Hiroaki Ando
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hiroaki Ando has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
M. Ichida
Konan University
2 shared publications- Naoki Kobayashi
NTT Basic Research Laboratories, 3-1 Morinosato-Wakamiya, Atsugi-shi, Kanagawa 243-01, Japan
2 shared publications T. Ito
Shizuoka University
2 shared publicationsA. Morozumi
Shizuoka University
1 shared publication- Arturo Chavez-Pirson
NP Photonics, Inc., Tucson, AZ 85747 USA
1 shared publication Daisuke Kawamoto
Department of Chemistry, Faculty of Science, Kyushu University, 744 Motooka, Nishi-ku, Fukuoka 819-0395
1 shared publication
Latest Publications
- Open Access
- 2 November 2016
- Published by Oxford University Press (OUP) in Bulletin of the Chemical Society of Japan
- Vol. 89 (11) , 1385-1390
Structure of a Gold(III) Hydroxide and Determination of Its Solubility
A representative gold(III) complex ion ([AuCl4]−), successively hydrolyzes to form [AuCl4−n(OH)n]− (n = 0–4) in aqueous solution as the pH increases and, finally, precipitates. It has been referred to as “gold(III) hydroxide” for the past fifty years. However, whether the precipitate is gold(III) hydroxide (Au(OH)3) or hydrous gold(III) oxide (Au2O3·nH2O) has remained uncertain. Few studies have been conducted to determine its chemical and physical properties. The aim of this investigation is to identify the precipitate and to determine its solubility. The precipitate was X-ray amorphous. Based on the transmission electron microscopy (TEM) observation, the shape was spherical and the particle diameter was approximately 9 nm. From the results of 197Au Mössbauer spectroscopy, Au L3-edge X-ray absorption (XA) spectroscopy and thermogravimetry/differential thermal analysis (TG/DTA) measurements, the precipitate composition was estimated to be Au(OH)3. Based on the composition, its structure was proposed to be a linear polymer. Moreover, its solubility at 298 K was determined to be 0.00120 g/100 g of H2O. This chemical and physical properties information of Au(OH)3 is essential for gold chemistry, for example, for preparing supported gold catalyst.
- 2 November 2016
- Published by Oxford University Press (OUP) in Bulletin of the Chemical Society of Japan
- Vol. 89 (11) , 1385-1390
Open AccessStructure of a Gold(III) Hydroxide and Determination of Its Solubility
A representative gold(III) complex ion ([AuCl4]−), successively hydrolyzes to form [AuCl4−n(OH)n]− (n = 0–4) in aqueous solution as the pH increases and, finally, precipitates. It has been referred to as “gold(III) hydroxide” for the past fifty years. However, whether the precipitate is gold(III) hydroxide (Au(OH)3) or hydrous gold(III) oxide (Au2O3·nH2O) has remained uncertain. Few studies have been conducted to determine its chemical and physical properties. The aim of this investigation is to identify the precipitate and to determine its solubility. The precipitate was X-ray amorphous. Based on the transmission electron microscopy (TEM) observation, the shape was spherical and the particle diameter was approximately 9 nm. From the results of 197Au Mössbauer spectroscopy, Au L3-edge X-ray absorption (XA) spectroscopy and thermogravimetry/differential thermal analysis (TG/DTA) measurements, the precipitate composition was estimated to be Au(OH)3. Based on the composition, its structure was proposed to be a linear polymer. Moreover, its solubility at 298 K was determined to be 0.00120 g/100 g of H2O. This chemical and physical properties information of Au(OH)3 is essential for gold chemistry, for example, for preparing supported gold catalyst.
- 8 January 2016
- Published by Springer Nature
- p. 171-174
Observation of Electron Spin Relaxation Time in Pnpn Structured GaAs
- 8 January 2016
- Published by Springer Nature
- p. 171-174
Observation of Electron Spin Relaxation Time in Pnpn Structured GaAs
- 8 January 2016
- Published by Springer Nature
- p. 175-178
Evaluation of Spin Relaxation Time by Polarization- and Time-Resolved Pump and Probe Measurements
- 8 January 2016
- Published by Springer Nature
- p. 175-178
Evaluation of Spin Relaxation Time by Polarization- and Time-Resolved Pump and Probe Measurements
- 1 April 2005
- Published by Elsevier in Journal of Luminescence
- Vol. 112 (1-4) , 287-290
Temperature dependence of time-resolved luminescence spectra for 1D excitons in single-walled carbon nanotubes in micelles
- 1 April 2005
- Published by Elsevier in Journal of Luminescence
- Vol. 112 (1-4) , 287-290
Temperature dependence of time-resolved luminescence spectra for 1D excitons in single-walled carbon nanotubes in micelles
- 20 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, 953-954
Absorption properties of the GaN/AlGaN multiple quantum wells grown on SiC substrate
GaN/AlGaN Quantum Wells (QWs) are attracting much attention because they enable the optical devices to operate at short wavelengths. To design optical devices that use these GaN/AlGaN QWs, we need to investigate their optical properties. Photoluminescence excitation (PLE) spectroscopy is useful for investigating the absorption properties of layered materials because information about the embedded layers can be obtained by tuning the monitoring wavelength to various luminescence lines. This paper reports the use of PLE spectroscopy with multiple monitoring wavelengths to evaluate the absorption properties of the MO-VPE grown GaN/A1GaN multiple quantum well (MQW). As far as the authors know, these are the first results of PLE measurement for the GaN/AlGaN QW structures.
