COCristian Miguel Luis Antoine Ortiz

Cristian Miguel Luis Antoine Ortiz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Cristian Miguel Luis Antoine Ortiz has a total of 25 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Study of Light-Induced Changes in the Optoelectronic Quality of Ga-Doped Silicon Wafers

    by Andres Pardo Perdomo, Nerea Dasilva Villanueva, Özlem Coşkun, Usman Ali Shah, Luis Jaime Caballero, Cristian Antoine Ortiz, Nathan Muller, Çağrı Taha Delikanlı, Ece Çamkara, Meriç Çalışkan Arslan, et al.

    Light-induced degradation (LID) of boron-doped (B-doped) Czochralski silicon (Cz-Si) due to the formation of boron-oxygen (B-O) defects is a very well-known phenomenon that limits the stability of solar cells. To overcome the detrimental effects of B-O defects, the silicon industry has adopted gallium-doped wafers. However, it has been reported that Ga-doped Cz-Si-based solar cells are affected by light and elevated temperature induced degradation (LeTID), and the origin of this phenomenon at wafer level remains unclear. In this work we investigate light-induced changes in Ga-doped p-type Cz-Si wafers of different resistivities and compare them to the well-known degradation response of B-doped substrates. Through controlled illumination–temperature experiments and photoconductance-based carrier lifetime measurements, we analyse the evolution of minority carrier lifetime and the metastable nature of the lifetime-limiting defects. It was found that upon light-soaking at room temperature for 24 hours, Ga-doped wafers exhibit an average increment in the carrier lifetime, but a drop is observed under dark annealing at 200 ºC for 10 min. This behavior, which has an opposite dynamic to the traditional B-O activation/deactivation process in B-doped wafers, might suggest the existence of a metastable defect in Ga-doped samples. By applying a higher temperature during the light-soaking step, the average carrier lifetime values of Ga-doped samples decrease around 30%, and no recovery is observed under dark annealing conditions at 70 or 200 ºC. Moreover, our results of cyclability suggest that the defects dynamic in Ga-doped Cz-Si is not reversible. The results provide new insights into the mechanisms governing stability in Ga-doped silicon at bare wafer level and their implications for reliable, high-efficiency solar cell manufacturing.

  • Open Access

    Study of compensated Si in the context of the recycling of p-type substrates for n-type based solar cell architectures

    by Nerea Dasilva Villanueva, Cristian Miguel Luis Antoine Ortiz, Luis Jaime Caballero, Usman Ali Shah, Andrés David Pardo Perdomo, Marco Ballabio, Daniel Nieves Belmar, David Fuertes Marrón, Nikolay V. Abrosimov, Enrique Cánovas, et al.

  • Open Access

    Study of Compensated Si in the Context of the Recycling of p-type Substrates for n-type Based Solar Cell Architectures

    by Nerea Dasilva Villanueva, Cristian Miguel Luis Antoine Ortiz, Luis Jaime Caballero, Usman Ali Shah, Andrés Pardo Perdomo, Nikolay V. Abrosimov, Marco Ballabio, Daniel Nieves Belmar, David Fuertes Marrón, Enrique Cánovas, et al.

    Compensated silicon has long been a topic of interest in semiconductor physics due to the complex interactions between donors and acceptor. In photovoltaics, p-type compensated Si was studied, e.g., in the framework of the development of upgraded metallurgical-grade (UMG) silicon, since the refining processes cannot avoid the presence of both B and P atoms in the feedstock.Today, the growing emphasis on circular manufacturing and end-of-life module recycling drives the attention toward n-type silicon, the current market standard. The possibility of reusing p-type feedstock from decommissioned modules compensated by donor addition could enable its integration into modern n-type architectures such as TOPCon, SHJ, and IBC. However, a key question remains open: does n-type compensated silicon (particularly when derived from recycled sources) exhibit the required optoelectronic quality for these advanced device structures?This work presents first answers to this question through a comparative study of two compensated silicon ingots: (i) an intentionally co-doped n-type ingot grown from conventional polysilicon; and (ii) a compensated ingot grown from recycled p-type material with phosphorus addition. The study aims to elucidate how dopant compensation affects key material parameters such as minority carrier lifetime and mobility, resistivity, and defect activity, thereby assessing its suitability for advanced n-type solar cell technologies. The results of this work confirm that recycled compensated silicon is a viable route toward high-efficiency n-type solar cells.

  • Open Access

    Electroluminescent performance and color tuning of heteroleptic Cu(I) complex via controlled doping and layer engineering

    by Diego Vilches, Cristian Antoine, Fabian Lara, Alan R. Cabrera, Felipe A. Angel, Iván González-Pavez

    We report the electroluminescent properties of a well-known Cu(I) complex based on P∧P-type ligands—specifically bis[2-(diphenylphosphino)phenyl] ether (DPEphos)—and N∧N-type ligands, namely, 2,9-dimethyl-1,10-phenanthroline (dmphen), [Cu(dmphen)(DPEphos)]BF4 (Cu1), as the emissive layer, transitioning from a light-emitting electrochemical cell (LEEC) to an organic light-emitting diode (OLED) configuration. No electroluminescence was observed in simple LEEC-type devices. However, the progressive introduction of injection and transport layers, and using 1,3-bis(carbazol-9-yl)benzene (mCP) as a host matrix, enabled efficient emission centered at 530 nm. We achieved effective charge balance and confinement of the recombination zone within the host through systematic optimization of host and transport layer thicknesses. We further investigated the effect of Cu1 doping concentration in mCP (0%–30%) on the device performance and emission color. While 10% doping yielded the highest luminance and efficiency, the emission color was also modulated—from green with bluish hues at low doping to yellowish green at higher levels—demonstrating a straightforward strategy for color tuning using a single Cu(I) complex. Although Cu1 is not the most efficient emitter available, its well-characterized nature and response to device architecture make it an ideal model for understanding structure–function relationships. This study offers valuable insights into layer engineering and compositional tuning, which can facilitate the development of more efficient and color-tunable devices with next-generation Cu(I)-based emitters.