Abdelhak Djoudi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abdelhak Djoudi has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Hossein Iman-Eini
School of Electrical and Computer Engineering College of Engineering University of Tehran Tehran Iran
2 shared publications Seddik Bacha
Espace‐DEV Guyane, Université de Guyane Guyane France
2 shared publicationsAbdelhamid Kaabeche
CDER, Centre de Développement des Energies Renouvelables Route de l'Observatoire Bouzeréah Algiers Algeria
1 shared publicationAhmed Rennane
Centre De Développement des Energies Renouvelables Route De L'observatoire Bouzeréah Algiers Algeria
1 shared publicationAmar Hadj Arab
Centre De Développement des Energies Renouvelables Route De L'observatoire Bouzeréah Algiers Algeria
1 shared publication
Latest Publications
- Open Access
- 28 October 2026
- Published by Institution of Engineering and Technology (IET) in Vector: The Journal of Engineering
- Vol. 2027 (1) , e70242
Robust Analytical LUT‐Based DPC for a Weak‐Grid‐Connected DFIG with Low‐Cost Implementation
This paper focuses on analytical lookup‐table (LUT)‐based direct power control (DPC) of a grid‐connected doubly‐fed induction generator (DFIG) driven by two‐level voltage source inverter (2L‐VSI). The proposed strategy effectively mitigates the inherent limitations associated with pulse‐width modulation (PWM)‐based methods by considering the model of the 2L‐VSI. Its robustness is also enhanced compared to non‐analytical LUT‐based DPC methods, for which the stability has not been confirmed. The stability of the entire system (DFIG and 2L‐VSI) is proved. It is based on simple formulas, rendering the PWM algorithm useless and requiring reduced implimentation computational requirements. The proposed DPC has a fixed switching frequency. It is sensorless for rotor currents and does not require flux estimation. It is independent of DFIG parameters and speed. This features enhances system reliability, and reduce the material used for the driving because it requires reduced computational means and less number of current sensors. This method is effective under various grid disturbances, whether occurring individually or simultaneously. The effectiveness of the presented method is validated via simulations.
- 28 October 2026
- Published by Institution of Engineering and Technology (IET) in Vector: The Journal of Engineering
- Vol. 2027 (1) , e70242
Open AccessRobust Analytical LUT‐Based DPC for a Weak‐Grid‐Connected DFIG with Low‐Cost Implementation
This paper focuses on analytical lookup‐table (LUT)‐based direct power control (DPC) of a grid‐connected doubly‐fed induction generator (DFIG) driven by two‐level voltage source inverter (2L‐VSI). The proposed strategy effectively mitigates the inherent limitations associated with pulse‐width modulation (PWM)‐based methods by considering the model of the 2L‐VSI. Its robustness is also enhanced compared to non‐analytical LUT‐based DPC methods, for which the stability has not been confirmed. The stability of the entire system (DFIG and 2L‐VSI) is proved. It is based on simple formulas, rendering the PWM algorithm useless and requiring reduced implimentation computational requirements. The proposed DPC has a fixed switching frequency. It is sensorless for rotor currents and does not require flux estimation. It is independent of DFIG parameters and speed. This features enhances system reliability, and reduce the material used for the driving because it requires reduced computational means and less number of current sensors. This method is effective under various grid disturbances, whether occurring individually or simultaneously. The effectiveness of the presented method is validated via simulations.
- Open Access
- 1 January 2025
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 18 (1)
Sliding Mode‐Based Position Sensor Fault‐Tolerant Control of PMSG Stator Currents
This article presents an improved position sensor fault‐tolerant control (IPS‐FTC) of the stator current components of the permanent magnet synchronous generator (PMSG). It ensures the generator's operation in post‐fault conditions, which are required for uninterruptible power injection by renewable energy conversion systems (RECSs). The proposed method is based on sliding mode (SM) theory and overcomes the drawbacks of traditional position sensor fault‐tolerant control (PFTC) methods. The developed approach is relatively simple, direct, and robust versus non‐modelled quantities. Furthermore, it does not require stator voltage sensors, compared to other developed SM control techniques. The stability and convergence of the proposed approach are proven by simulation and experimental results.
- 1 January 2025
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 18 (1)
Open AccessSliding Mode‐Based Position Sensor Fault‐Tolerant Control of PMSG Stator Currents
This article presents an improved position sensor fault‐tolerant control (IPS‐FTC) of the stator current components of the permanent magnet synchronous generator (PMSG). It ensures the generator's operation in post‐fault conditions, which are required for uninterruptible power injection by renewable energy conversion systems (RECSs). The proposed method is based on sliding mode (SM) theory and overcomes the drawbacks of traditional position sensor fault‐tolerant control (PFTC) methods. The developed approach is relatively simple, direct, and robust versus non‐modelled quantities. Furthermore, it does not require stator voltage sensors, compared to other developed SM control techniques. The stability and convergence of the proposed approach are proven by simulation and experimental results.