Mikhail M. Bubnov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Mikhail M. Bubnov has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
- Mikhail E. Likhachev
Dianov Fiber Optics Research Center, Prokhorov General Physics Institute, Russian Academy of Sciences, Moscow, Russia
10 shared publications - Denis S. Lipatov
G.G. Devyatykh Institute of Chemistry of High-Purity Substances, Russian Academy of Sciences, 49 Tropinin St., 603951 Nizhny Novgorod, Russia
5 shared publications - Svetlana S. Aleshkina
Prokhorov General Physics Institute of the Russian Academy of Sciences, Dianov Fiber Optics Research Center of the Russian Academy of Sciences, Moscow 119991, Russia
5 shared publications - Liudmila Dmitrievna Iskhakova
A.M. Prokhorov General Physics Institute of the Russian Academy of Sciences (GPI RAS), E.M. Dianov Fiber Optics Research Center, Moscow, Russia
3 shared publications Tatiana S. Zaushitsyna
A.M. Prokhorov General Physics Institute of the Russian Academy of Sciences (GPI RAS), E.M. Dianov Fiber Optics Research Center, Moscow, Russia
3 shared publications- Andrey A. Umnikov
G.G. Devyatykh Institute of Chemistry of High-Purity Substances of the Russian Academy of Sciences
2 shared publications
Latest Publications
- 2 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 44 (10) , 4208-4219
Rigorous Modeling of Electrostrictively Excited Acoustic Fields and SBS Gain Spectra in Single-Mode Optical Fibers
Mitigating the stimulated Brillouin scattering (SBS) problem in single-mode optical fibers is often based on complex doping allowing to create and spread multiple Brillouin resonances over a wide acoustic frequency range lowering an overall SBS gain maximum. Co-doping with Al2O3 is often used for it. However, it creates the “antiguiding” conditions for, at least, some of the acoustic waves electrostrictively excited in a vicinity of the fiber core. Conventional eigen-mode solvers have a fundamental restriction on guided acoustic modes and, thus, cannot allow one to calculate the SBS gain spectrum properly in a frequency region near and beyond the Brillouin frequency of pure silica. It requires the use of special approaches including an explicit account on the driving optical field. Here we provide a rigorous and, at the same time, relatively simple and fast method based on a development of the well-known infinite power-series expansion of a solution to the scalar inhomogeneous ordinary differential equation of the electrostrictively excited acoustic field, which has no requirement of specially fitting parameters and allows one to model exactly SBS gain spectra for arbitrarily doped (including different dopant species) conventional optical fibers. To complete the calculation framework, we also provide an experimental investigation of all required acousto-optical material parameters for GeO2, P2O5, Al2O3 and F dopants in MCVD-made fibers, on a base of which an Al2O3/GeO2/P2O5/F doping design of a single-mode optical fiber at 1.55 μm was proposed and experimentally verified featuring a multi-resonant BGS providing ∼11 dB of the SBS gain suppression relative to a standard single-mode germanosilicate fiber.
- 2 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 44 (10) , 4208-4219
Rigorous Modeling of Electrostrictively Excited Acoustic Fields and SBS Gain Spectra in Single-Mode Optical Fibers
Mitigating the stimulated Brillouin scattering (SBS) problem in single-mode optical fibers is often based on complex doping allowing to create and spread multiple Brillouin resonances over a wide acoustic frequency range lowering an overall SBS gain maximum. Co-doping with Al2O3 is often used for it. However, it creates the “antiguiding” conditions for, at least, some of the acoustic waves electrostrictively excited in a vicinity of the fiber core. Conventional eigen-mode solvers have a fundamental restriction on guided acoustic modes and, thus, cannot allow one to calculate the SBS gain spectrum properly in a frequency region near and beyond the Brillouin frequency of pure silica. It requires the use of special approaches including an explicit account on the driving optical field. Here we provide a rigorous and, at the same time, relatively simple and fast method based on a development of the well-known infinite power-series expansion of a solution to the scalar inhomogeneous ordinary differential equation of the electrostrictively excited acoustic field, which has no requirement of specially fitting parameters and allows one to model exactly SBS gain spectra for arbitrarily doped (including different dopant species) conventional optical fibers. To complete the calculation framework, we also provide an experimental investigation of all required acousto-optical material parameters for GeO2, P2O5, Al2O3 and F dopants in MCVD-made fibers, on a base of which an Al2O3/GeO2/P2O5/F doping design of a single-mode optical fiber at 1.55 μm was proposed and experimentally verified featuring a multi-resonant BGS providing ∼11 dB of the SBS gain suppression relative to a standard single-mode germanosilicate fiber.
