Yunho Shin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yunho Shin has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Been Kwak
Department of Electronic Engineering, Hanyang University, Seoul, South Korea
2 shared publications Daewoong Kwon
Department of Electronic Engineering, Hanyang University, Seoul, South Korea
2 shared publications- Ilho Myeong
Myongji University
2 shared publications - Changhyeon Han
Department of Electrical Engineering Hanyang University Seoul Republic of Korea
1 shared publication - Daewoong Kwon
Department of Electronic Engineering, Hanyang University, Seoul, Republic of Korea
1 shared publication - Dongbin Kim
Department of Electrical Engineering, Hanyang University, Seoul, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 20 February 2026
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 12 (8) , eaea2328
Repurposing Si CMOS nonidealities for stochastic and analog image processing
Conventional semiconductor device engineering regards intrinsic device nonidealities as reliability concerns to be minimized or eliminated. Here, we demonstrate the strategic repurposing of these nonidealities as functional resources for advanced stochastic analog computing. We leverage two underutilized phenomena—deep-level channel trap-induced generation-recombination (G-R) noise and impact ionization–induced negative differential resistance (NDR) in body current—which have received limited attention compared to the extensively studied 1/ f noise and monotonic drain current behavior in logic-centric transistors. By exploiting G-R noise with controllable temporal correlation and NDR with an unprecedented peak-to-valley ratio (2.78 × 10 4 ) within fully depleted silicon-on-insulator transistors fabricated in industry silicon complementary metal-oxide semiconductor (CMOS) process, we achieve multifunctional analog computation at the single-device level. Our transistor seamlessly performs stochastic encryption, deterministic signal readout, and analog inversion simply through reconfiguration of applied bias conditions, thereby eliminating the need for peripheral random-number generators, dedicated analog inverters, or amplifiers. This approach not only reveals the previously unrecognized computational potential embedded in mature CMOS technologies but also presents a scalable and energy-efficient alternative to architecture based on exotic materials, laying the foundation for next-generation analog computing systems.
- 20 February 2026
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 12 (8) , eaea2328
Open AccessRepurposing Si CMOS nonidealities for stochastic and analog image processing
Conventional semiconductor device engineering regards intrinsic device nonidealities as reliability concerns to be minimized or eliminated. Here, we demonstrate the strategic repurposing of these nonidealities as functional resources for advanced stochastic analog computing. We leverage two underutilized phenomena—deep-level channel trap-induced generation-recombination (G-R) noise and impact ionization–induced negative differential resistance (NDR) in body current—which have received limited attention compared to the extensively studied 1/ f noise and monotonic drain current behavior in logic-centric transistors. By exploiting G-R noise with controllable temporal correlation and NDR with an unprecedented peak-to-valley ratio (2.78 × 10 4 ) within fully depleted silicon-on-insulator transistors fabricated in industry silicon complementary metal-oxide semiconductor (CMOS) process, we achieve multifunctional analog computation at the single-device level. Our transistor seamlessly performs stochastic encryption, deterministic signal readout, and analog inversion simply through reconfiguration of applied bias conditions, thereby eliminating the need for peripheral random-number generators, dedicated analog inverters, or amplifiers. This approach not only reveals the previously unrecognized computational potential embedded in mature CMOS technologies but also presents a scalable and energy-efficient alternative to architecture based on exotic materials, laying the foundation for next-generation analog computing systems.
- Open Access
- 9 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 27374-27380
Front-Side NMOS Connection as the Preferred Scheme: Quantifying the ~10× Resistance Limit of NMOS-Backside in DBC 3DSFET SRAM
In 3-Dimensional Stacked FET (3DSFET) technology beyond the 1 nm node, direct backside contact (DBC) has emerged as an effective approach to continue scaling of both logic and SRAM bit cells. Two NMOS connection strategies under DBC integration—backside routing and front-side routing—are analyzed. The hybrid configuration, with PMOS using DBC and NMOS using front-side contact, achieves ~30% SRAM bit cell area reduction and performance gains of 7.2% in PD/PG on-current, 4.7% in IREAD, and 7.2% in Gamma. In contrast, backside NMOS routing increases area and resistance, but reliable operation is preserved as long as resistance growth is limited to $\sim 10\times $ , establishing a practical margin for DBC adoption in future high-density SRAM.
- 9 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 27374-27380
Open AccessFront-Side NMOS Connection as the Preferred Scheme: Quantifying the ~10× Resistance Limit of NMOS-Backside in DBC 3DSFET SRAM
In 3-Dimensional Stacked FET (3DSFET) technology beyond the 1 nm node, direct backside contact (DBC) has emerged as an effective approach to continue scaling of both logic and SRAM bit cells. Two NMOS connection strategies under DBC integration—backside routing and front-side routing—are analyzed. The hybrid configuration, with PMOS using DBC and NMOS using front-side contact, achieves ~30% SRAM bit cell area reduction and performance gains of 7.2% in PD/PG on-current, 4.7% in IREAD, and 7.2% in Gamma. In contrast, backside NMOS routing increases area and resistance, but reliable operation is preserved as long as resistance growth is limited to $\sim 10\times $ , establishing a practical margin for DBC adoption in future high-density SRAM.
- 4 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 46 (10) , 1897-1900
The Impact of Through Silicon Metal (TSM) Contact on Performance and Thermal Reliability in CFET
This work proposes a common-drain engineering technique using Through-Silicon Metal (TSM) to improve electro-thermal performance in CFET architectures. After optimizing the Bottom Dielectric Isolation (BDI) thickness to 5 nm, the TSM-integrated CFET exhibits ~10% reduction in gate capacitance (Cgg:$0.580\to 0.537$ fF) and ~12.5% lower nFET thermal resistance (Rth:$0.795\to ~0.696$ K/$\mu $ W) compared to the reference. In the TSM structure, although the common drain-to-metal contact area is reduced, SNMR degradation remains minimal (~2 mV). In addition, device lifetime shows significant improvement, with BTI and HCI projections extended by$\sim 2\times $ and$\sim 1.6\times $ , respectively. These results demonstrate that TSM enables effective electro-thermal co-optimization for future CFET logic integration.- 4 August 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 46 (10) , 1897-1900
The Impact of Through Silicon Metal (TSM) Contact on Performance and Thermal Reliability in CFET
This work proposes a common-drain engineering technique using Through-Silicon Metal (TSM) to improve electro-thermal performance in CFET architectures. After optimizing the Bottom Dielectric Isolation (BDI) thickness to 5 nm, the TSM-integrated CFET exhibits ~10% reduction in gate capacitance (Cgg:$0.580\to 0.537$ fF) and ~12.5% lower nFET thermal resistance (Rth:$0.795\to ~0.696$ K/$\mu $ W) compared to the reference. In the TSM structure, although the common drain-to-metal contact area is reduced, SNMR degradation remains minimal (~2 mV). In addition, device lifetime shows significant improvement, with BTI and HCI projections extended by$\sim 2\times $ and$\sim 1.6\times $ , respectively. These results demonstrate that TSM enables effective electro-thermal co-optimization for future CFET logic integration.