Lele Liu

This study investigates the influence of varying positive–negative polarity ratios (EP:EN) on melt pool evolution during alternating current CMT (VP-CMT) arc additive manufacturing through a combined experimental and numerical approach. A multi-layer single-track droplet-melt pool coupling model was established, revealing the regulatory mechanisms governing melt pool flow, temperature distribution, and dimensional changes. These are driven by differences in arc morphology, heat input, and mechanical forces during EP and EN phases. Results indicate that molten pool flow is primarily governed by wire feed, retraction, and Marangoni forces. During the EP phase, arc divergence and elevated heat input result in significantly higher flow velocities than in the EN phase. Molten pool length increases with rising EP proportion, exhibiting periodic dynamic variations. Lateral flow intensity intensifies as EP ratio increases, directly influencing cladding layer morphology. This study provides theoretical basis for optimising additive manufacturing quality by adjusting the EP:EN ratio.

In this study, simulations and analyses of arc characteristics in EP (positive polarity) and EN (negative polarity) stages (including the arc polarity transition stage) of variable polarity cold metal transition (VP-CMT) during arc additive manufacturing of aluminum alloys are carried out. Temperature field, potential field, and current density distribution of arc plasma at different stages are systematically investigated by establishing a numerical model of arc heat–force coupling in combination with single-layer single-pass additive manufacturing experiments. The results indicate that the arc’s high-temperature zone in EP stage shows the wider distribution range, with enhanced heat transfer efficiency, reaching a surface temperature of up to 11,555.8 K at 2 mm from the substrate. In contrast, the arc during the EN stage demonstrates a more concentrated high-temperature zone, attributed to a more pronounced electromagnetic contraction effect, resulting in reduced heat input and a lower peak substrate temperature in comparison with EP stage. As revealed by analysis of potential and current density distribution, the arc in EP stage shows the “bell-shaped” expansion pattern with widely distributed current density, whereas the EN stage arc displays a “wrapped” contraction pattern with a more concentrated current density. The transition from EN to EP stage exhibits greater arc stability than the reverse transition. Moreover, electrode spacing significantly influences arc characteristics; a reduction in spacing leads to a more focused high-temperature zone and a substantial increase in peak current density. This study elucidates the dynamic variations in heat transfer behavior between the EP and EN stages, offering a theoretical foundation for optimizing process parameters in aluminum alloy arc additive manufacturing.