Zerlinda Mara Ditta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zerlinda Mara Ditta has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Jindarat Ekprasert
Department of Microbiology, Faculty of Science, Khon Kaen University, Khon Kaen 40002, Thailand
7 shared publications Prinya Chindaprasirt
5 shared publications- Vanchai Sata
Sustainable Infrastructure Research and Development Center, Department of Civil Engineering, Faculty of Engineering, Khon Kaen University, Khon Kaen 40002, Thailand
5 shared publications Wittawat Saenrang
5 shared publicationsNantawat Tanapongpisit
4 shared publicationsPoemwai Chainakun
4 shared publications
Latest Publications
- 4 February 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 514
Microalgae-assisted biomineralization of Lysinibacillus sp. WH for sustainable low-carbon biocement Production
- 4 February 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 514
Microalgae-assisted biomineralization of Lysinibacillus sp. WH for sustainable low-carbon biocement Production
- Open Access
- 10 June 2025
- Published by Elsevier in Cleaner Engineering and Technology
- Vol. 27
Influence of bioadmixture dosage on mechanical and self-healing properties of cement paste containing incinerated sugarcane press mud
- 10 June 2025
- Published by Elsevier in Cleaner Engineering and Technology
- Vol. 27
Open AccessInfluence of bioadmixture dosage on mechanical and self-healing properties of cement paste containing incinerated sugarcane press mud
- Open Access
- 20 March 2024
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-15
Mechanical and self-healing properties of cement paste containing incinerated sugarcane filter cake and Lysinibacillus sp. WH bacteria
Cement is the most widely used construction material due to its strength and affordability, but its production is energy intensive. Thus, the need to replace cement with widely available waste material such as incinerated black filter cake (IBFC) in order to reduce energy consumption and the associated CO2 emissions. However, because IBFC is a newly discovered cement replacement material, several parameters affecting the mechanical properties of IBFC-cement composite have not been thoroughly investigated yet. Thus, this work aims to investigate the impact of IBFC as a cement replacement and the addition of the calcifying bacterium Lysinibacillus sp. WH on the mechanical and self-healing properties of IBFC cement pastes. The properties of the IBFC-cement pastes were assessed by determining compressive strength, permeable void, water absorption, cement hydration product, and self-healing property. Increases in IBFC replacement reduced the durability of the cement pastes. The addition of the strain WH to IBFC cement pastes, resulting in biocement, increased the strength of the IBFC-cement composite. A 20% IBFC cement-replacement was determined to be the ideal ratio for producing biocement in this study, with a lower void percentage and water absorption value. Adding strain WH decreases pore sizes, densifies the matrix in ≤ 20% IBFC biocement, and enhances the formation of calcium silicate hydrate (C–S–H) and AFm ettringite phases. Biogenic CaCO3 and C–S–H significantly increase IBFC composite strength, especially at ≤ 20% IBFC replacement. Moreover, IBFC-cement composites with strain WH exhibit self-healing properties, with bacteria precipitating CaCO3 crystals to bridge cracks within two weeks. Overall, this work provides an approach to produce a "green/sustainable" cement using biologically enabled self-healing characteristics.
- 20 March 2024
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-15
Open AccessMechanical and self-healing properties of cement paste containing incinerated sugarcane filter cake and Lysinibacillus sp. WH bacteria
Cement is the most widely used construction material due to its strength and affordability, but its production is energy intensive. Thus, the need to replace cement with widely available waste material such as incinerated black filter cake (IBFC) in order to reduce energy consumption and the associated CO2 emissions. However, because IBFC is a newly discovered cement replacement material, several parameters affecting the mechanical properties of IBFC-cement composite have not been thoroughly investigated yet. Thus, this work aims to investigate the impact of IBFC as a cement replacement and the addition of the calcifying bacterium Lysinibacillus sp. WH on the mechanical and self-healing properties of IBFC cement pastes. The properties of the IBFC-cement pastes were assessed by determining compressive strength, permeable void, water absorption, cement hydration product, and self-healing property. Increases in IBFC replacement reduced the durability of the cement pastes. The addition of the strain WH to IBFC cement pastes, resulting in biocement, increased the strength of the IBFC-cement composite. A 20% IBFC cement-replacement was determined to be the ideal ratio for producing biocement in this study, with a lower void percentage and water absorption value. Adding strain WH decreases pore sizes, densifies the matrix in ≤ 20% IBFC biocement, and enhances the formation of calcium silicate hydrate (C–S–H) and AFm ettringite phases. Biogenic CaCO3 and C–S–H significantly increase IBFC composite strength, especially at ≤ 20% IBFC replacement. Moreover, IBFC-cement composites with strain WH exhibit self-healing properties, with bacteria precipitating CaCO3 crystals to bridge cracks within two weeks. Overall, this work provides an approach to produce a "green/sustainable" cement using biologically enabled self-healing characteristics.
