Se Jeong Park
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Se Jeong Park has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Bo Ram Lee
School of Advanced Materials Science and Engineering Sungkyunkwan University (SKKU) Suwon Republic of Korea
3 shared publications - Yeonsu Choi
Photoenergy Research Center Korea Research Institute of Chemical Technology (KRICT) Daejeon Republic of Korea
3 shared publications - Jae Won Shim
School of Electrical Engineering, Korea University, Seoul, Republic of Korea
2 shared publications - Seo-Jin Ko
Department of Energy Science and Engineering Daegu Gyeongbuk Institute of Science and Technology (DGIST) Daegu 42988 Republic of Korea
2 shared publications - Seunghyun Rhee
Photoenergy Research Center Korea Research Institute of Chemical Technology (KRICT) Daejeon Republic of Korea
2 shared publications - Un‐Hak Lee
Department of Energy Science and Engineering Daegu Gyeongbuk Institute of Science and Technology (DGIST) Daegu Republic of Korea
2 shared publications
Latest Publications
- Open Access
- 12 September 2026
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (85)
Oligoethylene Glycol Side‐Chain Engineering of Y6‐Derived Nonfullerene Acceptors for Thermally Induced Spontaneous Pseudo‐Planar Heterojunction Organic Photodetectors
Dark current density ( J D ) fundamentally limits the noise characteristics and detectivity of organic photodetectors (OPDs), arising primarily from reverse‐bias carrier injection and trap‐mediated leakage pathways in donor‐acceptor (D‐A) bulk‐heterojunction (BHJ) active layers. Although pseudo‐planar heterojunction ( p ‐PHJ) architectures effectively suppress these losses, their implementation often requires complex layer engineering or controlled processing conditions. Here, we report two Y6‐derived nonfullerene acceptors (NFAs), YTEG‐4F and YTEG‐4Cl, bearing hydrophilic oligoethylene glycol (OEG) side chains that induce thermally driven spontaneous vertical phase separation within the D‐A BHJ layer. This molecular modification enables p‐PHJ formation, suppressing reverse‐bias carrier injection and leakage pathways, thereby reducing J D . In contrast to the thermally annealed PM6:Y6 device, which exhibits an increased J D of 6.64 × 10 −7 A cm −2 , the PM6:YTEG‐4F and PM6:YTEG‐4Cl devices achieve low J D s of 2.76 × 10 −9 and 3.24 × 10 −9 A cm −2 , corresponding to approximately 260‐fold and 210‐fold reductions after thermal annealing, respectively. Consequently, shot‐noise‐limited detectivities ( D sh *) of 1.17 × 10 13 and 9.74 × 10 12 Jones are achieved at −0.5 V for PM6:YTEG‐4F and PM6:YTEG‐4Cl p ‐PHJ OPDs, respectively. This work demonstrates that OEG side‐chain engineering of NFAs provides a broadly applicable molecular strategy for inducing p ‐PHJ architectures and regulating J D toward high‐performance OPDs.
