Quang Minh Thai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Quang Minh Thai has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
- Hryhorii Stanchu
Institute for Nanoscience and Engineering, University of Arkansas 4 , Fayetteville, Arkansas 72701
3 shared publications - Jifeng Liu
Dartmouth College
2 shared publications - Shui-Qing Yu
Department of Electrical Engineering and Computer Science, University of Arkansas 2 , Fayetteville, Arkansas 72701
2 shared publications - Sudip Acharya
Materials Science and Engineering, University of Arkansas 1 , Fayetteville, Arkansas 72701
2 shared publications Wei Du
University of Arkansas
2 shared publications- Wei Du
University of Arkansas
2 shared publications
Latest Publications
- 10 October 2026
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 13 (21) , 6348-6357
Germanium–Tin (GeSn) Avalanche Photodiode with up to 2.7 μm Cutoff Wavelength for Extended SWIR Detection
Separate absorption-charge multiplication (SACM) germanium–tin on silicon (GeSn on Si) avalanche photodiode (APD) offers a viable solution to achieve CMOS-compatible detection technology in short-wave infrared (SWIR)/extended SWIR (e-SWIR) range, leveraging the low k-factor of Si multiplication layer and SWIR/e-SWIR band absorption of GeSn. However, unlike the well-established growth of GeSn on Si with thick Ge buffer in between to reduce threading dislocation density due to lattice mismatch, GeSn on Si APD design requires relatively thin Ge buffer to limit electric field drop through the background p-doped buffer and efficiently transport photocarriers from the GeSn absorber to Si multiplication layer, therefore making the growth of high-Sn content APD for e-SWIR coverage very challenging. In this work, we experimentally demonstrate GeSn on Si APD up to 12.7% Sn, monolithically grown on Si substrate with 122 nm thick Ge buffer in between, which is considerably thinner than the widely used 700–900 nm thick Ge buffer. Stronger relaxation of GeSn absorber via thin Ge buffer favors Sn incorporation, leading to higher Sn content than the nominal target of 8% Sn. Device detection range is significantly improved compared to previous works─with the cutoff wavelength increased up to 2.7 μm at 300 K─in parallel with good responsivity in the SWIR/e-SWIR range, up to 1.45 A W–1 at 1.55 μm and 0.66 A W–1 at 2 μm at 77 K, corresponding to the lowest estimation of avalanche gain of 5.8 and 3 calculated based on the maximum primary responsivity. The validity of avalanche gain calculation using punch-through bias will be discussed for the case of partial depletion in the GeSn absorber.
- 10 October 2026
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 13 (21) , 6348-6357
Germanium–Tin (GeSn) Avalanche Photodiode with up to 2.7 μm Cutoff Wavelength for Extended SWIR Detection
Separate absorption-charge multiplication (SACM) germanium–tin on silicon (GeSn on Si) avalanche photodiode (APD) offers a viable solution to achieve CMOS-compatible detection technology in short-wave infrared (SWIR)/extended SWIR (e-SWIR) range, leveraging the low k-factor of Si multiplication layer and SWIR/e-SWIR band absorption of GeSn. However, unlike the well-established growth of GeSn on Si with thick Ge buffer in between to reduce threading dislocation density due to lattice mismatch, GeSn on Si APD design requires relatively thin Ge buffer to limit electric field drop through the background p-doped buffer and efficiently transport photocarriers from the GeSn absorber to Si multiplication layer, therefore making the growth of high-Sn content APD for e-SWIR coverage very challenging. In this work, we experimentally demonstrate GeSn on Si APD up to 12.7% Sn, monolithically grown on Si substrate with 122 nm thick Ge buffer in between, which is considerably thinner than the widely used 700–900 nm thick Ge buffer. Stronger relaxation of GeSn absorber via thin Ge buffer favors Sn incorporation, leading to higher Sn content than the nominal target of 8% Sn. Device detection range is significantly improved compared to previous works─with the cutoff wavelength increased up to 2.7 μm at 300 K─in parallel with good responsivity in the SWIR/e-SWIR range, up to 1.45 A W–1 at 1.55 μm and 0.66 A W–1 at 2 μm at 77 K, corresponding to the lowest estimation of avalanche gain of 5.8 and 3 calculated based on the maximum primary responsivity. The validity of avalanche gain calculation using punch-through bias will be discussed for the case of partial depletion in the GeSn absorber.
- 10 August 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (6)
Dual-barrier GeSn quantum-well lasers with operation up to 150 K
GeSn/SiGeSn quantum wells (QWs) have been investigated for the development of GeSn-based lasers. Barrier/well configurations including GeSn/GeSn and SiGeSn/GeSn were grown and characterized to evaluate carrier confinement and collection efficiency. In our previous work, a dual-barrier design (SiGeSn barrier/GeSn barrier/GeSn well) exhibited improved carrier collection efficiency for a GeSn single QW structure compared with a single-barrier configuration; however, no lasing had been reported from dual QW devices to date. Here, we report lasing from a GeSn dual-barrier single QW structure up to 140 K, with a threshold of 67 kW/cm2 at 77 K, representing a substantial threshold reduction. In addition, a 4-QW laser employing the same dual-barrier design demonstrates a clearly reduced threshold of 50 kW/cm2 at 77 K and a slightly increased maximum operating temperature of 150 K. The lower lasing threshold is attributed to decreased average carrier concentration in each well that improves the differential gain and the reduced Auger recombination rate.
