Natalia Goncharova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Natalia Goncharova has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Johannes Hoja
Department of Chemistry, University of Graz , Heinrichstraße 28/IV, 8010 Graz
2 shared publications - Adrian Daniel Boese
Institute of Chemistry University of Graz Graz Austria
1 shared publication - Alexander List
Department of Chemistry, University of Graz , Heinrichstraße 28/IV, 8010 Graz
1 shared publication - Anna Agnieszka Hoser
Biological and Chemical Research Centre Faculty of Chemistry, University of Warsaw, Żwirki i Wigury 101, Warsaw 02-089, Poland
1 shared publication - Bartolomeo Civalleri
Department of Chemistry University of Torino Torino Italy
1 shared publication Bruno Mladineo
Ruđer Bošković Institute, Bijenička Cesta 54, 10000 Zagreb Croatia
1 shared publication
Latest Publications
- Open Access
- 12 December 2025
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 26 (1) , 476-493
BEST-CSP Benchmark Study of Polymorphs I and II of Sulfamerazine and the Perils of Polytype Polymorphs
We report the outcome of an interdisciplinary investigation, by the BEST-CSP network, of the kinetically favored form I and the low-temperature stable form II polymorphs of the drug sulfamerazine (SMZ). Form II can be reproducibly obtained by slurrying in acetonitrile(MeCN)/water at room temperature, though seeding with form II significantly speeds up the conversion. New structure determinations have been obtained for both forms over a wide temperature range, with both single crystal and powder X-ray diffraction methods. Room temperature FT-IR and solid-state 13C NMR spectra are provided. The enantiotropic but practically irreversible crystal-to-crystal transition from form II to form I is observed at temperatures ranging from 150 to 170 °C in various differential scanning calorimetry (DSC) experiments, depending on sample and heating rate. The enthalpy of transition at 150 °C is measured as Δtrs H m(II → I) = 3.15 ± 0.12 kJ mol–1. The differences in the heat capacities mean that the DSC measured enthalpies vary with the onset temperature by about 0.55 kJ mol–1 over the range of heating rates commonly used in DSC experiments. Attempts to find the solvent-mediated transition temperature were complicated by observing that slurrying experiments in both methanol and MeCN/H2O above 50 °C produce a new, late-identified polymorph, sulfamerazine form V, which is closely related to form I but with an alternative packing of the double layers, i.e., is a polytype polymorph. Forms I and V are only easily distinguishable by high-quality powder X-ray diffraction. Form V appears to be marginally more stable than form I across the temperature range studied. The experimental data, including heat capacities and thermal expansion rates, are used to test a wide range of assumptions and energy models for calculating free energy differences between these polymorphs, illustrating the challenges in computationally modeling the thermodynamic transition temperature between form I and II. The implications of the discovery of form V on establishing the phase diagram of sulfamerazine are discussed.
- 12 December 2025
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 26 (1) , 476-493
Open AccessBEST-CSP Benchmark Study of Polymorphs I and II of Sulfamerazine and the Perils of Polytype Polymorphs
We report the outcome of an interdisciplinary investigation, by the BEST-CSP network, of the kinetically favored form I and the low-temperature stable form II polymorphs of the drug sulfamerazine (SMZ). Form II can be reproducibly obtained by slurrying in acetonitrile(MeCN)/water at room temperature, though seeding with form II significantly speeds up the conversion. New structure determinations have been obtained for both forms over a wide temperature range, with both single crystal and powder X-ray diffraction methods. Room temperature FT-IR and solid-state 13C NMR spectra are provided. The enantiotropic but practically irreversible crystal-to-crystal transition from form II to form I is observed at temperatures ranging from 150 to 170 °C in various differential scanning calorimetry (DSC) experiments, depending on sample and heating rate. The enthalpy of transition at 150 °C is measured as Δtrs H m(II → I) = 3.15 ± 0.12 kJ mol–1. The differences in the heat capacities mean that the DSC measured enthalpies vary with the onset temperature by about 0.55 kJ mol–1 over the range of heating rates commonly used in DSC experiments. Attempts to find the solvent-mediated transition temperature were complicated by observing that slurrying experiments in both methanol and MeCN/H2O above 50 °C produce a new, late-identified polymorph, sulfamerazine form V, which is closely related to form I but with an alternative packing of the double layers, i.e., is a polytype polymorph. Forms I and V are only easily distinguishable by high-quality powder X-ray diffraction. Form V appears to be marginally more stable than form I across the temperature range studied. The experimental data, including heat capacities and thermal expansion rates, are used to test a wide range of assumptions and energy models for calculating free energy differences between these polymorphs, illustrating the challenges in computationally modeling the thermodynamic transition temperature between form I and II. The implications of the discovery of form V on establishing the phase diagram of sulfamerazine are discussed.
- 28 October 2025
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 163 (16)
Nudged-elastic band calculations of polymorph transitions and solid-state reactions in molecular crystals
The modeling of solid-state transformations, such as polymorphic transitions and chemical reactions in molecular crystals, is vital for many applications, including drug design and the development of new synthesis methods. However, a description via nudged-elastic band (NEB) calculations faces several crucial challenges. First, the automatic initial pathway generation based on a linear interpolation often fails for periodic systems, leading to unrealistic geometries and atomic collisions. Second, the necessary system sizes are typically beyond the scope of density functional theory (DFT) calculations in terms of computational cost, but the associated accuracy is vitally needed. To address these issues, we introduce a hybrid interpolation method that combines linear interpolation for cell parameters with spherical linear interpolation for molecular structures or intramolecular fragments, ensuring smooth and realistic transitions. Moreover, we train and benchmark machine-learned force fields (MLFFs) based on the SO3krates equivariant neural network architecture to accelerate NEB calculations while retaining near-DFT accuracy. We apply our approach to two polymorph transitions and a solid-state Diels–Alder reaction and show that our new interpolation method reliably produces viable initial pathways. The MLFFs are trained on PBE+MBD reference data and reproduce DFT lattice energies with a mean absolute error of 0.4 kJ mol−1 along the minimum-energy paths. These results highlight the potential of combining advanced interpolation techniques with MLFFs to enable automated, accurate, and efficient exploration of solid-state transformations in molecular crystals.
- 28 October 2025
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 163 (16)
Nudged-elastic band calculations of polymorph transitions and solid-state reactions in molecular crystals
The modeling of solid-state transformations, such as polymorphic transitions and chemical reactions in molecular crystals, is vital for many applications, including drug design and the development of new synthesis methods. However, a description via nudged-elastic band (NEB) calculations faces several crucial challenges. First, the automatic initial pathway generation based on a linear interpolation often fails for periodic systems, leading to unrealistic geometries and atomic collisions. Second, the necessary system sizes are typically beyond the scope of density functional theory (DFT) calculations in terms of computational cost, but the associated accuracy is vitally needed. To address these issues, we introduce a hybrid interpolation method that combines linear interpolation for cell parameters with spherical linear interpolation for molecular structures or intramolecular fragments, ensuring smooth and realistic transitions. Moreover, we train and benchmark machine-learned force fields (MLFFs) based on the SO3krates equivariant neural network architecture to accelerate NEB calculations while retaining near-DFT accuracy. We apply our approach to two polymorph transitions and a solid-state Diels–Alder reaction and show that our new interpolation method reliably produces viable initial pathways. The MLFFs are trained on PBE+MBD reference data and reproduce DFT lattice energies with a mean absolute error of 0.4 kJ mol−1 along the minimum-energy paths. These results highlight the potential of combining advanced interpolation techniques with MLFFs to enable automated, accurate, and efficient exploration of solid-state transformations in molecular crystals.