Shaul Pagis-Sharon
Shaul Pagis-Sharon has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Yonatan Calahorra
Department of Materials Science and Metallurgy University of Cambridge CB3 0FS Cambrdige UK
4 shared publications - Lalitha Raveendran Nivedita
Department of Mechanical Engineering, The University of Texas at El Paso, El Paso, TX 79968, USA
3 shared publications - Ofer Sinai
Department of Materials and Interfaces, Weizmann Institute of Science, Rehovoth 76100, Israel
3 shared publications - Noor Abo-Ahmad2 shared publications
Or Azulay
2 shared publicationsRotem Shockner
2 shared publications
Latest Publications
- Open Access
- 18 November 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
A Ferrielectric Quasi-Racemic Crystal from an Enantiopolar Racemate
Ferrielectrics, materials with partly switchable polarization, enable functional responses such as pyroelectricity and piezoelectricity. However, general design strategies for purely organic ferrielectric crystals remain scarce. Here we show that quasiracemates (QR), derived from enantiopolar centrosymmetric racemates, may provide a novel route to organic ferrielectrics. In these structures, quasi-enantiomers assemble into antiparallel polar columns that reveal the hidden polarization of the parent racemate. We hypothesized that a quasi-enantiomer bearing an acidic proton capable of forming an additional hydrogen bond could enable ferrielectric switching. Guided by this principle, we designed a QR composed of N-Ac-R-Val and N-Ac-S-Thr. The obtained crystals exhibit P21 symmetry and display ferrielectric characteristics, along with a large absolute pyroelectric coefficient (∼3.9 × 10–9 C/(K·cm2)) and a relatively low absolute piezoelectric response (d22 ∼ 2.27 pm/V). Deuteration of the acidic protons suppresses both the large pyroelectric response and the ferrielectric switching, providing strong evidence that these phenomena are driven by these protons and their local hydrogen-bonding environment. The macroscopic polarization and polar properties are further tunable by doping N-Ac-RS-Val with varying concentrations of N-Ac-S-Thr.
- 18 November 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
Open AccessA Ferrielectric Quasi-Racemic Crystal from an Enantiopolar Racemate
Ferrielectrics, materials with partly switchable polarization, enable functional responses such as pyroelectricity and piezoelectricity. However, general design strategies for purely organic ferrielectric crystals remain scarce. Here we show that quasiracemates (QR), derived from enantiopolar centrosymmetric racemates, may provide a novel route to organic ferrielectrics. In these structures, quasi-enantiomers assemble into antiparallel polar columns that reveal the hidden polarization of the parent racemate. We hypothesized that a quasi-enantiomer bearing an acidic proton capable of forming an additional hydrogen bond could enable ferrielectric switching. Guided by this principle, we designed a QR composed of N-Ac-R-Val and N-Ac-S-Thr. The obtained crystals exhibit P21 symmetry and display ferrielectric characteristics, along with a large absolute pyroelectric coefficient (∼3.9 × 10–9 C/(K·cm2)) and a relatively low absolute piezoelectric response (d22 ∼ 2.27 pm/V). Deuteration of the acidic protons suppresses both the large pyroelectric response and the ferrielectric switching, providing strong evidence that these phenomena are driven by these protons and their local hydrogen-bonding environment. The macroscopic polarization and polar properties are further tunable by doping N-Ac-RS-Val with varying concentrations of N-Ac-S-Thr.
- Open Access
- 7 October 2026
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 218
Mechanisms of enhanced piezoelectric response in nanoporous GaN revealed by quantitative mapping
- 7 October 2026
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 218
Open AccessMechanisms of enhanced piezoelectric response in nanoporous GaN revealed by quantitative mapping
- Open Access
- 22 July 2026
- Published by Elsevier in SSRN Electronic Journal
Mechanisms of Enhanced Piezoelectric Response in Nanoporous GaN Revealed by Quantitative Mapping
Electrochemical etching provides a route to introduce nanoscale porosity to GaN and enhance its electromechanical properties. It remains unclear whether this enhancement results from electrostatic effects such as carrier depletion or mechanical effects such as softening. Nonetheless, neither the porosity-dependent piezoresponse nor the influence of porosity on electronic properties have been systematically studied. Herein, we mapped out the conductance and piezoresponse of electrochemically etched GaN with porosity spanning 0-60% using piezoresponse force microscopy and conductive AFM. It was found that the piezoresponse increased progressively with porosity, first sharply, then moderately, reaching about 7-8 pm/V, compared to the accepted value of 2-3 pm/V for bulk GaN. We attribute this to two effects: an initial establishment of a significant depletion region, followed by mechanical softening of the porous structure, with the latter supported by finite element simulations. Three doping levels were examined; results demonstrated that doping strongly affected etching outcomes but not the piezoresponse magnitude. Since piezoelectricity in semiconductors is fundamentally constrained by free carriers, we studied the local current response of the same samples. The tip-sample conductance was dominated by the pore edges, most likely due to geometrical factors such as sharp edges or enhanced contact area. The I-V characteristics exhibited Schottky diode behavior, indicating that operation under reverse bias conditions is preferable for useful piezoelectric applications of porous GaN. By systematically correlating porosity, piezoresponse and conductance, our work sets a quantitative framework for porous GaN piezoelectric devices
- 22 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMechanisms of Enhanced Piezoelectric Response in Nanoporous GaN Revealed by Quantitative Mapping
Electrochemical etching provides a route to introduce nanoscale porosity to GaN and enhance its electromechanical properties. It remains unclear whether this enhancement results from electrostatic effects such as carrier depletion or mechanical effects such as softening. Nonetheless, neither the porosity-dependent piezoresponse nor the influence of porosity on electronic properties have been systematically studied. Herein, we mapped out the conductance and piezoresponse of electrochemically etched GaN with porosity spanning 0-60% using piezoresponse force microscopy and conductive AFM. It was found that the piezoresponse increased progressively with porosity, first sharply, then moderately, reaching about 7-8 pm/V, compared to the accepted value of 2-3 pm/V for bulk GaN. We attribute this to two effects: an initial establishment of a significant depletion region, followed by mechanical softening of the porous structure, with the latter supported by finite element simulations. Three doping levels were examined; results demonstrated that doping strongly affected etching outcomes but not the piezoresponse magnitude. Since piezoelectricity in semiconductors is fundamentally constrained by free carriers, we studied the local current response of the same samples. The tip-sample conductance was dominated by the pore edges, most likely due to geometrical factors such as sharp edges or enhanced contact area. The I-V characteristics exhibited Schottky diode behavior, indicating that operation under reverse bias conditions is preferable for useful piezoelectric applications of porous GaN. By systematically correlating porosity, piezoresponse and conductance, our work sets a quantitative framework for porous GaN piezoelectric devices
- Open Access
- 30 October 2025
- Published by Elsevier in Surface and Coatings Technology
- Vol. 518
Quantitative model for sputter deposition on porous substrates at low temperatures
- 30 October 2025
- Published by Elsevier in Surface and Coatings Technology
- Vol. 518
Open AccessQuantitative model for sputter deposition on porous substrates at low temperatures