NKNguyen Xuan Kha

Nguyen Xuan Kha

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Nguyen Xuan Kha has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Correlation Between Fracture Systems on Outcrop and Uplifted Basement Blocks in Sedimentary Basins: A Case Study of the Uplifted Basement Block in the Cuu Long Basin

    by Kha Xuan Nguyen, An Viet Nguyen, Tuan Nguyen, Xuan Mai Huu, Thai Ba Ngoc, Thanh Quoc Truong

    Predicting fracture architecture away from wells remains a major challenge in crystalline basement reservoirs because hydrocarbon storage and fluid flow are controlled predominantly by heterogeneous secondary fracture networks. This study evaluates whether an exposed granitoid block can provide a useful structural analogue for a deeply buried fractured-basement reservoir through integration of field fracture mapping at Ke Ga, borehole image and conventional well-log data from Well BH-415 in the Bach Ho field, multi-mineral petrophysical modelling, and seismic attributes in the Cuu Long Basin, offshore Vietnam. Three principal fracture populations were identified at Ke Ga, dominated by a NNE–SSW-oriented set striking approximately 20–30° and representing about 57% of the mapped fractures. The BH-415 basement contains vertically variable NNW–SSE, NNE–SSW, NE–SW, and NW–SE fracture trends associated with contrasting degrees of brecciation, alteration, and secondary pore development. The highest-quality fractured intervals exhibit net secondary porosity of up to approximately 6.6% and net permeability exceeding 1100 mD. Cross-scale comparison reveals partial rather than one-to-one structural correspondence: the dominant NNE–SSW Ke Ga population is compatible with NNE–SSW to NE–SW trends in BH-415, and a NW–SE population occurs in both datasets, whereas other subsurface fracture trends lack clear outcrop equivalents. RAI-derived seismic attributes further show spatial consistency with structurally heterogeneous intervals identified at the well. These results demonstrate that fracture orientation alone is insufficient to predict reservoir quality and that outcrop observations should be used primarily to constrain plausible structural architectures rather than to transfer petrophysical properties directly to the subsurface. The integrated workflow provides a conservative cross-scale framework for characterizing heterogeneous fractured crystalline basement reservoirs and evaluating the applicability of surface structural analogues in subsurface exploration.

  • Open Access

    Case Study: Application of Corner Point Gridding in Static Reservoir Modelling for Hydrocarbon Volume Estimation with Integrated Quality Control

    by Nguyen Trong Dai, Truong Quoc Thanh, Mai Huu Xuan, Nguyen Xuan Kha

    The static reservoir modelling helps identify structures with petroleum potential and serves as an essential input for dynamic reservoir simulation. The varying resolutions of input data and heterogeneity of geology, modelling is also understood as a process of averaging to reasonably predict the geological conditions and spatial distribution of the reservoir. In the absence of seismic trend data, we performed vertical well analysis and applied the Monte Carlo method to predict reservoir properties in areas without well data, based on the concept that the “Mean” of well data is representative of the entire reservoir and constant. In this study, we present the application of Corner Point Gridding in building the static reservoir model. This includes grid sizing, fault modelling, build horizons in the presence of faults, and layer subdivision. The structural model was constructed by 2,667,000 cells, which has size 50 * 50 * 0.35m, 16 faults with linear shape, 200 layer using proportional method and four zones. Based on structural model, petrophysical models are developed using upscaled data, which allows the calculation of hydrocarbons initially in place. Porosity ranges from 8% to 22%, with mean values between 0.1291 and 0.1616 and water saturation is relatively high from 0.9189 to 0.9718, indicating low hydrocarbon saturation in reservoir. The total STOIIP is estimated at 950 × 10 3 m 3 , with a pore volume of 12,429 × 10 3 m 3 . The QC results show that the mean values of facies fluctuate by about 2%, and by less than 2% for porosity and water saturation in each zone.

  • Open Access

    3D Seismic Interpretation and Geological Modelling for Petroleum Reserves Estimation of I Sequence, Lower Miocene, X Field, Block Y, Malay – Tho Chu Basin, Viet Nam

    by Duong Quoc Phong, Truong Minh Ngoc Quy, Nguyen Trong Dai, Truong Quoc Thanh, Mai Huu Xuan, Nguyen Xuan Kha

    Seismic attributes are widely used to enhance geological interpretation by extracting quantitative information from seismic data. They provide insights into both structural and stratigraphic features, enabling interpreters to detect subtle changes in lithology, continuity, and geometry of subsurface formations. Attributes are especially useful in improving the resolution of seismic images, helping to delineate horizons, identify fault patterns, and visualize depositional features. This study focuses on using seismic attribute analysis to clarify the distribution of sand bodies within a reservoir interval. The objective is to identify zones with favourable sand development, define their geometry and connectivity, and outline areas with high hydrocarbon reservoir potential. The interpreted I Sequence was divided into three sub-sequences, each modelled with a geological grid size of 50m×50 m and subdivided into 150 layers. The porosity model showed mean values ranging from 0.228 to 0.2484 across the main reservoir zones, while water saturation varied from 0.90659 to 0.92747. After calculating seismic attributes, the authors delineated sand bodies in the I38_upper layer located in the North–Northwest, Northeast, and smaller bodies in the South. In the I90 layer, sand bodies were identified in the North–Northeast, East, and Southeast, along with narrow, laterally restricted sands in the western part of the study area. The P2 reserve with 50% confidence for the most potential interval (I23–I38) was estimated at 86 million cubic meters after running 200 cases.

