EFEr Fotsing

Er Fotsing

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Er Fotsing has a total of 3 co-authors. Here are the top co-authors by number of shared publications:

  • A Ross

    Department of Mechanical Engineering, École Polytechnique de Montréal, Montréal (Québec), Canada

    2 shared publications
  • Edu Ruiz

    Department of Mechanical Engineering, École Polytechnique de Montréal, Montréal (Québec), Canada

    2 shared publications
  • M Sola

    Department of Mechanical Engineering, École Polytechnique de Montréal, Montréal (Québec), Canada

    2 shared publications

Latest Publications

  • Dynamic characterization of viscoelastic materials used in composite structures

    by Er Fotsing, M Sola, A Ross, Edu Ruiz

    The main focus of this paper is the experimental comparative analysis of the viscoelastic properties of acrylic- and silicon-based viscoelastic materials. These materials are widely used in the aeronautic industry for structural and/or damping applications. It is therefore required to determine their viscoelastic properties such as shear modulus and loss factor following their integration to aircraft composite structures. The influence of material thickness, bonding quality, curing and cocuring with composite material was evaluated using dynamic mechanical analysis machine in plan shear configuration. This comparative analysis in the 0–600 Hz frequency range provides useful information that should be taken into consideration when designing bonded joints for structural and/or damping applications. The small variation of the acrylic-based material loss factor over a wide range of frequencies suggests that this material is a good candidate for damping applications at room temperature in metallic structures where no curing is required. However, cocuring of acrylic-based material with composite laminae increases its shear modulus up to six times with respect to the uncured material whereas its loss factor is reduced by about 20%. On the other hand, the silicon-based material remains stable after thermal treatment (curing and cocuring) suggesting that it is well suited for in situ damping treatment involving laminate composite structure. However, at room temperature its shear modulus after cocuring is lowered by almost 25% due to poor bonding quality, which depends on the nature of the substrate.


  • Lightweight damping of composite sandwich beams: Experimental analysis

    by Er Fotsing, M Sola, A Ross, Edu Ruiz

    The purpose of this article is to experimentally study the damping of composite sandwich beams with lightweight honeycomb core. The top and bottom facesheets are made of carbon/epoxy layers with partial interleaved viscoelastic layers. A new damping approach consisting of selectively targeting the inflection points of the bending mode shapes is proposed. At the nodes, the shearing deformation in the beam is maximal, and so is the strain in the viscoelastic layers. The experimental investigation of damping is made by means of standard impact tests using an instrumented hammer performed on beam specimens. The nodes are determined experimentally by moving a small accelerometer along the beam axis and by measuring the amplitude of the acceleration at each point. This novel damping approach keeps the damping ratio as high as the ratio obtained with standard (full coverage) surface damping treatment while reducing the added mass by almost 50%. A comparison of the results obtained in this study with experimental and numerical results found in the literature leads to the conclusion that the most efficient way of damping this type of sandwich structure is to modify and/or improve the viscoelastic properties of the core.