GSGuoxu Shu

Guoxu Shu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Guoxu Shu has a total of 12 co-authors. Here are the top co-authors by number of shared publications:

  • Liang Huang

    Key Laboratory of Deep Petroleum Intelligent Exploration and Development, Institute of Geology and Geophysics, Chinese Academy of Sciences, Beijing, China

    2 shared publications
  • Shoudong Huo

    Institute of Geology and Geophysics, Chinese Academy of Sciences, Beijing, China

    2 shared publications
  • Gonghe Lv

    Sinopec Geophysical Corporation, Beijing, China.

    1 shared publication
  • Hao Wang

    Chinese Academy of Sciences 2 , Institute of Geology and Geophysics, Key Laboratory of Deep Petroleum Intelligent Exploration and Development, Beijing, China, and , College of Earth and Planetary Sciences, Beijing, China

    1 shared publication
  • Jiangyun Zhang

    Institute of Geology and Geophysics, Chinese Academy of Sciences 1

    1 shared publication
  • Mingran Liu

    Chinese Academy of Sciences 2 , Institute of Geology and Geophysics, Key Laboratory of Deep Petroleum Intelligent Exploration and Development, Beijing, China, and , College of Earth and Planetary Sciences, Beijing, China

    1 shared publication

Latest Publications

  • Application of full-waveform inversion technology for the detection of dam structural anomalies: A case study in Western China

    by Xuhui Zhou, Mingran Liu, Liang Huang, Shengqiang Mu, Guoxu Shu, Hao Wang, Jiangyun Zhang, Wenchao Su, Shoudong Huo

    Geophysical methods play a crucial role in noninvasive dam monitoring, but traditional techniques often face limitations in resolution, depth penetration, and lateral variation detection, which hinder their effectiveness for structural assessments. To address these challenges, we apply full-waveform inversion (FWI) to a 375 m long dam profile to evaluate its potential for structural imaging and future monitoring. Seismic data are pre-processed by stacking shots to enhance the signal-to-noise ratio (S/N), followed by band-pass and f-k filtering to remove linear and zero-frequency noise. Notch and median filtering are then applied to reduce residual noise, and time windows are used to separate surface-wave signals. FWI successfully reconstructs a detailed shallow S-wave velocity profile but yields suboptimal results for P-wave velocity, as the primary inverted signals are surface waves. The final inversion results identify the key regions and interfaces within a depth of 35 m, as well as three high-velocity anomaly zones associated with embedded monitoring equipment at a depth of 10 m. In contrast, the multi-channel analysis of surface waves method, although capable of identifying general subsurface features, fails to resolve these high-velocity anomalies with the same level of detail and precision. These results highlight the advantages of FWI in providing higher-resolution imaging and detecting subtle anomalies for future dam monitoring.


  • Compressive seismic data acquisition in a desert area of western China: A case study

    by Guoxu Shu, Taikun Shi, Liang Huang, Zhenghui Gao, Gonghe Lv, Zhixin Di, Shoudong Huo

    The seismic exploration industry continuously demands better imaging quality and consequently requires denser spatial sampling, which increases acquisition cost and time. To alleviate this burden, compressive sensing (CS) theory has been introduced in the design of acquisition geometry, as it requires fewer shot and receiver locations than traditional methods. In 2017, we conducted a field experiment in a desert area in western China. This was the first such test in China to utilize CS theory in a field test. The survey had 1760 shot records with irregular shot and receiver locations designed with guidance from CS theory. By way of data reconstruction, a seismic data set with higher sampling density (7.5 × 7.5 m bin size) was acquired, and the imaging quality was improved significantly compared to existing legacy data (15 × 15 m bin size). These results indicate that a CS-designed acquisition may reduce cost while enhancing imaging quality.