Tian Ma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tian Ma has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Jian Min Gao
Beijing Forestry University
1 shared publicationJin Ju Sun
Beijing Forestry University
1 shared publication- Jingjing Yu
Felix Bloch Institute for Solid State Physics, Faculty of Physics and Earth System Sciences, Universität Leipzig 1 , 04103 Leipzig
1 shared publication Lixin Dong
School of Mining Engineering, University of Science and Technology Liaoning, Anshan, Liaoning 114051, PR China
1 shared publication- Renji Zheng
School of Resources and Environmental Engineering, Wuhan University of Technology, Wuhan 430070, China
1 shared publication - Shujuan Dai
School of Chemical Engineering, University of Science and Technology Liaoning, Anshan, China
1 shared publication
Latest Publications
- 9 February 2022
- Published by Elsevier in Advanced Powder Technology
- Vol. 33 (3) , 103468
Mechanochemical homodisperse of Bi2MoO6 on Zn-Al LDH matrix to form Z-scheme heterojunction with promoted visible-light photocatalytic performance
- 9 February 2022
- Published by Elsevier in Advanced Powder Technology
- Vol. 33 (3) , 103468
Mechanochemical homodisperse of Bi2MoO6 on Zn-Al LDH matrix to form Z-scheme heterojunction with promoted visible-light photocatalytic performance
- 18 September 2013
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 821-822, 1307-1312
Preparation and Characterization of Microporous Hemp Stem-Based Activated Carbons
Activated carbons are prepared from hemp stem with KOH as activating agent under different ratio of KOH to carbon conditions. The BET(Brunauer Emmett and Teller) specific surface area of the hemp stem-based activated carbons first increases and then decreases with the increasing ratio of KOH to carbon. The specific surface area, micropore surface area and volume of the activated carbons reach a maximum of 1589.27m2/g 1420.52m2/g, 89% of the total area, 0.751m3/g at the ratio of 4.5:1. The micropore size distribution shows the activated carbons contain a large number of ultramicropore and supermicropore.
- 18 September 2013
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 821-822, 1307-1312
Preparation and Characterization of Microporous Hemp Stem-Based Activated Carbons
Activated carbons are prepared from hemp stem with KOH as activating agent under different ratio of KOH to carbon conditions. The BET(Brunauer Emmett and Teller) specific surface area of the hemp stem-based activated carbons first increases and then decreases with the increasing ratio of KOH to carbon. The specific surface area, micropore surface area and volume of the activated carbons reach a maximum of 1589.27m2/g 1420.52m2/g, 89% of the total area, 0.751m3/g at the ratio of 4.5:1. The micropore size distribution shows the activated carbons contain a large number of ultramicropore and supermicropore.
- 1 May 2012
- Published by IWA Publishing in Water Science & Technology
- Vol. 65 (9) , 1615-1623
Estimation and modeling of direct rapid sand filtration for total fecal coliform removal from secondary clarifier effluents
The filtration of fecal coliform from a secondary clarifier effluent was investigated using direct rapid sand filters as tertiary wastewater treatment on a pilot scale. The effect of the flocculation dose, flow loading rate, and grain size on fecal coliform removal was determined. Direct rapid sand filters can remove 0.6–1.5 log-units of fecal coliform, depending on the loading rate and grain size distribution. Meanwhile, the flocculation dose has little effect on coliform removal, and increasing the loading rate and/or grain size decreases the bacteria removal efficiency. A model was then developed for the removal process. Bacteria elimination and inactivation both in the water phase and the sand bed can be described by first-order kinetics. Removal was successfully simulated at different loading rates and grain size distributions and compared with the data obtained using pilot-scale filters.
- 1 May 2012
- Published by IWA Publishing in Water Science & Technology
- Vol. 65 (9) , 1615-1623
Estimation and modeling of direct rapid sand filtration for total fecal coliform removal from secondary clarifier effluents
The filtration of fecal coliform from a secondary clarifier effluent was investigated using direct rapid sand filters as tertiary wastewater treatment on a pilot scale. The effect of the flocculation dose, flow loading rate, and grain size on fecal coliform removal was determined. Direct rapid sand filters can remove 0.6–1.5 log-units of fecal coliform, depending on the loading rate and grain size distribution. Meanwhile, the flocculation dose has little effect on coliform removal, and increasing the loading rate and/or grain size decreases the bacteria removal efficiency. A model was then developed for the removal process. Bacteria elimination and inactivation both in the water phase and the sand bed can be described by first-order kinetics. Removal was successfully simulated at different loading rates and grain size distributions and compared with the data obtained using pilot-scale filters.