Yong Huang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yong Huang has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
- Dapeng Li
School of Environmental Science and Engineering, Suzhou University of Science and Technology, Suzhou 215009, China
2 shared publications - Jian Guan
Department of Radiation Oncology, Nanfang Hospital, Southern Medical University, Guangzhou, Guangdong, China
2 shared publications - Tian C. Zhang
Univ. of Nebraska-Lincoln
2 shared publications - Xiaolong Chen
Naval Aviation University, Yantai, China
2 shared publications - Yang Pan
Nanjing University
2 shared publications - Baoxin Chen
Naval Aviation University, Yantai, Shandong China
1 shared publication
Latest Publications
- 24 August 2023
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 30 (44) , 99762-99773
Effects of different modifying agents on the preparation and properties of coagulants derived from excess sludge
The contents and kinds of oxygen-containing functional groups are very significant when preparing cationic hydrochar coagulants via graft copolymerization. Herein, the hydrothermal conditions to produce sludge-based hydrochar (SBC) precursors were optimized by introducing different kinds and amounts of modifying agents (i.e., HCOOH, citric acid (CA), H2SO4, and H2O2), then the surface properties and flocculation performance of derived cationic coagulants (SBC-g-DMC) were studied. Results showed that the utilization of four modifiers raised the acidic groups on the SBC surface; thereinto, the presence of CA could evidently increase the content of phenolic hydroxyl groups. After DMC monomer grafting, the formed coagulants possess positive zeta potentials over a wide pH range (i.e., 3.0 ~ 11.0), showing a typical cationic property. The grafting ratio and efficiency, as well as the cationic degree of coagulants prepared with different SBC precursors follow a descending order of SBCCA-g-DMC > \({\text{SBC}}_{{\text{H}}_{2}{\mathrm{SO}}_{4}}\)-g-DMC > SBCHCOOH-g-DMC > \({\text{SBC}}_{{\text{H}}_{2}{\mathrm{O}}_{2}}\)-g-DMC; thus, SBCCA-g-DMC coagulant with the best grafting result shows a superior flocculation performance. When a dosage of 4 mg/L was adopted, the average turbidity removal rate of SBCCA-g-DMC could reach up to 94.44%. Meanwhile, due to the possible and robust oxidation with the initiator, H2O2 seems not a perfect modifier for SBC preparation. This study could provide an essential reference for the optimal synthesis of SBC and its based coagulants for organic matter recovery and pollutant removal.- 24 August 2023
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 30 (44) , 99762-99773
Effects of different modifying agents on the preparation and properties of coagulants derived from excess sludge
The contents and kinds of oxygen-containing functional groups are very significant when preparing cationic hydrochar coagulants via graft copolymerization. Herein, the hydrothermal conditions to produce sludge-based hydrochar (SBC) precursors were optimized by introducing different kinds and amounts of modifying agents (i.e., HCOOH, citric acid (CA), H2SO4, and H2O2), then the surface properties and flocculation performance of derived cationic coagulants (SBC-g-DMC) were studied. Results showed that the utilization of four modifiers raised the acidic groups on the SBC surface; thereinto, the presence of CA could evidently increase the content of phenolic hydroxyl groups. After DMC monomer grafting, the formed coagulants possess positive zeta potentials over a wide pH range (i.e., 3.0 ~ 11.0), showing a typical cationic property. The grafting ratio and efficiency, as well as the cationic degree of coagulants prepared with different SBC precursors follow a descending order of SBCCA-g-DMC > \({\text{SBC}}_{{\text{H}}_{2}{\mathrm{SO}}_{4}}\)-g-DMC > SBCHCOOH-g-DMC > \({\text{SBC}}_{{\text{H}}_{2}{\mathrm{O}}_{2}}\)-g-DMC; thus, SBCCA-g-DMC coagulant with the best grafting result shows a superior flocculation performance. When a dosage of 4 mg/L was adopted, the average turbidity removal rate of SBCCA-g-DMC could reach up to 94.44%. Meanwhile, due to the possible and robust oxidation with the initiator, H2O2 seems not a perfect modifier for SBC preparation. This study could provide an essential reference for the optimal synthesis of SBC and its based coagulants for organic matter recovery and pollutant removal.- 21 November 2022
- Published by Taylor & Francis
- p. 206-215
Research on research methods and protective measures of rockfall disasters on slope
