PTPaulo Gilberto de Paula Toro

Paulo Gilberto de Paula Toro

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Paulo Gilberto de Paula Toro has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Performance of the mixed compression intake system of a scramjet demonstrator at different off-design flight speeds

    by Ítalo Sabino Arrais Bezerra, Sandi Itamar Schafer de Souza, Paulo Gilberto de Paula Toro

    This paper focuses on the numerical investigation of the effects of flight speed fluctuations on the intake system performance of the scramjet demonstrator developed in the Universidade Federal do Rio Grande do Norte (UFRN). A set of 2D-RANS simulations based on equations of continuity, momentum, and energy was used to model the airflow, with the turbulence evaluated by the k-kl-ω transition model. The airflow regime was modeled as stationary and the atmospheric air under the conditional hypothesis of calorically perfect gas or non-equilibrium gas (if applicable). Three different design and off-design flight conditions were studied at Mach numbers of 6.4, 6.8 (design speed), and 7.2, considering horizontal flight at an altitude of 30 km. Several airflow phenomena are presented, such as flow fields of thermodynamic properties and velocity (Mach number), shock wave structures, and compression performance coefficients. The results showed an increase in pressure and temperature ratios with relative speed reduction at the isolator. The air mass admitted at the isolator was reduced for off-design speeds due to shock structures repositioning, significantly affecting the combustion performance, promoting air mass losses of about 8% at lower flight velocities. The shock/boundary layer interaction at high velocities provokes a separation region next to the cowl, causing air mass losses lower than 1% and accentuating local heating, above the melting limits of most engineering materials. Strong shock trains at the isolator were observed, presenting more intense wall pressure oscillations for higher flight velocities. However, the flow remained supersonic for all analyzed conditions obtaining effective stabilization, in this case, using an isolator 370 mm long. High compression performance was obtained for coefficients of adiabatic compression efficiency, within a range from 83% (Mach 6.4) to 85% (Mach 7.2), and kinetic energy efficiency, with values approximately constant, about 93,1%. These results expose velocity fluctuation limits of 5% around the design condition to reduce the excessive air mass losses and local heating of the cowl, with a lower impact on compression performance.

  • Open Access

    Conceptual study of a scramjet with symmetrical internal compression system

    by Tiago Aleixo Araújo, Ítalo Sabino Arrais Bezerra, Sandi Itamar Schafer Souza, Paulo Gilberto Paula Toro

    This paper focuses on the design analysis of a planar hydrogen-powered scramjet constructed with a symmetrical internal compression system of rectangular cross-sectional area, developed to demonstrate supersonic combustion in atmospheric flight at 30 km of altitude and velocity of 2050 m/s, equivalent to Mach number 6.8. In this analysis, is proposed an analytical approach based on theories of oblique shock wave optimized by the criterion of maximum total pressure recovery, Rayleigh flow’s and the area ratio coupled to Prandtl–Meyer to dimension the compression, combustion, and expansion sections. The design of the compression system was developed to provide velocity, and temperature sufficiently adequate for spontaneous supersonic combustion of the hydrogen-air mixture. The atmospheric airflow was modeled by the hypothesis of calorically perfect gas without viscous effects. A visualization of the effects of various flow phenomena, such as shock waves, combustion, and expansion waves, on the evolution of thermodynamic properties throughout the scramjet demonstrator is discussed. The results showed by conducted compression performance analysis, a major increase in entropy in the reflected shock wave where the criterion of shock waves of equal strength was not applied. Also, the airflow thermodynamic properties and velocity from the leading edge to the trailing edge were analyzed. With heat addition, the scramjet was able to produce uninstalled thrust.