Di Ning
Di Ning has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Haigang Wang
National Field Observation and Research Station (Hebei Cangzhou) for Groundwater and Land Subsidence, Cangzhou 061000, China
2 shared publications - Chaofan Zhou
Key Laboratory of the Ministry of Education Land Subsidence Mechanism and Prevention, Capital Normal University, Beijing 100048, China
1 shared publication - Haipeng Guo
Hebei Cangzhou Groundwater and Land Subsidence National Observation and Research Station
1 shared publication - Huili Gong
College of Resources Environment and Tourism, Capital Normal University, Beijing 100048, China
1 shared publication - Jianping He
School of Civil Engineering, Nantong Institute of Technology, Nantong 226000, China
1 shared publication - Jincai Zhang
Hebei Geo-Environment Monitoring, Shijiazhuang 050021, China
1 shared publication
Latest Publications
- Open Access
- 23 September 2026
- Published by MDPI AG in Micromachines
- Vol. 17 (10) , 1112
Development and Engineering Application of a Vertically Installed FBG Sensor for Subgrade Strain Monitoring
Subgrade deformation under load is accumulated from the local compressive strain of each layer. Solely relying on the overall settlement monitoring at the top surface makes it difficult to reveal the internal strain distribution and the evolutionary characteristics of early damage. Therefore, acquiring the local compressive strain field along the depth direction is of great engineering significance for subgrade condition assessment and safety early warning. In this paper, a vertically installed FBG sensor (VI-FBG) with GFRP packaging suitable for layered strain measurement of subgrade is developed. The effectiveness of the sensor is verified by direct compression tests and compressive strain tests with the sensor embedded in concrete. Furthermore, the sensor was buried in the subgrade of a high-speed railway to carry out strain monitoring. The test results show that the sensor has favorable sensing performance, with a strain sensitivity of 1.2 pm/με and a temperature sensitivity of 16.84 pm/°C. The measured compressive strain of concrete is in good agreement with the theoretical value, and the relative error is less than 8%. The field monitoring data can truly reflect the vertical compressive strain during subgrade filling. The measured time-history curve exhibits good consistency with the displacement time-history curve obtained by the adjacent FBG settlement sensor. This study verifies that the sensor is applicable to the monitoring of local vertical compressive deformation of subgrade, and its GFRP encapsulation endows it with good engineering applicability.
- 23 September 2026
- Published by MDPI AG in Micromachines
- Vol. 17 (10) , 1112
Open AccessDevelopment and Engineering Application of a Vertically Installed FBG Sensor for Subgrade Strain Monitoring
Subgrade deformation under load is accumulated from the local compressive strain of each layer. Solely relying on the overall settlement monitoring at the top surface makes it difficult to reveal the internal strain distribution and the evolutionary characteristics of early damage. Therefore, acquiring the local compressive strain field along the depth direction is of great engineering significance for subgrade condition assessment and safety early warning. In this paper, a vertically installed FBG sensor (VI-FBG) with GFRP packaging suitable for layered strain measurement of subgrade is developed. The effectiveness of the sensor is verified by direct compression tests and compressive strain tests with the sensor embedded in concrete. Furthermore, the sensor was buried in the subgrade of a high-speed railway to carry out strain monitoring. The test results show that the sensor has favorable sensing performance, with a strain sensitivity of 1.2 pm/με and a temperature sensitivity of 16.84 pm/°C. The measured compressive strain of concrete is in good agreement with the theoretical value, and the relative error is less than 8%. The field monitoring data can truly reflect the vertical compressive strain during subgrade filling. The measured time-history curve exhibits good consistency with the displacement time-history curve obtained by the adjacent FBG settlement sensor. This study verifies that the sensor is applicable to the monitoring of local vertical compressive deformation of subgrade, and its GFRP encapsulation endows it with good engineering applicability.
- Open Access
- 4 December 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (12) , 1380
Layered Monitoring of Ground Subsidence Based on Ultra-Weak FBG Sensing Technology: A Case Study in Gaoyang County, China
The primary objective of layered settlement monitoring of deep soil is to obtain settlement data for both the soil and superstructure, enabling appropriate measures to be taken to ensure the structure’s safety and stability. Traditional deep soil monitoring technologies are either limited in the number of measurement points (e.g., fiber Bragg grating sensing technology) or exhibit low measurement accuracy (e.g., distributed fiber optic sensing technology). This study proposes a layered settlement monitoring technique for deep soil based on the ultra-weak fiber Bragg grating sensors. First, ultra-weak fiber Bragg grating strain sensors packaged by fiber-reinforced polymer (FRP) were developed, and experimental research on the sensors’ sensing and directional recognition characteristics was conducted. Subsequently, the sensors were deployed for ground subsidence monitoring in Gaoyang County, China, with investigations conducted on sensor installation techniques and long-term measurement data. Experimental and engineering test results demonstrate that the strain and temperature sensing coefficients of the sensors are 1.22 pm/με and 17.06 pm/°C, respectively. Sensors incorporating dual ultra-weak fiber Bragg grating arrays can simultaneously detect both vertical and lateral soil displacement. Long-term monitoring data effectively reflects subsidence changes in the Gaoyang region.
