Christin Erniati Panjaitan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Christin Erniati Panjaitan has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Muhammad Irwanto
Universitas Prima Indonesia
2 shared publications - Baharuddin Ismail
Centre of Excellence for Renewable Energy, Universiti Malaysia Perlis, Pauh Putra Campus, 02600 Arau, Perlis, Malaysia
1 shared publication - Habib Satria
Universitas Medan Area
1 shared publication - Haniza Yazid
Universiti Malaysia Perlis
1 shared publication - Mahdi Syukri
Universitas Syiah Kuala
1 shared publication - Togar Timoteus Gultom1 shared publication
Latest Publications
- 2 September 2026
- Published by Springer Nature
- p. 299-307
Enhancing Breast Cancer Detection in Ultrasound Images Using CNN and Spatial Filtering
- 2 September 2026
- Published by Springer Nature
- p. 299-307
Enhancing Breast Cancer Detection in Ultrasound Images Using CNN and Spatial Filtering
- Open Access
- 1 December 2025
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 14 (6) , 4174-4188
Parameter tuning of PIDG controller on maximum photovoltaic power point for battery charging system
Maximum photovoltaic power point (MPVPP) based on DC-DC buck converter is supplied by photovoltaic module. A controller method is needed to control the signal that it drives the switching component of DC-DC buck converter. The previous researcher conducts proportional integral derivative (PID) controller applying the DC-DC buck converter, but only its parameters (proportional, KP, integral, KI, and derivative, KD) are studied. This paper presents MPVPP based on PID with gain (PIDG) controller on the DC-DC buck converter by tuning the parameters of KP. KI and KD and adding a gain, G connected to PIDG controller for charging 12 V, 7 Ah battery. The DC-DC buck converter is designed for the output voltage of 14.7 V and output power of 150 W and modelled using Simulink MATLAB. The simulation results show that the parameters of KP=0.0032, KI=1, and KD=4×10-7 are suitable to control the switching component. The gain, G gives significant effect on the settling time and the time to reach their steady state value of output voltage of 14.7 V. The battery SOC can increase 1.36% per second, if the initial SOC is 25%, thus it needs arround 55 seconds to reach the fully charging condition.
- 1 December 2025
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 14 (6) , 4174-4188
Open AccessParameter tuning of PIDG controller on maximum photovoltaic power point for battery charging system
Maximum photovoltaic power point (MPVPP) based on DC-DC buck converter is supplied by photovoltaic module. A controller method is needed to control the signal that it drives the switching component of DC-DC buck converter. The previous researcher conducts proportional integral derivative (PID) controller applying the DC-DC buck converter, but only its parameters (proportional, KP, integral, KI, and derivative, KD) are studied. This paper presents MPVPP based on PID with gain (PIDG) controller on the DC-DC buck converter by tuning the parameters of KP. KI and KD and adding a gain, G connected to PIDG controller for charging 12 V, 7 Ah battery. The DC-DC buck converter is designed for the output voltage of 14.7 V and output power of 150 W and modelled using Simulink MATLAB. The simulation results show that the parameters of KP=0.0032, KI=1, and KD=4×10-7 are suitable to control the switching component. The gain, G gives significant effect on the settling time and the time to reach their steady state value of output voltage of 14.7 V. The battery SOC can increase 1.36% per second, if the initial SOC is 25%, thus it needs arround 55 seconds to reach the fully charging condition.