Yuqin Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yuqin Zhang has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Chunqi Shi
Institute of Microelectronic Circuits and Systems, East China Normal University, Shanghai, China
2 shared publications - Kangjie Zhao
Institute of Microelectronic Circuits and Systems, East China Normal University, Shanghai, China
2 shared publications - Leilei Huang
East China Normal University
2 shared publications - Runxi Zhang
Institute of Microelectronic Circuits and Systems, East China Normal University, Shanghai, China
2 shared publications - Yuri Lu
Institute of Microelectronic Circuits and Systems, East China Normal University, Shanghai, China
2 shared publications - Zitong Zhang
Institute of Microelectronic Circuits and Systems, East China Normal University, Shanghai, China
2 shared publications
Latest Publications
- 18 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (4) , 3353-3365
A Fully Integrated Doppler-Assisted FMCW Radar With Low Hertz-Range Noise Figure and High Chirp Linearity for Vital Signs Sensing and Indoor Localization
This article presents a Doppler-assisted frequency-modulated continuous-wave (FMCW) radar that combines precise range resolution capability of FMCW with high sensitivity of Doppler radar, enabling versatile performance for indoor applications. A comprehensive analysis of low-frequency noise contributions from key receiver (RX) blocks including low-noise amplifier (LNA), mixer, local oscillator (LO) buffer, and analog baseband (ABB) circuits is conducted. An “RF+LO+BB” joint noise figure (NF) improvement method is proposed to effectively suppress the low-frequency noise. To minimize frequency modulation (FM) error in charge-pump-based fractional-N phase-locked loops (PLLs), a nested-PLL architecture with an optimized loop parameter selection method is employed, significantly enhancing chirp linearity. Fabricated in a 55-nm CMOS technology, the proposed Doppler-assisted FMCW radar achieves NFs of 32.13 and 12.94 dB at 10 Hz and 1 kHz, respectively, and a chirp linearity of 0.0039% over a 3.52 GHz chirp bandwidth (BW), resulting in a maximum detection range of 19.41 m and a range resolution of 4.7 cm. The radar occupies a die area of 12.7 mm2 and consumes 594 mW in FMCW mode and 432 mW in Doppler mode under a 3.3 V supply.
- 18 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (4) , 3353-3365
A Fully Integrated Doppler-Assisted FMCW Radar With Low Hertz-Range Noise Figure and High Chirp Linearity for Vital Signs Sensing and Indoor Localization
This article presents a Doppler-assisted frequency-modulated continuous-wave (FMCW) radar that combines precise range resolution capability of FMCW with high sensitivity of Doppler radar, enabling versatile performance for indoor applications. A comprehensive analysis of low-frequency noise contributions from key receiver (RX) blocks including low-noise amplifier (LNA), mixer, local oscillator (LO) buffer, and analog baseband (ABB) circuits is conducted. An “RF+LO+BB” joint noise figure (NF) improvement method is proposed to effectively suppress the low-frequency noise. To minimize frequency modulation (FM) error in charge-pump-based fractional-N phase-locked loops (PLLs), a nested-PLL architecture with an optimized loop parameter selection method is employed, significantly enhancing chirp linearity. Fabricated in a 55-nm CMOS technology, the proposed Doppler-assisted FMCW radar achieves NFs of 32.13 and 12.94 dB at 10 Hz and 1 kHz, respectively, and a chirp linearity of 0.0039% over a 3.52 GHz chirp bandwidth (BW), resulting in a maximum detection range of 19.41 m and a range resolution of 4.7 cm. The radar occupies a die area of 12.7 mm2 and consumes 594 mW in FMCW mode and 432 mW in Doppler mode under a 3.3 V supply.