- 12 September 2026
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (85)
Open AccessOligoethylene Glycol Side‐Chain Engineering of Y6‐Derived Nonfullerene Acceptors for Thermally Induced Spontaneous Pseudo‐Planar Heterojunction Organic Photodetectors
Dark current density ( J D ) fundamentally limits the noise characteristics and detectivity of organic photodetectors (OPDs), arising primarily from reverse‐bias carrier injection and trap‐mediated leakage pathways in donor‐acceptor (D‐A) bulk‐heterojunction (BHJ) active layers. Although pseudo‐planar heterojunction ( p ‐PHJ) architectures effectively suppress these losses, their implementation often requires complex layer engineering or controlled processing conditions. Here, we report two Y6‐derived nonfullerene acceptors (NFAs), YTEG‐4F and YTEG‐4Cl, bearing hydrophilic oligoethylene glycol (OEG) side chains that induce thermally driven spontaneous vertical phase separation within the D‐A BHJ layer. This molecular modification enables p‐PHJ formation, suppressing reverse‐bias carrier injection and leakage pathways, thereby reducing J D . In contrast to the thermally annealed PM6:Y6 device, which exhibits an increased J D of 6.64 × 10 −7 A cm −2 , the PM6:YTEG‐4F and PM6:YTEG‐4Cl devices achieve low J D s of 2.76 × 10 −9 and 3.24 × 10 −9 A cm −2 , corresponding to approximately 260‐fold and 210‐fold reductions after thermal annealing, respectively. Consequently, shot‐noise‐limited detectivities ( D sh *) of 1.17 × 10 13 and 9.74 × 10 12 Jones are achieved at −0.5 V for PM6:YTEG‐4F and PM6:YTEG‐4Cl p ‐PHJ OPDs, respectively. This work demonstrates that OEG side‐chain engineering of NFAs provides a broadly applicable molecular strategy for inducing p ‐PHJ architectures and regulating J D toward high‐performance OPDs.
- 26 December 2025
- Published by Wiley in Advanced Materials
- Vol. 38 (10) , e20278
Visibly Transparent Monolithic Perovskite/Organic Tandem Solar Cells Achieving Over 6% Light‐Utilization Efficiency
Transparent photovoltaics for solar‐window applications must balance human‐visible clarity with meaningful power output. Here, we report a selectively absorbing, monolithic perovskite/organic tandem that decouples visible transmittance from photocurrent generation and minimizes voltage loss delivering record light‐utilization efficiency (LUE) for visibly transparent (VT) tandem devices. An ultra‐wide‐bandgap, DMA‐alloyed perovskite top sub‐cell harvests primarily <∼530 nm, achieving, as a single junction, AVT 65.68% and power conversion efficiency (PCE) 8.23% (LUE 5.46%). Complemented by a ternary PCE10‐2Cl:Y6:Y12 bottom stack that minimizes visible absorption while harvesting in the NIR, the tandem reaches PCE 10.91% at AVT 55.39%, yielding LUE 6.04%. To the best of our knowledge, this is the first VT monolithic perovskite/organic tandem to surpass 6% LUE at AVT ≥ 50%, while delivering a record‐high open circuit voltage ( V OC ) of 2.38 V. These results establish optical–electrical co‐design guidelines for high‐clarity, power‐generating glazing, which explicitly connect materials and interface choices in both sub‐cells to energetic disorder, built‐in potential, and recombination.
- 26 December 2025
- Published by Wiley in Advanced Materials
- Vol. 38 (10) , e20278
Visibly Transparent Monolithic Perovskite/Organic Tandem Solar Cells Achieving Over 6% Light‐Utilization Efficiency
Transparent photovoltaics for solar‐window applications must balance human‐visible clarity with meaningful power output. Here, we report a selectively absorbing, monolithic perovskite/organic tandem that decouples visible transmittance from photocurrent generation and minimizes voltage loss delivering record light‐utilization efficiency (LUE) for visibly transparent (VT) tandem devices. An ultra‐wide‐bandgap, DMA‐alloyed perovskite top sub‐cell harvests primarily <∼530 nm, achieving, as a single junction, AVT 65.68% and power conversion efficiency (PCE) 8.23% (LUE 5.46%). Complemented by a ternary PCE10‐2Cl:Y6:Y12 bottom stack that minimizes visible absorption while harvesting in the NIR, the tandem reaches PCE 10.91% at AVT 55.39%, yielding LUE 6.04%. To the best of our knowledge, this is the first VT monolithic perovskite/organic tandem to surpass 6% LUE at AVT ≥ 50%, while delivering a record‐high open circuit voltage ( V OC ) of 2.38 V. These results establish optical–electrical co‐design guidelines for high‐clarity, power‐generating glazing, which explicitly connect materials and interface choices in both sub‐cells to energetic disorder, built‐in potential, and recombination.