- 20 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, 953-954
Absorption properties of the GaN/AlGaN multiple quantum wells grown on SiC substrate
GaN/AlGaN Quantum Wells (QWs) are attracting much attention because they enable the optical devices to operate at short wavelengths. To design optical devices that use these GaN/AlGaN QWs, we need to investigate their optical properties. Photoluminescence excitation (PLE) spectroscopy is useful for investigating the absorption properties of layered materials because information about the embedded layers can be obtained by tuning the monitoring wavelength to various luminescence lines. This paper reports the use of PLE spectroscopy with multiple monitoring wavelengths to evaluate the absorption properties of the MO-VPE grown GaN/A1GaN multiple quantum well (MQW). As far as the authors know, these are the first results of PLE measurement for the GaN/AlGaN QW structures.
- 17 December 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 154-156
Linear and nonlinear optical properties in fractional-layer-superlattice quantum wires
- 17 December 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 154-156
Linear and nonlinear optical properties in fractional-layer-superlattice quantum wires
- Open Access
- 1 January 2001
- Published by Pharmaceutical Society of Japan in Journal of Health Science
- Vol. 47 (1) , 75-77
Examination of an Internal Standard Substance for the Quantitative Analysis of Sarin Using 31P-NMR.
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 1 January 2001
- Published by Pharmaceutical Society of Japan in Journal of Health Science
- Vol. 47 (1) , 75-77
Open AccessExamination of an Internal Standard Substance for the Quantitative Analysis of Sarin Using 31P-NMR.
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 1 November 2000
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 39 (11R) , 6259
GaAs Photonic Crystals on SiO2 Fabricated by Very-High-Frequency Anode-Coupled Reactive Ion Etching and Wafer Bonding
High-aspect-ratio, two-dimensional (2D) air-column GaAs photonic crystals (PhCs) on SiO2 layers with a lattice constant ranging from 240 nm to 1.0 µm have been fabricated using a novel method combining wafer bonding and low-temperature very-high-frequency (VHF) reactive ion etching (RIE). The obtained PhCs exhibit near-field patterns of sixfold symmetry or fourfold symmetry due to lateral interference, depending on the lattice structure. We have obtained photoluminescence (PL) spectra of PhCs which reveal the low damage feature of the combined process of low-temperature RIE and wafer bonding. Reflectance spectra exhibit fine structures which originate from the resonance coupling of the external light to the zone-folded bands of the photonic structure. This vertical confinement structure, obtained by forming GaAs PhCs on SiO2, is useful for taking advantage of 2D photonic crystals since it prevents photon dissipation from the lattice plane. The fabrication method combining low-temperature RIE with wafer bonding is a promising process for developing 2D photonic crystals on SiO2 layers.
- 1 November 2000
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 39 (11R) , 6259
GaAs Photonic Crystals on SiO2 Fabricated by Very-High-Frequency Anode-Coupled Reactive Ion Etching and Wafer Bonding
High-aspect-ratio, two-dimensional (2D) air-column GaAs photonic crystals (PhCs) on SiO2 layers with a lattice constant ranging from 240 nm to 1.0 µm have been fabricated using a novel method combining wafer bonding and low-temperature very-high-frequency (VHF) reactive ion etching (RIE). The obtained PhCs exhibit near-field patterns of sixfold symmetry or fourfold symmetry due to lateral interference, depending on the lattice structure. We have obtained photoluminescence (PL) spectra of PhCs which reveal the low damage feature of the combined process of low-temperature RIE and wafer bonding. Reflectance spectra exhibit fine structures which originate from the resonance coupling of the external light to the zone-folded bands of the photonic structure. This vertical confinement structure, obtained by forming GaAs PhCs on SiO2, is useful for taking advantage of 2D photonic crystals since it prevents photon dissipation from the lattice plane. The fabrication method combining low-temperature RIE with wafer bonding is a promising process for developing 2D photonic crystals on SiO2 layers.
- 14 February 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (7) , 867-869
Lateral electric-field effects on excitonic photoemissions in InGaAs quantum disks
Electric-field effects on excitons in zero-dimensional InGaAs quantum disks have been examined at low temperature. Photoluminescence from a single isolated disk was measured under the application of a lateral electric field by using the microphotoluminescence technique. A redshift of sharp excitonic luminescence and a decrease in its intensity under increasing electric field were observed. These were found to distinctively depend on the lateral extent of the disks: these were much more prominent in the larger disk. The exciton luminescence was found to be highly polarized along the direction of the field in the larger disk.
- 14 February 2000
- Published by AIP Publishing in Applied Physics Letters
- Vol. 76 (7) , 867-869
Lateral electric-field effects on excitonic photoemissions in InGaAs quantum disks
Electric-field effects on excitons in zero-dimensional InGaAs quantum disks have been examined at low temperature. Photoluminescence from a single isolated disk was measured under the application of a lateral electric field by using the microphotoluminescence technique. A redshift of sharp excitonic luminescence and a decrease in its intensity under increasing electric field were observed. These were found to distinctively depend on the lateral extent of the disks: these were much more prominent in the larger disk. The exciton luminescence was found to be highly polarized along the direction of the field in the larger disk.
- 1 January 1997
- Published by Elsevier in Journal of Crystal Growth
- Vol. 170 (1-4) , 719-724
Hexagonal facet laser with optical waveguides grown by flow-rate modulation epitaxy
- 1 January 1997
- Published by Elsevier in Journal of Crystal Growth
- Vol. 170 (1-4) , 719-724
Hexagonal facet laser with optical waveguides grown by flow-rate modulation epitaxy