- 30 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (12) , 4678-4693
A 77-GHz Hybrid TDM-MIMO Phased-Array Radar With 186-m Detection Range and 3-cm Range Resolution
This article presents a fully integrated 77-GHz hybrid time-division-multiplexing multiple-input–multiple-output (TDM-MIMO) phased-array radar in a 55-nm CMOS process. The system integrates eight independent transmitters ( $8~{\times }~1$ TXs) and two four-channel phased-array receivers ( $2~{\times }~4$ RXs), achieving a $4.76{\times }$ increase in detection range compared to single-input–single-output (SISO) architecture in long-range radar (LRR) mode and 1.79° angular resolution with $16 {\times } 4$ virtual array in short-range radar (SRR) mode. To realize a large chirp bandwidth while maintaining low voltage-controlled oscillator (VCO) gain ( $K_{\text {VCO}}$ ), a zig-zag phase-locked loop (PLL)-based frequency-modulated continuous wave (FMCW) generator is proposed, enabling continuous multi-subband chirping. By monitoring the voltage across the capacitance in loop filter ( $V_{\text {CAP}}$ ) for subband switching, the tuning voltage ( $V_{\text {TUNE}}$ ) is configured to the optimal switching voltage, eliminating the frequency ripple ( $F_{R}$ ) during subband switching. Each TX channel integrates switches to support a flexible number and positioning of 1–8 transmitters in TDM mode. To mitigate the leakage effect caused by variations in amplitude and phase due to the varying number and position of TX on-channels, a receiver architecture with three low noise amplifiers (LNAs) and a 4-bit phase shifter is designed to achieve low noise figure (NF) and high linearity. Furthermore, an I/Q mixer is designed to achieve orthogonal-ellipse-overlapping-shape NF and petal-shape linearity over a phase difference range of 0°– ${360^{\circ } }~{\Delta \phi _{\text {leak}}}$ between the local oscillator (LO) and leakage. The chip achieves a measured maximum chirp bandwidth of 12.6-GHz spanning four zig-zag subbands. The root-mean-square (rms) frequency error is 0.0068% at 18.8-MHz/ $\mu $ s chirp rate with 2.5-GHz bandwidth, and 0.3% at 545-MHz/ $\mu $ s chirp rate with 2.65-GHz bandwidth. The eight-channel TX achieves a maximum effective isotropic radiated power (EIRP) of 32 dBm at 78.8 GHz, while the four-channel RX achieves a minimum NF of 16.3 dB at a 2-MHz intermediate frequency (IF). The hybrid radar achieves a detection range of 186 m and a range resolution of 3 cm.
- 30 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (12) , 4678-4693
A 77-GHz Hybrid TDM-MIMO Phased-Array Radar With 186-m Detection Range and 3-cm Range Resolution
This article presents a fully integrated 77-GHz hybrid time-division-multiplexing multiple-input–multiple-output (TDM-MIMO) phased-array radar in a 55-nm CMOS process. The system integrates eight independent transmitters ( $8~{\times }~1$ TXs) and two four-channel phased-array receivers ( $2~{\times }~4$ RXs), achieving a $4.76{\times }$ increase in detection range compared to single-input–single-output (SISO) architecture in long-range radar (LRR) mode and 1.79° angular resolution with $16 {\times } 4$ virtual array in short-range radar (SRR) mode. To realize a large chirp bandwidth while maintaining low voltage-controlled oscillator (VCO) gain ( $K_{\text {VCO}}$ ), a zig-zag phase-locked loop (PLL)-based frequency-modulated continuous wave (FMCW) generator is proposed, enabling continuous multi-subband chirping. By monitoring the voltage across the capacitance in loop filter ( $V_{\text {CAP}}$ ) for subband switching, the tuning voltage ( $V_{\text {TUNE}}$ ) is configured to the optimal switching voltage, eliminating the frequency ripple ( $F_{R}$ ) during subband switching. Each TX channel integrates switches to support a flexible number and positioning of 1–8 transmitters in TDM mode. To mitigate the leakage effect caused by variations in amplitude and phase due to the varying number and position of TX on-channels, a receiver architecture with three low noise amplifiers (LNAs) and a 4-bit phase shifter is designed to achieve low noise figure (NF) and high linearity. Furthermore, an I/Q mixer is designed to achieve orthogonal-ellipse-overlapping-shape NF and petal-shape linearity over a phase difference range of 0°– ${360^{\circ } }~{\Delta \phi _{\text {leak}}}$ between the local oscillator (LO) and leakage. The chip achieves a measured maximum chirp bandwidth of 12.6-GHz spanning four zig-zag subbands. The root-mean-square (rms) frequency error is 0.0068% at 18.8-MHz/ $\mu $ s chirp rate with 2.5-GHz bandwidth, and 0.3% at 545-MHz/ $\mu $ s chirp rate with 2.65-GHz bandwidth. The eight-channel TX achieves a maximum effective isotropic radiated power (EIRP) of 32 dBm at 78.8 GHz, while the four-channel RX achieves a minimum NF of 16.3 dB at a 2-MHz intermediate frequency (IF). The hybrid radar achieves a detection range of 186 m and a range resolution of 3 cm.