- Open Access
- 5 October 2025
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (5)
Ultra‐Sensitive Short‐Wave Infrared Organic Photodetectors Enabled by a π‐Conjugation Extended Proquinoid Electron Acceptor
Short‐wavelength infrared (SWIR) light detection technologies have attracted considerable attention due to their broad applications in bioimaging, sensing, and optical communication. Despite this promise, achieving high‐performance organic SWIR photodetectors (SWIR OPDs) remains a major challenge due to intrinsically weak photoresponse and sensitivity in this spectral region. Herein, a novel proquinoid‐type non‐fullerene acceptor (NFA), denoted as TQC‐4Cl is reported, which exhibits an ultra‐narrow band gap of 1.01 eV and a broad spectral response extending beyond 1200 nm, enabled via an aromatic‐quinoid transformation strategy. Thermal annealing of the TQC‐4Cl film significantly enhanced crystallinity and molecular ordering. Consequently, the optimized TQC‐4Cl‐based SWIR OPDs exhibit an exceptionally low dark current density ( J d ) of 4.38 × 10 −8 A cm −2 , noise current of 466 fA (at 4 Hz), and a high external quantum efficiency (EQE) of 13.66% at 1200 nm at −0.5 V bias, resulting in a shot‐noise limited specific detectivity ( D sh *) of 1.06 × 10 12 Jones and a noise current‐based specific detectivity ( D n *) of 2.84 × 10 11 Jones under the same bias conditions. The ideal phase‐separated morphology and high crystallinity of the photoactive layer provide the beneficial condition enabling efficient charge extraction, suppressed bimolecular recombination, and reduced energetic disorder. Furthermore, the devices demonstrated long‐term operational stability at 85 °C, underscoring their superior thermal durability. This study not only marks the advancement toward the realization of highly sensitive and thermally robust SWIR OPDs but also contributes to the rational molecular design strategies for ultra‐narrow bandgap organic semiconductors for next‐generation optoelectronic devices.
- 5 October 2025
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (5)
Open AccessUltra‐Sensitive Short‐Wave Infrared Organic Photodetectors Enabled by a π‐Conjugation Extended Proquinoid Electron Acceptor
Short‐wavelength infrared (SWIR) light detection technologies have attracted considerable attention due to their broad applications in bioimaging, sensing, and optical communication. Despite this promise, achieving high‐performance organic SWIR photodetectors (SWIR OPDs) remains a major challenge due to intrinsically weak photoresponse and sensitivity in this spectral region. Herein, a novel proquinoid‐type non‐fullerene acceptor (NFA), denoted as TQC‐4Cl is reported, which exhibits an ultra‐narrow band gap of 1.01 eV and a broad spectral response extending beyond 1200 nm, enabled via an aromatic‐quinoid transformation strategy. Thermal annealing of the TQC‐4Cl film significantly enhanced crystallinity and molecular ordering. Consequently, the optimized TQC‐4Cl‐based SWIR OPDs exhibit an exceptionally low dark current density ( J d ) of 4.38 × 10 −8 A cm −2 , noise current of 466 fA (at 4 Hz), and a high external quantum efficiency (EQE) of 13.66% at 1200 nm at −0.5 V bias, resulting in a shot‐noise limited specific detectivity ( D sh *) of 1.06 × 10 12 Jones and a noise current‐based specific detectivity ( D n *) of 2.84 × 10 11 Jones under the same bias conditions. The ideal phase‐separated morphology and high crystallinity of the photoactive layer provide the beneficial condition enabling efficient charge extraction, suppressed bimolecular recombination, and reduced energetic disorder. Furthermore, the devices demonstrated long‐term operational stability at 85 °C, underscoring their superior thermal durability. This study not only marks the advancement toward the realization of highly sensitive and thermally robust SWIR OPDs but also contributes to the rational molecular design strategies for ultra‐narrow bandgap organic semiconductors for next‐generation optoelectronic devices.