- 23 October 2025
- Published by Elsevier in Optical Fiber Technology
- Vol. 95
Yb-doped tapered fiber amplifier with ultimately low higher-order modes content
- 23 October 2025
- Published by Elsevier in Optical Fiber Technology
- Vol. 95
Yb-doped tapered fiber amplifier with ultimately low higher-order modes content
- 10 October 2025
- Published by Elsevier in Optical Fiber Technology
- Vol. 95
Highly Yb-doped silica-based fibers for ultra-short lasers and amplifiers
- 10 October 2025
- Published by Elsevier in Optical Fiber Technology
- Vol. 95
Highly Yb-doped silica-based fibers for ultra-short lasers and amplifiers
- 28 August 2018
- Published by IOP Publishing in Quantum Electronics
- Vol. 48 (8) , 733-737
Use of rare-earth elements to achieve wavelength-selective absorption in high-power fibre lasers
- 28 August 2018
- Published by IOP Publishing in Quantum Electronics
- Vol. 48 (8) , 733-737
Use of rare-earth elements to achieve wavelength-selective absorption in high-power fibre lasers
- 22 February 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10083, 1008309-1008309-13
MW peak power diffraction limited monolithic Yb-doped tapered fiber amplifier
- 22 February 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10083, 1008309-1008309-13
MW peak power diffraction limited monolithic Yb-doped tapered fiber amplifier
- 5 June 2015
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 32 (7) , 1294-1308
Leakage and bend losses in solid-core Bragg fibers
An analytical approach describing the modes of solid-core Bragg fibers is presented. Our method does not assume the periodic structure of a fiber cladding; therefore, it is applicable to a wide class of solid-core Bragg fibers, including bent ones. To check derived formulas, six Bragg fibers with a core diameter from 8.4 to 42 μm and a number of cladding rings from 5 to 15 were fabricated. The measured loss spectra of the straight and bent Bragg fibers agree well with theoretical ones. Based on these results, we show that bending affects leakage losses by two mechanisms: decreasing the reflection of light from interfaces and destroying the constructive interference of reflected waves in the cladding. The role of these mechanisms at low and large (near critical) fiber curvature is discussed.
- 5 June 2015
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 32 (7) , 1294-1308
Leakage and bend losses in solid-core Bragg fibers
An analytical approach describing the modes of solid-core Bragg fibers is presented. Our method does not assume the periodic structure of a fiber cladding; therefore, it is applicable to a wide class of solid-core Bragg fibers, including bent ones. To check derived formulas, six Bragg fibers with a core diameter from 8.4 to 42 μm and a number of cladding rings from 5 to 15 were fabricated. The measured loss spectra of the straight and bent Bragg fibers agree well with theoretical ones. Based on these results, we show that bending affects leakage losses by two mechanisms: decreasing the reflection of light from interfaces and destroying the constructive interference of reflected waves in the cladding. The role of these mechanisms at low and large (near critical) fiber curvature is discussed.
- 30 October 2014
- Published by IOP Publishing in Laser Physics Letters
- Vol. 11 (12) , 125104
Narrow-linewidth mode-lock figure-eight nanosecond pulse fiber laser
- 30 October 2014
- Published by IOP Publishing in Laser Physics Letters
- Vol. 11 (12) , 125104
Narrow-linewidth mode-lock figure-eight nanosecond pulse fiber laser
- 31 December 2011
- Published by IOP Publishing in Quantum Electronics
- Vol. 41 (12) , 1073-1079
Luminescence and photoinduced absorption in ytterbium-doped optical fibres
- 31 December 2011
- Published by IOP Publishing in Quantum Electronics
- Vol. 41 (12) , 1073-1079
Luminescence and photoinduced absorption in ytterbium-doped optical fibres
- 1 January 2007
- Published by Institution of Engineering and Technology (IET)
- Vol. 2007, 712
Low-loss dispersion-shifted solid-core photonic bandgap Bragg fiber
- 1 January 2007
- Published by Institution of Engineering and Technology (IET)
- Vol. 2007, 712
Low-loss dispersion-shifted solid-core photonic bandgap Bragg fiber
- 31 March 2004
- Published by IOP Publishing in Quantum Electronics
- Vol. 34 (3) , 241-246
Optical losses in single-mode and multimode fibres heavily doped with GeO2and P2O5
- 31 March 2004
- Published by IOP Publishing in Quantum Electronics
- Vol. 34 (3) , 241-246
Optical losses in single-mode and multimode fibres heavily doped with GeO2and P2O5