- 10 August 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (6)
Dual-barrier GeSn quantum-well lasers with operation up to 150 K
GeSn/SiGeSn quantum wells (QWs) have been investigated for the development of GeSn-based lasers. Barrier/well configurations including GeSn/GeSn and SiGeSn/GeSn were grown and characterized to evaluate carrier confinement and collection efficiency. In our previous work, a dual-barrier design (SiGeSn barrier/GeSn barrier/GeSn well) exhibited improved carrier collection efficiency for a GeSn single QW structure compared with a single-barrier configuration; however, no lasing had been reported from dual QW devices to date. Here, we report lasing from a GeSn dual-barrier single QW structure up to 140 K, with a threshold of 67 kW/cm2 at 77 K, representing a substantial threshold reduction. In addition, a 4-QW laser employing the same dual-barrier design demonstrates a clearly reduced threshold of 50 kW/cm2 at 77 K and a slightly increased maximum operating temperature of 150 K. The lower lasing threshold is attributed to decreased average carrier concentration in each well that improves the differential gain and the reduced Auger recombination rate.
- Open Access
- 14 March 2026
- Published by Elsevier in SSRN Electronic Journal
Epitaxial Growth and Structural Evolution of Lattice-Matched SiGeSn/Ge Heterostructures with Si Composition up to 42%
SiGeSn alloys have emerged as a promising material platform for bandgap and strain engineering in group-IV semiconductor systems. In this work, we demonstrate the molecular beam epitaxy (MBE) growth of lattice-matched SiGeSn alloys and SiGeSn/Ge superlattice (SL) structures on Si and Ge substrates. High Si (up to 42%) and Sn (up to 10%) concentrations are achieved while maintaining excellent crystalline quality and compositional uniformity. Photoluminescence measurements confirm the tunable optical properties between the two investigated compositions, validating the effectiveness of bandgap engineering. Transmission electron microscopy further reveals defect-free SL structures with sharp and flat interfaces, demonstrating the precise interface and thickness control enabled by MBE. These results establish a reliable route for realizing high-quality SiGeSn-based heterostructures and highlight the potential of this material system for advanced heterostructures, including quantum wells, SLs, and long-period quantum cascade architectures.
- 14 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEpitaxial Growth and Structural Evolution of Lattice-Matched SiGeSn/Ge Heterostructures with Si Composition up to 42%
SiGeSn alloys have emerged as a promising material platform for bandgap and strain engineering in group-IV semiconductor systems. In this work, we demonstrate the molecular beam epitaxy (MBE) growth of lattice-matched SiGeSn alloys and SiGeSn/Ge superlattice (SL) structures on Si and Ge substrates. High Si (up to 42%) and Sn (up to 10%) concentrations are achieved while maintaining excellent crystalline quality and compositional uniformity. Photoluminescence measurements confirm the tunable optical properties between the two investigated compositions, validating the effectiveness of bandgap engineering. Transmission electron microscopy further reveals defect-free SL structures with sharp and flat interfaces, demonstrating the precise interface and thickness control enabled by MBE. These results establish a reliable route for realizing high-quality SiGeSn-based heterostructures and highlight the potential of this material system for advanced heterostructures, including quantum wells, SLs, and long-period quantum cascade architectures.
- Open Access
- 3 November 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (17)
High-quality GeSn grown in foundry mode via chemical vapor deposition enabling lasing up to 235 K
Using a commercial chemical vapor deposition reactor operated in foundry mode, we rapidly developed high-quality, high-Sn-content GeSn growth recipes within just a few months from the initial trials. A recently discovered growth strategy—spontaneous-relaxation-enhanced (SRE) Sn incorporation—was employed to produce thick, low-defect GeSn layers. We conducted a comprehensive study of GeSn alloys with Sn compositions ranging from 3.1% to 18.2%. All samples exhibited strong room-temperature photoluminescence, confirming excellent material quality. For higher-Sn compositions, optically pumped lasing was achieved at wavelengths beyond 3.3 μm over a temperature range of 77–235 K, with a threshold power density of 338 kW/cm2 at 77 K. The demonstrated combination of foundry-mode operation and SRE-based growth offers a robust, scalable route for rapid GeSn material development, facilitating technology transfer to commercial foundries and accelerating progress toward GeSn-based photonic integration.
- 3 November 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (17)
Open AccessHigh-quality GeSn grown in foundry mode via chemical vapor deposition enabling lasing up to 235 K
Using a commercial chemical vapor deposition reactor operated in foundry mode, we rapidly developed high-quality, high-Sn-content GeSn growth recipes within just a few months from the initial trials. A recently discovered growth strategy—spontaneous-relaxation-enhanced (SRE) Sn incorporation—was employed to produce thick, low-defect GeSn layers. We conducted a comprehensive study of GeSn alloys with Sn compositions ranging from 3.1% to 18.2%. All samples exhibited strong room-temperature photoluminescence, confirming excellent material quality. For higher-Sn compositions, optically pumped lasing was achieved at wavelengths beyond 3.3 μm over a temperature range of 77–235 K, with a threshold power density of 338 kW/cm2 at 77 K. The demonstrated combination of foundry-mode operation and SRE-based growth offers a robust, scalable route for rapid GeSn material development, facilitating technology transfer to commercial foundries and accelerating progress toward GeSn-based photonic integration.