize mineral surfaces in saline environments. Chloride tolerance varies among acidophilic iron-oxidizing bacteria, but the concentrations at which they remain active are generally too low to permit the industrial use of seawater. Therefore, identifying highly chloride-tolerant leaching microorganisms and studying their bioleaching potential in chloride-containing systems is of utmost importance. This study investigated chloride tolerance and adaptability of bacteria from different genera, with a focus on Sulfobacillus thermosulfidooxidans subsp. asporogenes 41, a moderately thermophilic strain that can oxidize both Fe (II) and reduced inorganic sulfur compounds (RISCs). This dual activity makes it advantageous for bioleaching by facilitating sulfur removal, generating acidity, and preventing mineral passivation. Comparative experiments on the bioleaching of pyrite and chalcopyrite demonstrated that adaptation to 0.3 M NaCl enhanced the chloride tolerance of S. thermosulfidooxidans subsp. asporogenes 41. The adapted strain exhibited significantly improved copper extraction under saline conditions compared with the native culture. Maximum copper recovery was achieved at 0.4 M NaCl, highlighting the potential of chloride-adapted moderate thermophiles for biomining applications in saline environments. In contrast the minimal inhibitory concentration for Acidithiobacillud ferrooxidans Dr was 0.005 M (causing 41.2% inhibition), while Leptospirillum ferriphilum CC was unaffected by lower concentrations (0.01–0.02 M) and only showed severe inhibition (86.5%) at 0.1 M NaCl, defining its minimal inhibitory concentration (MIC) at 0.05 M.
Open AccessBacterial Tolerance and Bioleaching in the Presence of Chloride
Chloride ions can enhance the bioleaching of copper minerals, yet most biomining microorganisms are highly sensitive to chloride and cannot survive or colonize mineral surfaces in saline environments. Chloride tolerance varies among acidophilic iron-oxidizing bacteria, but the concentrations at which they remain active are generally too low to permit the industrial use of seawater. Therefore, identifying highly chloride-tolerant leaching microorganisms and studying their bioleaching potential in chloride-containing systems is of utmost importance. This study investigated chloride tolerance and adaptability of bacteria from different genera, with a focus on Sulfobacillus thermosulfidooxidans subsp. asporogenes 41, a moderately thermophilic strain that can oxidize both Fe (II) and reduced inorganic sulfur compounds (RISCs). This dual activity makes it advantageous for bioleaching by facilitating sulfur removal, generating acidity, and preventing mineral passivation. Comparative experiments on the bioleaching of pyrite and chalcopyrite demonstrated that adaptation to 0.3 M NaCl enhanced the chloride tolerance of S. thermosulfidooxidans subsp. asporogenes 41. The adapted strain exhibited significantly improved copper extraction under saline conditions compared with the native culture. Maximum copper recovery was achieved at 0.4 M NaCl, highlighting the potential of chloride-adapted moderate thermophiles for biomining applications in saline environments. In contrast the minimal inhibitory concentration for Acidithiobacillud ferrooxidans Dr was 0.005 M (causing 41.2% inhibition), while Leptospirillum ferriphilum CC was unaffected by lower concentrations (0.01–0.02 M) and only showed severe inhibition (86.5%) at 0.1 M NaCl, defining its minimal inhibitory concentration (MIC) at 0.05 M.
- 30 September 2022
- Published by Taylor & Francis in International Journal of Environmental Studies
- Vol. 81 (4) , 1756-1771
Sequential biologically assisted extraction of Cu and Zn from printed circuit boards (PCB)
The increased production and use of electrical and electronic equipment leads to obsolescence and disposal problems, necessitating materials recovery and recycling. This paper reports results on metal bioleaching from printed circuit boards (PCBs) using chemolithotrophic bacteria isolated at different sulphide ore biotopes in Armenia. Different ways of generating lixiviants were investigated, namely using combination of Acidithiobacillus ferrooxidans 61 and Acidithiobacillus thiooxidans SO-1 bacteria generating biogenic Fe2(SO4)3 and biogenic H2SO4. The sequence between these leaching agents permitted design of a 2-step process based on acidolysis and redoxolysis to leach non-ferrous metals from PCBs. To compare the efficiency of the sequential bioleaching of PCBs, several experimental runs were realised under the six modes at 10% pulp density. The flasks-based tests have witnessed almost complete recovery of Cu with the rest of the metals reaching extraction degree above 80%.
- 30 September 2022
- Published by Taylor & Francis in International Journal of Environmental Studies
- Vol. 81 (4) , 1756-1771
Sequential biologically assisted extraction of Cu and Zn from printed circuit boards (PCB)
The increased production and use of electrical and electronic equipment leads to obsolescence and disposal problems, necessitating materials recovery and recycling. This paper reports results on metal bioleaching from printed circuit boards (PCBs) using chemolithotrophic bacteria isolated at different sulphide ore biotopes in Armenia. Different ways of generating lixiviants were investigated, namely using combination of Acidithiobacillus ferrooxidans 61 and Acidithiobacillus thiooxidans SO-1 bacteria generating biogenic Fe2(SO4)3 and biogenic H2SO4. The sequence between these leaching agents permitted design of a 2-step process based on acidolysis and redoxolysis to leach non-ferrous metals from PCBs. To compare the efficiency of the sequential bioleaching of PCBs, several experimental runs were realised under the six modes at 10% pulp density. The flasks-based tests have witnessed almost complete recovery of Cu with the rest of the metals reaching extraction degree above 80%.