Rock-falling slope disaster is a common geological disaster in mountainous areas of China, which is characterized by wide distribution, concealment and suddenness, etc. It is difficult to implement all-round treatment, and once the disaster occurs, it will cause serious loss of life and property. At present, the three main problems of slope rolling stone disaster are this: 1. Study on the characteristics of rolling stone movement, including the trajectory, impact force and protective measures of rolling stone. 2. Monitoring and early warning of slope rolling stone disaster, summarizing the commonly used monitoring methods and instruments, and pointing out the development direction of slope rolling stone monitoring in the future; 3. Combing common protection technologies of slope rolling stone disaster. On the basis of summarizing the above research problems, the existing problems and future development trends in the research of rolling stone disaster are pointed out: 1. When using numerical simulation to study the motion characteristics of rolling stones, the factors such as the crushing of rolling stones, the shape of rolling stones and the shape of the earth's surface should be considered, so as to better fit the actual motion situation of rolling stones and make the simulation results more accurate; 2. In the monitoring and early warning of slope rolling stone disaster. We should pay attention to the research on the separation stage of the rock-rolling disaster on the slope, and consider the index system based on the combination of dynamic index and static index to judge the risk degree of the rock-rolling disaster on the slope.
- 21 November 2022
- Published by Taylor & Francis
- p. 206-215
Research on research methods and protective measures of rockfall disasters on slope
Rock-falling slope disaster is a common geological disaster in mountainous areas of China, which is characterized by wide distribution, concealment and suddenness, etc. It is difficult to implement all-round treatment, and once the disaster occurs, it will cause serious loss of life and property. At present, the three main problems of slope rolling stone disaster are this: 1. Study on the characteristics of rolling stone movement, including the trajectory, impact force and protective measures of rolling stone. 2. Monitoring and early warning of slope rolling stone disaster, summarizing the commonly used monitoring methods and instruments, and pointing out the development direction of slope rolling stone monitoring in the future; 3. Combing common protection technologies of slope rolling stone disaster. On the basis of summarizing the above research problems, the existing problems and future development trends in the research of rolling stone disaster are pointed out: 1. When using numerical simulation to study the motion characteristics of rolling stones, the factors such as the crushing of rolling stones, the shape of rolling stones and the shape of the earth's surface should be considered, so as to better fit the actual motion situation of rolling stones and make the simulation results more accurate; 2. In the monitoring and early warning of slope rolling stone disaster. We should pay attention to the research on the separation stage of the rock-rolling disaster on the slope, and consider the index system based on the combination of dynamic index and static index to judge the risk degree of the rock-rolling disaster on the slope.
- 12 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 283-286
Investigation of damage evolution in Beishan granite utilizing cluster tessellation model
A cluster tessellation model (CTM) which combines the advantage of grain-based model and image-based model is utilized to study the damage evolution of Beishan granite (BG). First, the CTM which could take into account the meso-structure of the mineral grain shape and distribution characteristics was constructed. Then, based on the model, many uniaxial and biaxial compression experiments were implemented to verify the rationality of the CTM. The model can reproduce macro-properties and failure modes of the BG and the meso-structure significantly influenced the deformation and failure characteristics.
- 12 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 283-286
Investigation of damage evolution in Beishan granite utilizing cluster tessellation model
A cluster tessellation model (CTM) which combines the advantage of grain-based model and image-based model is utilized to study the damage evolution of Beishan granite (BG). First, the CTM which could take into account the meso-structure of the mineral grain shape and distribution characteristics was constructed. Then, based on the model, many uniaxial and biaxial compression experiments were implemented to verify the rationality of the CTM. The model can reproduce macro-properties and failure modes of the BG and the meso-structure significantly influenced the deformation and failure characteristics.
