Kang-Chieh Fan
Research Subjects
Kang-Chieh Fan has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Jason Midkiff
Department of Electrical and Computer Engineering
2 shared publications- Ray T. Chen
Department of Electrical and Computer Engineering, The University of Texas at Austin, Austin, USA
2 shared publications May Hlaing
Department of Electrical and Computer Engineering
1 shared publication- May Hlaing
Department of Electrical and Computer Engineering, Microelectronic Research Center, The University of Texas at Austin, Austin, TX, USA
1 shared publication Sourabh Jain
Department of Electrical and Computer Engineering
1 shared publication- Sourabh Jain
Department of Electronics and Communication Engineering, IIIT Bhopal, Bhopal, Madhya Pradesh, India
1 shared publication
Latest Publications
- Open Access
- 27 April 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (18) , 26646-26654
Slow-Light Mid-IR Silicon Photonic Chips for NO 2 and CH 4 Gas Detection
A compact, chip-scale mid-infrared gas sensor is demonstrated, leveraging a two-dimensional photonic crystal waveguide (PCW) fabricated on a silicon-on-insulator (SOI) platform. The PCW comprises a hexagonal lattice with lattice constant a = 860 nm and hole radius r = 0.22a, incorporating a central line defect of reduced-radius holes (rs = 0.7r) to induce slow-light propagation near the photonic band edge with a group index of approximately 73, thereby enhancing light-matter interaction. The sensor operates at fundamental absorption wavelengths of 3.42 μm for nitrogen dioxide (NO2) and 3.40 μm for methane (CH4), utilizing the strongest molecular vibrational transitions for maximum sensitivity. Experimental validation was conducted using dynamically diluted gas mixtures generated by mass flow controllers, with signal acquisition performed by a liquid nitrogen-cooled InSb detector. For NO2, the sensor exhibited excellent linear response over 5–25 ppm (part per million) with coefficient of determination R2 = 0.9934, achieving a detection limit of 210 ppb (part per billion)─representing the first reported silicon photonic-based NO2 detection. For CH4, exposure to 25 ppm resulted in a 6.4% decrease in transmitted intensity, demonstrating multigas sensing capability. The CMOS-compatible fabrication process and compact 3 mm device footprint establish this SOI-PCW platform as a scalable, low-power solution for integrated mid-infrared gas sensing, with significant potential for environmental monitoring and industrial safety applications.
- 27 April 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (18) , 26646-26654
Open AccessSlow-Light Mid-IR Silicon Photonic Chips for NO 2 and CH 4 Gas Detection
A compact, chip-scale mid-infrared gas sensor is demonstrated, leveraging a two-dimensional photonic crystal waveguide (PCW) fabricated on a silicon-on-insulator (SOI) platform. The PCW comprises a hexagonal lattice with lattice constant a = 860 nm and hole radius r = 0.22a, incorporating a central line defect of reduced-radius holes (rs = 0.7r) to induce slow-light propagation near the photonic band edge with a group index of approximately 73, thereby enhancing light-matter interaction. The sensor operates at fundamental absorption wavelengths of 3.42 μm for nitrogen dioxide (NO2) and 3.40 μm for methane (CH4), utilizing the strongest molecular vibrational transitions for maximum sensitivity. Experimental validation was conducted using dynamically diluted gas mixtures generated by mass flow controllers, with signal acquisition performed by a liquid nitrogen-cooled InSb detector. For NO2, the sensor exhibited excellent linear response over 5–25 ppm (part per million) with coefficient of determination R2 = 0.9934, achieving a detection limit of 210 ppb (part per billion)─representing the first reported silicon photonic-based NO2 detection. For CH4, exposure to 25 ppm resulted in a 6.4% decrease in transmitted intensity, demonstrating multigas sensing capability. The CMOS-compatible fabrication process and compact 3 mm device footprint establish this SOI-PCW platform as a scalable, low-power solution for integrated mid-infrared gas sensing, with significant potential for environmental monitoring and industrial safety applications.
- Open Access
- 1 October 2025
- Published by AIP Publishing in AIP Advances
- Vol. 15 (10)
Surface-normal photonic crystal waveguide arrays for ultra-sensitive mid-IR gas sensing
This paper presents a novel silicon-based hollow-core surface-normal photonic crystal waveguide with an air-core even mode and high group index in the meta structure. This mode is proposed for gas detection in the mid-infrared range. The structure’s bandgap map and guided modes were calculated through numerical simulations, allowing for design optimization to enable slow-light propagation of the guided modes. The design enhances light–matter interaction by leveraging large group indices and dispersion control. In experimental simulations of photonic crystal waveguide structures, an ultra-high group index of 1424 was achieved at a wavelength of 3.31 μm, matching with methane absorption. This high group index—i.e., the realization of extremely slow light—facilitates enhanced interaction with analytes of interest. The result reveals that 60.1% of the energy of the fundamental mode resides within the center air hole, providing a high overlap with analytes. The device geometry can be customized to introduce the absorption wavelengths of various analytes, enabling arrays of different device geometries on the same chip for simultaneous detection of multiple gas species.
- 1 October 2025
- Published by AIP Publishing in AIP Advances
- Vol. 15 (10)
Open AccessSurface-normal photonic crystal waveguide arrays for ultra-sensitive mid-IR gas sensing
This paper presents a novel silicon-based hollow-core surface-normal photonic crystal waveguide with an air-core even mode and high group index in the meta structure. This mode is proposed for gas detection in the mid-infrared range. The structure’s bandgap map and guided modes were calculated through numerical simulations, allowing for design optimization to enable slow-light propagation of the guided modes. The design enhances light–matter interaction by leveraging large group indices and dispersion control. In experimental simulations of photonic crystal waveguide structures, an ultra-high group index of 1424 was achieved at a wavelength of 3.31 μm, matching with methane absorption. This high group index—i.e., the realization of extremely slow light—facilitates enhanced interaction with analytes of interest. The result reveals that 60.1% of the energy of the fundamental mode resides within the center air hole, providing a high overlap with analytes. The device geometry can be customized to introduce the absorption wavelengths of various analytes, enabling arrays of different device geometries on the same chip for simultaneous detection of multiple gas species.