- Open Access
- 29 April 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-12
Bio-strengthening of cementitious composites from incinerated sugarcane filter cake by a calcifying bacterium Lysinibacillus sp. WH
This study investigated Microbially Induced Calcite Precipitation (MICP) technology to improve the mechanical properties of cementitious composites containing incinerated sugarcane filter cake (IFC) using a calcifying bacteriumLysinibacillussp. WH. Both IFC obtained after the first and second clarification processes, referred to as white (IWFC) and black (IBFC), were experimented. This is the first work to investigate the use of IBFC as a cement replacement. According to the X-ray fluorescence (XRF) results, the main element of IWFC and IBFC was CaO (91.52%) and SiO2(58.80%), respectively. This is also the first work to investigate the use of IBFC as a cement replacement. We found that the addition of strain WH could further enhance the strength of both cementitious composites up to ~ 31%, while reduced water absorption and void. Microstructures of the composites were visualized using a scanning electron microscope (SEM). The cement hydration products were determined using X-ray diffraction (XRD) followed by Rietveld analysis. The results indicated that biogenic CaCO3was the main composition in enhancing strength of the IBFC composite, whereas induce tricalcium silicate (C3S) formation promoting the strength of IWFC composite. This work provided strong evidence that the mechanical properties of the cementitious composites could be significantly improved through the application of MICP. In fact, the strength of IFC-based cementitious composites after boosting by strain WH is only 10% smaller than that of the conventional Portland cement. While using IFC as a cement substitute is a greener way to produce environmentally friendly materials, it also provides a solution to long-term agro-industrial waste pollution problems.
- 29 April 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-12
Open AccessBio-strengthening of cementitious composites from incinerated sugarcane filter cake by a calcifying bacterium Lysinibacillus sp. WH
This study investigated Microbially Induced Calcite Precipitation (MICP) technology to improve the mechanical properties of cementitious composites containing incinerated sugarcane filter cake (IFC) using a calcifying bacteriumLysinibacillussp. WH. Both IFC obtained after the first and second clarification processes, referred to as white (IWFC) and black (IBFC), were experimented. This is the first work to investigate the use of IBFC as a cement replacement. According to the X-ray fluorescence (XRF) results, the main element of IWFC and IBFC was CaO (91.52%) and SiO2(58.80%), respectively. This is also the first work to investigate the use of IBFC as a cement replacement. We found that the addition of strain WH could further enhance the strength of both cementitious composites up to ~ 31%, while reduced water absorption and void. Microstructures of the composites were visualized using a scanning electron microscope (SEM). The cement hydration products were determined using X-ray diffraction (XRD) followed by Rietveld analysis. The results indicated that biogenic CaCO3was the main composition in enhancing strength of the IBFC composite, whereas induce tricalcium silicate (C3S) formation promoting the strength of IWFC composite. This work provided strong evidence that the mechanical properties of the cementitious composites could be significantly improved through the application of MICP. In fact, the strength of IFC-based cementitious composites after boosting by strain WH is only 10% smaller than that of the conventional Portland cement. While using IFC as a cement substitute is a greener way to produce environmentally friendly materials, it also provides a solution to long-term agro-industrial waste pollution problems.
- 30 September 2021
- Published by Wiley in Biotechnology Journal
- Vol. 17 (1) , 2100124
Kinetic model of a newly‐isolated Lysinibacillus sp. strain YL and elastic properties of its biogenic CaCO3 towards biocement application
Background: Biocement, calcifying bacteria‐incorporated cement, offers an environmentally‐friendly way to increase the cement lifespan. This work aimed to investigate the potential use of Lysinibacillus sp. strain YL towards biocement application in both theoretical and experimental ways.Methods and results: Strain YL was grown using calcium acetate (Ca(C2H3O2)2), calcium chloride (CaCl2) and calcium nitrate (Ca(NO3)2). Maximum bacterial growth of ~0.09 hr‐1 and the highest amount of CaCO3 precipitation of ~8.0 g/L were obtained when using Ca(C2H3O2)2. The SEM and XRD results confirmed that biogenic CaCO3 were calcites. The bulk, Young’s and shear moduli of biogenic CaCO3 calculated via the VRH approximation were ~1.5‐2.3 times larger than those of ordinary Portland cement. The Poisson’s ratio was 0.382 and negative in some directions, suggesting its ductility and auxetic behaviors. The new model was developed to explain the growth kinetic of strain YL in the presence of Ca(C2H3O2)2, whose concentration was optimized for biocement experiments. Strain YL could increase the compressive strength of cement up to ~50% higher than that of the uninoculated cement.Conclusion: Strain YL is a promising candidate for biocement applications. This work represents the trials of experiments and models allowing quantitatively comparison with large‐scale production in the future.
- 30 September 2021
- Published by Wiley in Biotechnology Journal
- Vol. 17 (1) , 2100124
Kinetic model of a newly‐isolated Lysinibacillus sp. strain YL and elastic properties of its biogenic CaCO3 towards biocement application
Background: Biocement, calcifying bacteria‐incorporated cement, offers an environmentally‐friendly way to increase the cement lifespan. This work aimed to investigate the potential use of Lysinibacillus sp. strain YL towards biocement application in both theoretical and experimental ways.Methods and results: Strain YL was grown using calcium acetate (Ca(C2H3O2)2), calcium chloride (CaCl2) and calcium nitrate (Ca(NO3)2). Maximum bacterial growth of ~0.09 hr‐1 and the highest amount of CaCO3 precipitation of ~8.0 g/L were obtained when using Ca(C2H3O2)2. The SEM and XRD results confirmed that biogenic CaCO3 were calcites. The bulk, Young’s and shear moduli of biogenic CaCO3 calculated via the VRH approximation were ~1.5‐2.3 times larger than those of ordinary Portland cement. The Poisson’s ratio was 0.382 and negative in some directions, suggesting its ductility and auxetic behaviors. The new model was developed to explain the growth kinetic of strain YL in the presence of Ca(C2H3O2)2, whose concentration was optimized for biocement experiments. Strain YL could increase the compressive strength of cement up to ~50% higher than that of the uninoculated cement.Conclusion: Strain YL is a promising candidate for biocement applications. This work represents the trials of experiments and models allowing quantitatively comparison with large‐scale production in the future.