Liancheng Zhao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Liancheng Zhao has a total of 42 co-authors. Here are the top co-authors by number of shared publications:
- Fengyun Guo
School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China
3 shared publications - Yong Zhang
School of Materials Science and Engineering, Harbin Institute of Technology, Harbin, China
3 shared publications Caili Lang
School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China
2 shared publications- Song He
Academy of Military Medical Sciences
2 shared publications - Xianshun Zeng
Tianjin Key Laboratory for Photoelectric Materials and Devices, and Key Laboratory of Display Materials & Photoelectric Devices, Ministry of Education, School of Materials Science & Engineering, Tianjin University of Technology, Tianjin 300384, China
2 shared publications - Barrett K. Duan
Department of Pathology , Harvard Medical School , Brigham and Women's Hospital, Wyss Institute for Biologically Inspired Engineering, Building for Transformative Medicine, 60 Fenwood Road , Boston , Massachusetts 02115 , United States
1 shared publication
Latest Publications
- 26 March 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (13) , 15448-15458
Benzo[1,2-b:4,5-b′]difuran Polymer-Based Non-Fullerene Organic Solar Cells: The Roles of Non-Fullerene Acceptors and Molybdenum Oxide on Their Ambient Stabilities and Processabilities
The ambient stability and processability of organic solar cells (OSCs) are important factors for their commercialization. Herein, we selected four benzo[1,2-b:4,5-b′]difuran (BDF) polymers and two electron acceptors to examine the role of photovoltaic materials in the ambient stability. The investigations revealed that the MoOx layer is the detrimental factor for the ambient stabilities. The penetration of MoOx into the active layer and their interactions will strengthen the interface and form a favorable contact, hence leading to the increased photovoltaic performance, in which the efficiency loss induced by air was balanced out. As such, these BDF polymer-based non-fullerene (NF) OSCs possessed very promising ambient stabilities even after ∼1000 h with the almost maintained power conversion efficiencies (PCEs). These results drive us to further investigate the ambient processability of these NF–OSCs. The PCEs from the devices processed under ambient condition only possessed 0.3–2% loss compared to those devices under inert conditions, which suggest the significant potentials of BDF polymers to develop highly efficient and stable NF–OSCs for the practical applications.
- 26 March 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (13) , 15448-15458
Benzo[1,2-b:4,5-b′]difuran Polymer-Based Non-Fullerene Organic Solar Cells: The Roles of Non-Fullerene Acceptors and Molybdenum Oxide on Their Ambient Stabilities and Processabilities
The ambient stability and processability of organic solar cells (OSCs) are important factors for their commercialization. Herein, we selected four benzo[1,2-b:4,5-b′]difuran (BDF) polymers and two electron acceptors to examine the role of photovoltaic materials in the ambient stability. The investigations revealed that the MoOx layer is the detrimental factor for the ambient stabilities. The penetration of MoOx into the active layer and their interactions will strengthen the interface and form a favorable contact, hence leading to the increased photovoltaic performance, in which the efficiency loss induced by air was balanced out. As such, these BDF polymer-based non-fullerene (NF) OSCs possessed very promising ambient stabilities even after ∼1000 h with the almost maintained power conversion efficiencies (PCEs). These results drive us to further investigate the ambient processability of these NF–OSCs. The PCEs from the devices processed under ambient condition only possessed 0.3–2% loss compared to those devices under inert conditions, which suggest the significant potentials of BDF polymers to develop highly efficient and stable NF–OSCs for the practical applications.
- 4 July 2018
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 54 (60) , 8339-8342
A colorimetric and fluorometric dual-modal sensor for methanol based on a functionalized pentacenequinone derivative
A functionalized pentacenequinone derivative, ZR1, as a highly selective sensor for methanol has been prepared. Based on the methanol-induced keto–enol tautomerization of the pentacene-quinone moiety, ZR1 shows specific selectivity toward methanol, which leads to dual-modal detection of methanol with a very low detection limit of 0.038% in ethanol.
- 4 July 2018
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 54 (60) , 8339-8342
A colorimetric and fluorometric dual-modal sensor for methanol based on a functionalized pentacenequinone derivative
A functionalized pentacenequinone derivative, ZR1, as a highly selective sensor for methanol has been prepared. Based on the methanol-induced keto–enol tautomerization of the pentacene-quinone moiety, ZR1 shows specific selectivity toward methanol, which leads to dual-modal detection of methanol with a very low detection limit of 0.038% in ethanol.
