Abdul Warrish
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Abdul Warrish has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Jaspal Singh Chauhan
Aquatic Ecology Lab, Department of Himalayan Aquatic Biodiversity, Hemvati Nandan Bahuguna Garhwal University (A Central University), Srinagar-Garhwal, India
5 shared publications - Prasant Arya
Aquatic Ecology Lab, Department of Himalayan Aquatic Biodiversity, Hemvati Nandan Bahuguna Garhwal University (A Central University), Srinagar-Garhwal, India
2 shared publications - Ashish Bahuguna
Dr. Ambedkar Centre of Excellence Hemvati Nandan Bahuguna Garhwal University (A Central University) Srinagar Garhwal Uttarakhand India
1 shared publication - Deepti Semwal
Aquatic Ecology Lab, Department of Himalayan Aquatic Biodiversity, Hemvati Nandan Bahuguna Garhwal University (A Central University), Srinagar-Garhwal, India
1 shared publication - Kshitij Chaturvedi
Department of Himalayan Aquatic Biodiversity, Hemvati Nandan Bahuguna Garhwal University (A Central University), Srinagar-Garhwal, India
1 shared publication - Neha Badola
Aquatic Ecology Lab, Department of Himalayan Aquatic Biodiversity, Hemvati Nandan Bahuguna Garhwal University (A Central University), Srinagar-Garhwal, India
1 shared publication
Latest Publications
- 8 October 2026
- Published by Springer Nature in Aquatic Sciences
- Vol. 88 (4) , 139
Himalayan springs under plastic stress: an integrated microplastic risk assessment
- 8 October 2026
- Published by Springer Nature in Aquatic Sciences
- Vol. 88 (4) , 139
Himalayan springs under plastic stress: an integrated microplastic risk assessment
- 6 August 2026
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 12 (8) , 2299-2324
Advanced technologies for nanoplastics removal from water and wastewater treatment systems
Advanced technologies show promise, but challenges in cost, feasibility and scalability remain. Advanced nanoplastics removal technologies must be validated under real-world conditions, not just only in laboratory settings.
- 6 August 2026
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 12 (8) , 2299-2324
Advanced technologies for nanoplastics removal from water and wastewater treatment systems
Advanced technologies show promise, but challenges in cost, feasibility and scalability remain. Advanced nanoplastics removal technologies must be validated under real-world conditions, not just only in laboratory settings.
- 28 June 2026
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 61 (18) , 1-20
Microplastic removal from water using mucilage extracted from Opuntia ficus-indica as a natural bio-coagulant
- 28 June 2026
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 61 (18) , 1-20
Microplastic removal from water using mucilage extracted from Opuntia ficus-indica as a natural bio-coagulant
- 30 November 2025
- Published by Springer Nature in Bulletin of Environmental Contamination and Toxicology
- Vol. 115 (6) , 80
Microplastics in Precipitation: Analyzing Altitudinal Influence on Atmospheric Deposition Patterns
Atmospheric transport and deposition of microplastics (MPs) represent an emerging pathway whereby plastic pollution reaches even the most remote ecosystems. To investigate how elevation influences this process, we collected rainfall and snowfall samples across eight sites in the Central Himalaya, India, at elevations from 445 m to 3,378 m. After multi-stage sieving (5 mm to 100 μm), oxidative digestion, and vacuum filtration onto 0.8 μm cellulose membranes, samples were analyzed for concentration, size distribution, and polymer composition. We observed an inverse relationship between altitude and MPs concentration, with urban low-elevation sites yielding up to 137 MPs L⁻¹ at 445 m, compared to only 5.5 MPs L⁻¹ at 3,378 m. Fibers dominated all samples (74.1%), reflecting textile sources, while films, fragments, cluster and foam composed the remainder. Particle size distributions shifted with height, larger MPs (1–5 mm) prevailed in low-lying areas, whereas fine particles (< 100 μm; 100 μm-1 mm) accounted for high-altitude and mid-altitude deposits, highlighting the role of small MPs in long-range atmospheric transport. Polymer composition also varied with elevation lightweight polymers like polyethylene (PE) and polypropylene (PP) became more common at higher sites, while heavier polymers such as polyvinyl chloride (PVC) & polytetrafluoroethylene (PTFE) remained concentrated at lower elevations. These findings suggest that altitude is a key control on atmospheric MP deposition low-altitude regions near dense urban sources exhibit higher concentrations, while remote high-altitude zones receive fewer but finer particles may be transported from urban area.
- 30 November 2025
- Published by Springer Nature in Bulletin of Environmental Contamination and Toxicology
- Vol. 115 (6) , 80
Microplastics in Precipitation: Analyzing Altitudinal Influence on Atmospheric Deposition Patterns
Atmospheric transport and deposition of microplastics (MPs) represent an emerging pathway whereby plastic pollution reaches even the most remote ecosystems. To investigate how elevation influences this process, we collected rainfall and snowfall samples across eight sites in the Central Himalaya, India, at elevations from 445 m to 3,378 m. After multi-stage sieving (5 mm to 100 μm), oxidative digestion, and vacuum filtration onto 0.8 μm cellulose membranes, samples were analyzed for concentration, size distribution, and polymer composition. We observed an inverse relationship between altitude and MPs concentration, with urban low-elevation sites yielding up to 137 MPs L⁻¹ at 445 m, compared to only 5.5 MPs L⁻¹ at 3,378 m. Fibers dominated all samples (74.1%), reflecting textile sources, while films, fragments, cluster and foam composed the remainder. Particle size distributions shifted with height, larger MPs (1–5 mm) prevailed in low-lying areas, whereas fine particles (< 100 μm; 100 μm-1 mm) accounted for high-altitude and mid-altitude deposits, highlighting the role of small MPs in long-range atmospheric transport. Polymer composition also varied with elevation lightweight polymers like polyethylene (PE) and polypropylene (PP) became more common at higher sites, while heavier polymers such as polyvinyl chloride (PVC) & polytetrafluoroethylene (PTFE) remained concentrated at lower elevations. These findings suggest that altitude is a key control on atmospheric MP deposition low-altitude regions near dense urban sources exhibit higher concentrations, while remote high-altitude zones receive fewer but finer particles may be transported from urban area.
- Open Access
- 19 November 2025
- Published by Elsevier in Journal of Hazardous Materials: Plastics
- Vol. 1
Bioplastics and the environment: Solution or Green Illusion?
- 19 November 2025
- Published by Elsevier in Journal of Hazardous Materials: Plastics
- Vol. 1
Open AccessBioplastics and the environment: Solution or Green Illusion?