- 14 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 398-403
Non-Parametric Searching Sparse Long-Time Coherent Integration Method for Highly Maneuverable Target of MIMO Radar
Radar maneuvering target detection under complex background has always been a worldwide difficult problem in the field of radar signal processing. The range and Doppler migration would cause the target's energy distributed among multiple range or Doppler bins. Moreover, the heavy computational burden of long-time integration is a challenging problem that needs to be solved. A novel non-parametric searching sparse long-time coherent integration (LTCI) method is proposed for highly maneuverable target detection using MIMO radar. Time-reversed and non-uniform resampling (TRNU) are designed to remove the migrations and adaptive sparse Fourier transform is employed to reduce the computational burden. The maneuvering target would appear as peaks in the TRNU-sparse LTCI (SLTCI) domain with less clutter. Experiments using S-band real radar data indicate that the proposed method can achieve a good balance between computational cost and integration performance compared with classical methods, e.g., Radon-Fourier transform (RFT) and Radon-fractional FT (RFRFT).
- 14 October 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 398-403
Non-Parametric Searching Sparse Long-Time Coherent Integration Method for Highly Maneuverable Target of MIMO Radar
Radar maneuvering target detection under complex background has always been a worldwide difficult problem in the field of radar signal processing. The range and Doppler migration would cause the target's energy distributed among multiple range or Doppler bins. Moreover, the heavy computational burden of long-time integration is a challenging problem that needs to be solved. A novel non-parametric searching sparse long-time coherent integration (LTCI) method is proposed for highly maneuverable target detection using MIMO radar. Time-reversed and non-uniform resampling (TRNU) are designed to remove the migrations and adaptive sparse Fourier transform is employed to reduce the computational burden. The maneuvering target would appear as peaks in the TRNU-sparse LTCI (SLTCI) domain with less clutter. Experiments using S-band real radar data indicate that the proposed method can achieve a good balance between computational cost and integration performance compared with classical methods, e.g., Radon-Fourier transform (RFT) and Radon-fractional FT (RFRFT).
- 10 February 2020
- Published by Institution of Engineering and Technology (IET) in IET Radar, Sonar & Navigation
- Vol. 14 (4) , 601-606
SRAP for range‐coupled radar imaging
Both waveforms of the frequency diverse array radar and the orthogonal frequency division multiplexing multiple‐input–multiple‐output radar are range coupled, so they provide an inherent advantage of angle–range joint imaging. The derivation of the signal models shows that the ranging principles are the same and the main differences lie in the spectrum structures and the demodulation schemes. Space–range adaptive processing (SRAP) is proposed for the two kinds of radar systems. Numerical simulations show that super‐resolution angle–range images with extra‐low sidelobes can be obtained via SRAP. The super‐resolution performances of the range‐coupled radars are evaluated and analysed.
- 10 February 2020
- Published by Institution of Engineering and Technology (IET) in IET Radar, Sonar & Navigation
- Vol. 14 (4) , 601-606
SRAP for range‐coupled radar imaging
Both waveforms of the frequency diverse array radar and the orthogonal frequency division multiplexing multiple‐input–multiple‐output radar are range coupled, so they provide an inherent advantage of angle–range joint imaging. The derivation of the signal models shows that the ranging principles are the same and the main differences lie in the spectrum structures and the demodulation schemes. Space–range adaptive processing (SRAP) is proposed for the two kinds of radar systems. Numerical simulations show that super‐resolution angle–range images with extra‐low sidelobes can be obtained via SRAP. The super‐resolution performances of the range‐coupled radars are evaluated and analysed.
- 1 October 2016
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 40 (19-20) , 8708-8721
Erosion of plugged tees in exhaust pipes through variously-sized cuttings
- 1 October 2016
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 40 (19-20) , 8708-8721
Erosion of plugged tees in exhaust pipes through variously-sized cuttings
- 1 August 2014
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 140 (8)
Competitive Reduction of Nitrate, Nitrite, and Nitrobenzene in Fe0-Water Systems
- 1 August 2014
- Published by American Society of Civil Engineers (ASCE) in Journal of Environmental Engineering
- Vol. 140 (8)
Competitive Reduction of Nitrate, Nitrite, and Nitrobenzene in Fe0-Water Systems
- 1 May 2014
- Published by Elsevier in Applied Thermal Engineering
- Vol. 66 (1-2) , 140-147
Fabrication and thermal performance of porous crack composite wick flattened heat pipe
- 1 May 2014
- Published by Elsevier in Applied Thermal Engineering
- Vol. 66 (1-2) , 140-147
Fabrication and thermal performance of porous crack composite wick flattened heat pipe