  • Open Access

    LockCem Pumping Program for DH-3P Well Dai Hung Field, Vietnam

    by Le Quang Duyen, Tang Van Dong, Tran Huu Kien, Nguyen The Vinh, Mai Huu Xuan, Truong Quoc Thanh, Nguyen Xuan Kha

    This study focuses on the temporary wellbore security operation conducted in the Dai Hung (DH) field in the Nam Con Son basin, Vietnam. It explores the use of LockCem as a solution to prevent gas migration and accumulation through the valve system of the DH-3P Subsea Xmas tree. The pumping history of previous brine pumping attempts is examined, along with the objective and necessity of securing the wellbore to ensure the safety of the Floating Production Unit (FPU)-DH01 production. The execution plan and general methodology of the operation are outlined, including the required equipment and risk assessment. The study provides a detailed discussion of the LockCem solution, including the lab report and mixing procedure. Additionally, the operation procedure for LockCem, Viscous Pill, Musol A, and Retarded Fluids’ density and setting depth is presented. The study emphasizes the importance of well security in oil and gas production and demonstrates the effectiveness of LockCem technology in well killing. Moreover, it details the tubing required to set 200 m of LockCem at the bottom plug around 1652 m. LockCem technology kills wells and emphasizes the importance of well security in oil and gas production.

  • Open Access

    BACH HO FIELD GEOLOGICAL FEATURES IDENTIFICATION USING WELL LOGGING DATA

    by Xuan Kha Nguyen, Xuan Son Pham, Van Quy Hoang, Tuan Nguyen, Quoc Thanh Truong, Huu Xuan Mai, Van Xuan Tran

    Link for citation: Nguyen Xuan Kha, Pham Xuan Son, Hoang Van Quy, Nguyen Tuan, Truong Quoc Thanh, Mai Huu Xuan, Tran Van Xuan. Bach ho field geological features identification using well logging data. Bulletin of the Tomsk Polytechnic University. Geo Аssets Engineering, 2023, vol. 334, no. 7, рр. 35-42. In Rus. The relevance. Well geophysics is considered as a typical method that can assist in determining the petrophysics properties of reservoirs and further location of the petroleum product-containing reservoirs. For reservoirs formed from fractured basement rock, studies on the petrophysics properties of fracture zones can contribute to the identification of petroleum products. The main aim. The study applied the cross-plotting method based on raw well-logging data to identify the possible correlation between the gamma-ray logging with well-logging including neutron porosity, sonic transient time, and bulk density in three wells (BH-433, BH-809, and BH-905) of Bach Ho field in the Cuu Long Basin, Vietnam. Methods. To deploy this study, well-logging data were integrated into formation of micro images and neutro, speed of sound, and density of the basement at the surveyed reservoir positions. Results. The results indicated that granite in the investigated zones responds to the two tight value ranges (no-oil exist zones) neutro (0,000–0,100) and speed of sound (46–64), and neutro (0,000–0,100) and density (2,375–2,750) while the value ranges deviate from 0,000–0,100, 46–64, and 2,375–2,750, respectively for neutro, speed of sound, and density are closely related to the good permeability and porosity zones (oil exist zones). Based on the findings, it can be confirmed that the cross-plotting analysis has contributed positively to the initial assessment of potential ranges of the oil reservoirs in Bach Ho field. The application of the cross-plotting method will contribute to enhancing the predictability of oil and gas in the reservoirs. Ссылка для цитирования: Выявление геологических особенностей месторождения Бах ХО по данным ГИС / Нгуен Суан Кха, Фам Суан Сон, Хоанг Ван Куи, Нгуен Туан, Чыонг Куок Тхань, Май Хуу Суан, Тран Ван Суан // Известия Томского политехнического университета. Инжиниринг георесурсов. – 2023. – Т. 334. – № 7. – С. 35-42. В исследовании применялся метод кроссплоттинга, основанный на необработанных данных каротажа скважины для выявления возможной корреляции между данными гамма-каротажа и каротажа скважины, включая нейтронную пористость, время звукового переходного процесса и объемную плотность в трех скважинах (BH-433, BH-809 и BH-905) месторождения Бах Хо в бассейне Куу Лонг, Вьетнам. Для развертывания этого исследования данные ГИС были интегрированы в микроизображения пласта и нейтро, скорость звука и плотность фундамента в изученных позициях коллектора. Результаты показали, что гранит в исследованных зонах отвечает двум диапазонам плотных значений (зоны отсутствия нефти) нейтро (0,000–0,100) и скорость звука (46–64), а также нейтро (0,000–0,100) и плотность (2,375–2,750), в то время как диапазоны значений, которые отклоняются от 0,000–0,100, 46–64 и 2,375–2,750, соответственно, для нейтро, скорость звука и плотность, тесно связаны с зонами хорошей проницаемости и пористости (зонами нефтеносности). Основываясь на результатах, можно подтвердить, что анализ кросс-плотов внес положительный вклад в первоначальную оценку потенциальных диапазонов нефтяных коллекторов на месторождении Бах Хо. Применение метода кроссплоттинга будет способствовать повышению предсказуемости нефти и газа в пластах.