Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bijon Kumar Sarkar has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of low volume coal bottom ash as partial sand replacement on the strength, durability, and microstructural properties of PPC based concrete

    by Bijon Kumar Sarkar, Anup Dinda, Kushal Ghosh, Partha Ghosh

    India’s continued reliance on coal-fired power generation produces nearly 60 million tonnes of coal bottom ash (CBA) annually due to the high ash content of domestic coal, creating significant disposal and environmental challenges. Concurrently, excessive extraction of natural river sand has resulted in resource depletion and ecological degradation, highlighting the need for alternative fine aggregates. Although coal fly ash has been widely utilized in the manufacture of Portland pozzolana cement (PPC), the use of CBA as a fine aggregate replacement in PPC-based concrete remains comparatively underexplored. This study evaluates the feasibility of incorporating CBA as a partial replacement for natural sand in PPC-based concrete. Sand was replaced with CBA at 0%, 10%, 20%, 30%, 40%, and 50% by volume, and the effects on workability, strength, durability, and microstructural properties were investigated. Increasing the CBA content reduced workability owing to its porous texture and higher water absorption. Within the investigated replacement levels, concrete containing 10–20% CBA exhibited the most favourable overall performance. At 28 days, compressive strength increased by 11.30% and 10.87%, while splitting tensile strength improved by 5.17% and 8.62% for the 10% and 20% replacement levels, respectively, compared with the conventional concrete (CC). Microstructural observations indicated a denser cementitious matrix and refined pore structure at moderate CBA replacement levels. In contrast, higher replacement levels resulted in a weaker interfacial transition zone and reduced mechanical performance. The results demonstrate that replacing natural sand with up to 20% CBA can produce PPC-based concrete with satisfactory engineering performance while promoting the beneficial utilization of an industrial by-product. Quantitative sustainability assessments remain a subject for future investigation.

  • Open Access

    Sustainable Resource-Efficient Concrete Using Bottom Ash as a Partial Sand Replacement

    by Bijon Kumar Sarkar, Partha Ghosh

    Waste materials are abundant and often act as slow environmental contaminants, creating severe ecological challenges. With rapid industrialization, electricity demand has increased substantially, and in India, coal-based thermal power plants (TPPs) remain the dominant source of power generation. Coal combustion produces two major by-products: fly ash and bottom ash (BA). While fly ash is widely utilized in blended cements due to its pozzolanic nature, BA has received comparatively limited attention despite having similar chemical characteristics. Owing to its coarser particle size, BA shows strong potential as a substitute for natural river sand, the excessive extraction of which has led to severe resource depletion and sustainability concerns. Unlike previous studies that focused on single-source BA or limited performance evaluation, this study investigates the use of BA from multiple sources to develop resource-efficient bottom ash concrete (BAC). Concrete mixes containing 0%, 20%, 35%, and 50% BA as volumetric replacements of river sand were evaluated for their fresh, mechanical, durability, and microstructural properties. The results indicate that BA significantly influences concrete performance due to its porous structure. Among the investigated mixes, 35% river sand replacement with BA showed the most favorable performance for the specific materials and sources used in this study, achieving up to 17.46% higher compressive strength and up to 16.14% higher resistance to transport-related properties at 90 days. Microstructural analysis confirmed the formation of secondary C–S–H gel, which enhanced matrix densification. However, 50% replacement resulted in reduced performance. The findings demonstrate that BA can be effectively utilized in concrete at replacement levels of up to 35% as a sustainable substitute for river sand under the investigated material conditions.