- 4 December 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (12) , 1380
Open AccessLayered Monitoring of Ground Subsidence Based on Ultra-Weak FBG Sensing Technology: A Case Study in Gaoyang County, China
The primary objective of layered settlement monitoring of deep soil is to obtain settlement data for both the soil and superstructure, enabling appropriate measures to be taken to ensure the structure’s safety and stability. Traditional deep soil monitoring technologies are either limited in the number of measurement points (e.g., fiber Bragg grating sensing technology) or exhibit low measurement accuracy (e.g., distributed fiber optic sensing technology). This study proposes a layered settlement monitoring technique for deep soil based on the ultra-weak fiber Bragg grating sensors. First, ultra-weak fiber Bragg grating strain sensors packaged by fiber-reinforced polymer (FRP) were developed, and experimental research on the sensors’ sensing and directional recognition characteristics was conducted. Subsequently, the sensors were deployed for ground subsidence monitoring in Gaoyang County, China, with investigations conducted on sensor installation techniques and long-term measurement data. Experimental and engineering test results demonstrate that the strain and temperature sensing coefficients of the sensors are 1.22 pm/με and 17.06 pm/°C, respectively. Sensors incorporating dual ultra-weak fiber Bragg grating arrays can simultaneously detect both vertical and lateral soil displacement. Long-term monitoring data effectively reflects subsidence changes in the Gaoyang region.
- Open Access
Distribution Characteristics and Enrichment Mechanisms of Fluoride in Alluvial–Lacustrine Facies Clayey Sediments in the Land Subsidence Area of Cangzhou Plain, China
Compression of clayey sediments not only causes land subsidence but also results in geogenic high fluoride groundwater. The distribution characteristics and enrichment mechanisms of fluoride in alluvial−lacustrine facies clayey sediments in the land subsidence area of Cangzhou Plain, China, were investigated using sample collection, mineralogical research, and hydrogeochemical and isotopic analysis. The results show that F− concentration of groundwater samples ranged from 0.31 to 5.54 mg/L in aquifers. The total fluoride content of clayey sediments ranged from 440 to 792 mg/kg and porewater F− concentration ranged from 0.77 to 4.18 mg/L. Clay minerals containing fine particles, such as muscovite, facilitate the enrichment of fluoride in clayey sediments, resulting in higher total fluoride levels than those in sandy sediments. The clay porewater F− predominantly originated from the dissolution of water-soluble F and the desorption of exchangeable F from sediments. The F− concentration in porewater was further influenced by ionic interactions such as cation exchange. The stable sedimentary environment and intense compression promoted the dissolution of F–bearing minerals and the desorption of adsorbed F in deep clayey sediments. The similar composition feature of δ2H−δ18O in deep groundwater and clay porewater samples suggests a significant mixing effect. These findings highlight the joint effects of hydrogeochemical and mineralogical processes on F behavior in clayey sediments.
Open AccessDistribution Characteristics and Enrichment Mechanisms of Fluoride in Alluvial–Lacustrine Facies Clayey Sediments in the Land Subsidence Area of Cangzhou Plain, China
Compression of clayey sediments not only causes land subsidence but also results in geogenic high fluoride groundwater. The distribution characteristics and enrichment mechanisms of fluoride in alluvial−lacustrine facies clayey sediments in the land subsidence area of Cangzhou Plain, China, were investigated using sample collection, mineralogical research, and hydrogeochemical and isotopic analysis. The results show that F− concentration of groundwater samples ranged from 0.31 to 5.54 mg/L in aquifers. The total fluoride content of clayey sediments ranged from 440 to 792 mg/kg and porewater F− concentration ranged from 0.77 to 4.18 mg/L. Clay minerals containing fine particles, such as muscovite, facilitate the enrichment of fluoride in clayey sediments, resulting in higher total fluoride levels than those in sandy sediments. The clay porewater F− predominantly originated from the dissolution of water-soluble F and the desorption of exchangeable F from sediments. The F− concentration in porewater was further influenced by ionic interactions such as cation exchange. The stable sedimentary environment and intense compression promoted the dissolution of F–bearing minerals and the desorption of adsorbed F in deep clayey sediments. The similar composition feature of δ2H−δ18O in deep groundwater and clay porewater samples suggests a significant mixing effect. These findings highlight the joint effects of hydrogeochemical and mineralogical processes on F behavior in clayey sediments.