- 18 May 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry B
- Vol. 6 (24) , 4096-4103
A rhodamine-based fast and selective fluorescent probe for monitoring exogenous and endogenous nitric oxide in live cells
Nitric oxide, an important cellular messenger molecule, plays a wide range of physiological roles in neurotransmission, vascular relaxation, platelet activation, and immune response. In this work, we synthesized a selective and sensitive cationic fluorescent probe (ROPD) for monitoring exogenous and endogenous nitric oxide in live cells by grafting a NO-trapper o-phenylenediamine (OPD), via one of the amino groups of OPD, onto a rhodamine fluorophore at the C-3 position. The probe exhibited high selectivity and sensitivity towards NO with fast response in the water phase over a wide pH range. At the same time, the probe ROPD is cell-membrane permeable and can be used for the real-time visualization of exogenous NO in both L929 and HeLa cells, and endogenous NO in stressed RAW 264.7 cells.
- 18 May 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry B
- Vol. 6 (24) , 4096-4103
A rhodamine-based fast and selective fluorescent probe for monitoring exogenous and endogenous nitric oxide in live cells
Nitric oxide, an important cellular messenger molecule, plays a wide range of physiological roles in neurotransmission, vascular relaxation, platelet activation, and immune response. In this work, we synthesized a selective and sensitive cationic fluorescent probe (ROPD) for monitoring exogenous and endogenous nitric oxide in live cells by grafting a NO-trapper o-phenylenediamine (OPD), via one of the amino groups of OPD, onto a rhodamine fluorophore at the C-3 position. The probe exhibited high selectivity and sensitivity towards NO with fast response in the water phase over a wide pH range. At the same time, the probe ROPD is cell-membrane permeable and can be used for the real-time visualization of exogenous NO in both L929 and HeLa cells, and endogenous NO in stressed RAW 264.7 cells.
- 1 May 2017
- Published by Elsevier in Thin Solid Films
- Vol. 629, 55-59
Dark current mechanisms and spectral response of SiO2-passivated photodiodes based on InAs/GaSb superlattice
- 1 May 2017
- Published by Elsevier in Thin Solid Films
- Vol. 629, 55-59
Dark current mechanisms and spectral response of SiO2-passivated photodiodes based on InAs/GaSb superlattice
- 1 February 2017
- Published by Elsevier in Dyes and Pigments
- Vol. 137, 50-57
Synthesis, characterization and photovoltaic properties of dithienobenzodithiophene-based conjugated polymers
- 1 February 2017
- Published by Elsevier in Dyes and Pigments
- Vol. 137, 50-57
Synthesis, characterization and photovoltaic properties of dithienobenzodithiophene-based conjugated polymers
- 1 August 2016
- Published by Elsevier in Organic Electronics
- Vol. 35, 53-58
High mobility multibit nonvolatile memory elements based organic field effect transistors with large hysteresis
- 1 August 2016
- Published by Elsevier in Organic Electronics
- Vol. 35, 53-58
High mobility multibit nonvolatile memory elements based organic field effect transistors with large hysteresis
- 30 April 2013
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 28 (6) , 065001
Catalyst and processing effects on metal-assisted chemical etching for the production of highly porous GaN
- 30 April 2013
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 28 (6) , 065001
Catalyst and processing effects on metal-assisted chemical etching for the production of highly porous GaN
- Open Access
- 19 March 2009
- Published by Wiley in Crystal Research and Technology
- Vol. 44 (4) , 433-439
Defect structure and spectroscopic characteristics of codoped Hf: Er: LiNbO3 crystals
- 19 March 2009
- Published by Wiley in Crystal Research and Technology
- Vol. 44 (4) , 433-439
Open AccessDefect structure and spectroscopic characteristics of codoped Hf: Er: LiNbO3 crystals
- 1 November 2007
- Published by Elsevier in Optical Materials
- Vol. 30 (3) , 492-496
Investigation on structure and photorefractive properties of Mg:Ce:Cu:LiNbO3 crystals with various [Li]/[Nb] ratios
- 1 November 2007
- Published by Elsevier in Optical Materials
- Vol. 30 (3) , 492-496
Investigation on structure and photorefractive properties of Mg:Ce:Cu:LiNbO3 crystals with various [Li]/[Nb] ratios
- 1 July 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (13) , 3339-3345
Influence of BaTiO3 on damping and dielectric properties of filled polyurethane/unsaturated polyester resin interpenetrating polymer networks
- 1 July 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (13) , 3339-3345
Influence of BaTiO3 on damping and dielectric properties of filled polyurethane/unsaturated polyester resin interpenetrating polymer networks