Dhawal Salwan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dhawal Salwan has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Brijesh Kumbhani
Department of Electrical Engineering, Indian Institute of Technology Ropar, Rupnagar, Punjab, India
2 shared publications - Satyam Agarwal
Department of Electrical Engineering, Indian Institute of Technology Ropar, Rupnagar, Punjab, India
2 shared publications
Latest Publications
- 17 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 30 (10897798) , 203-207
Practicalities to Communication Receiver for JSC Waveform: Whether to Filter or to Undersample?
In this letter, we consider low-complexity symbol detection schemes for the UAV communication receiver using a phase shift keying-linear frequency modulated (PSK-LFM) joint sensing and communication (JSC) waveform. The JSC waveform typically employs a large bandwidth as it helps in performing radar functionality. However, UAV communication receivers typically operate at a much lower bandwidth as compared to radar. Therefore, this letter presents a communication receiver performance for two schemes: one that filters and samples a portion of the signal, while the other undersamples the entire received signal for bit detection. We analytically derive BER expressions for both schemes under imperfect CSI and assess their performance. The results show that undersampling provides better BER performance than with filtering at the same sampling rate, highlighting the robustness of the proposed receiver design.
- 17 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 30 (10897798) , 203-207
Practicalities to Communication Receiver for JSC Waveform: Whether to Filter or to Undersample?
In this letter, we consider low-complexity symbol detection schemes for the UAV communication receiver using a phase shift keying-linear frequency modulated (PSK-LFM) joint sensing and communication (JSC) waveform. The JSC waveform typically employs a large bandwidth as it helps in performing radar functionality. However, UAV communication receivers typically operate at a much lower bandwidth as compared to radar. Therefore, this letter presents a communication receiver performance for two schemes: one that filters and samples a portion of the signal, while the other undersamples the entire received signal for bit detection. We analytically derive BER expressions for both schemes under imperfect CSI and assess their performance. The results show that undersampling provides better BER performance than with filtering at the same sampling rate, highlighting the robustness of the proposed receiver design.
- 15 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Vehicles
- Vol. 11 (1) , 236-248
Design and Analysis of Low-Complexity Communication Receiver for PSK–LFM Joint Sensing and Communication Waveform
In this article, we propose novel strategies for preamble detection and synchronization to detect the symbols from the phase shift keying-linear frequency modulated (PSK-LFM) joint sensing and communication waveform at the communication receiver of an uncrewed aerial vehicle (UAV). Since radar waveform requires huge bandwidth (order of 100 MHz–2 GHz) for better range resolution, processing the same waveform at the UAV's communication receiver necessitates high analog-to-digital converter (ADC) sampling rates. To reduce the ADC sampling requirements, in this paper, we propose two signal processing schemes for the communication receiver. In first, a part of the received signal is filtered using a low pass filter (LPF) and sampled for preamble detection, symbol synchronisation, and detecting the symbols. In the other case, the entire signal undergoes undersampling for subsequent processing. Furthermore, we obtain bit error rate (BER) performance for all the cases by considering time, phase, and carrier frequency offsets. We show that processing the undersampled signal yields superior BER performance compared to the filtering approach, even when both operate at an equivalent sampling rate. Furthermore, for all cases, we compare the simulation results with and without offsets, along with the analytical results obtained without offsets.
- 15 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Vehicles
- Vol. 11 (1) , 236-248
Design and Analysis of Low-Complexity Communication Receiver for PSK–LFM Joint Sensing and Communication Waveform
In this article, we propose novel strategies for preamble detection and synchronization to detect the symbols from the phase shift keying-linear frequency modulated (PSK-LFM) joint sensing and communication waveform at the communication receiver of an uncrewed aerial vehicle (UAV). Since radar waveform requires huge bandwidth (order of 100 MHz–2 GHz) for better range resolution, processing the same waveform at the UAV's communication receiver necessitates high analog-to-digital converter (ADC) sampling rates. To reduce the ADC sampling requirements, in this paper, we propose two signal processing schemes for the communication receiver. In first, a part of the received signal is filtered using a low pass filter (LPF) and sampled for preamble detection, symbol synchronisation, and detecting the symbols. In the other case, the entire signal undergoes undersampling for subsequent processing. Furthermore, we obtain bit error rate (BER) performance for all the cases by considering time, phase, and carrier frequency offsets. We show that processing the undersampled signal yields superior BER performance compared to the filtering approach, even when both operate at an equivalent sampling rate. Furthermore, for all cases, we compare the simulation results with and without offsets, along with the analytical results obtained without offsets.