Alina Mary Varghese
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alina Mary Varghese has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Adil Fayaz
Indian Institute of Science
1 shared publication - Anna Kauffman
Department of Chemical, Paper, and Biomedical Engineering, Miami University, Oxford, OH 45056, USA
1 shared publication - Anne C. Co
Department of Chemistry and Biochemistry, The Ohio State University, Columbus, USA
1 shared publication Anyuan Gao
Department of Chemistry and Chemical Biology
1 shared publication- Brooke Moon
Department of Chemical, Paper, and Biomedical Engineering, Miami University, Oxford, OH 45056, USA
1 shared publication - Catherine B. Almquist
Department of Chemical, Paper, and Biomedical Engineering, Miami University, Oxford, OH 45056, USA
1 shared publication
Latest Publications
- 2 November 2026
- Published by Springer Nature in Nature Chemistry
- p. 1-8
Thermochemical adsorption at high overpotentials limits molecular CO-to-methanol electroreduction
Electrocatalysis modulates interfacial charge-transfer kinetics through potential control. However, it remains unclear how thermochemical steps, such as adsorption, dictate these overall kinetics. Here we determine CO-reduction limiting currents by measuring CO-oxidation limiting currents, allowing mass-transport effects to be deconvoluted from the CO-reduction kinetics. Using CO-to-methanol conversion on molecular catalysts as a model system, we show that while the reaction rate is limited by an electrochemical step at low overpotentials, the thermochemical CO adsorption step becomes rate limiting at high overpotentials. Cation-dependent variations in CO adsorption energies and activation energies align with the Brønsted–Evans–Polanyi principle, establishing CO adsorption energy as a robust kinetic descriptor. We further demonstrate that cobalt phthalocyanine supported on carbon nanotubes enables appreciable CO-to-methanol conversion due to its enhanced CO adsorption compared to other metal phthalocyanines. Ultimately, these findings illuminate an inherent thermochemical constraint on electrolysis and provide a kinetic framework to identify when such limitations become rate determining.
- 2 November 2026
- Published by Springer Nature in Nature Chemistry
- p. 1-8
Thermochemical adsorption at high overpotentials limits molecular CO-to-methanol electroreduction
Electrocatalysis modulates interfacial charge-transfer kinetics through potential control. However, it remains unclear how thermochemical steps, such as adsorption, dictate these overall kinetics. Here we determine CO-reduction limiting currents by measuring CO-oxidation limiting currents, allowing mass-transport effects to be deconvoluted from the CO-reduction kinetics. Using CO-to-methanol conversion on molecular catalysts as a model system, we show that while the reaction rate is limited by an electrochemical step at low overpotentials, the thermochemical CO adsorption step becomes rate limiting at high overpotentials. Cation-dependent variations in CO adsorption energies and activation energies align with the Brønsted–Evans–Polanyi principle, establishing CO adsorption energy as a robust kinetic descriptor. We further demonstrate that cobalt phthalocyanine supported on carbon nanotubes enables appreciable CO-to-methanol conversion due to its enhanced CO adsorption compared to other metal phthalocyanines. Ultimately, these findings illuminate an inherent thermochemical constraint on electrolysis and provide a kinetic framework to identify when such limitations become rate determining.
- Open Access
Room-Temperature Catalytic and Photocatalytic Oxidation of CO over Pt/TiO2 Catalysts in an LED-Based Flow Reactor: Effects of Pt Loading and Oxidation State
The build-up of carbon monoxide (CO) in confined spaces can pose serious risks to human health. One method of mitigating CO in air is catalytic oxidation. Low-temperature catalytic oxidation of CO is desirable to enhance energy efficiency and sustainability. Noble metal catalysts have been shown to be active catalysts for CO oxidation at low temperatures. In addition, photocatalysis has been demonstrated as a method to degrade harmful gas-phase compounds into less toxic ones at room temperature. In this study, the effects of platinum (Pt) loading and oxidation state on a TiO2 (P25) support were investigated in a light-emitting diode (LED)-based flow reactor for the room-temperature catalytic and photocatalytic oxidation of CO in air. It was found that the catalytic activity increased with Pt loading up to 5 wt%, and catalytic activity was significantly higher when the Pt was reduced (Pt0) on the catalyst compared to oxidized platinum (Pt2+, Pt4+). Visible light absorption increased with increasing platinum loading on TiO2, and the catalyst activity for room-temperature CO oxidation increased with exposure to both ultraviolet (UVA) and visible light. Platinum is responsible for the adsorption of CO and the activation of adsorbed oxygen and CO, and it interacts with the photogenerated electrons upon exposure to light to enhance the photocatalytic activity of Pt/TiO2 catalysts for the room-temperature oxidation of CO.
Open AccessRoom-Temperature Catalytic and Photocatalytic Oxidation of CO over Pt/TiO2 Catalysts in an LED-Based Flow Reactor: Effects of Pt Loading and Oxidation State
The build-up of carbon monoxide (CO) in confined spaces can pose serious risks to human health. One method of mitigating CO in air is catalytic oxidation. Low-temperature catalytic oxidation of CO is desirable to enhance energy efficiency and sustainability. Noble metal catalysts have been shown to be active catalysts for CO oxidation at low temperatures. In addition, photocatalysis has been demonstrated as a method to degrade harmful gas-phase compounds into less toxic ones at room temperature. In this study, the effects of platinum (Pt) loading and oxidation state on a TiO2 (P25) support were investigated in a light-emitting diode (LED)-based flow reactor for the room-temperature catalytic and photocatalytic oxidation of CO in air. It was found that the catalytic activity increased with Pt loading up to 5 wt%, and catalytic activity was significantly higher when the Pt was reduced (Pt0) on the catalyst compared to oxidized platinum (Pt2+, Pt4+). Visible light absorption increased with increasing platinum loading on TiO2, and the catalyst activity for room-temperature CO oxidation increased with exposure to both ultraviolet (UVA) and visible light. Platinum is responsible for the adsorption of CO and the activation of adsorbed oxygen and CO, and it interacts with the photogenerated electrons upon exposure to light to enhance the photocatalytic activity of Pt/TiO2 catalysts for the room-temperature oxidation of CO.
- 9 February 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (4) , 2172-2183
Two-Dimensional BiPS 4 -Derived Catalyst for the Selective Electroreduction of CO 2 : The Synergistic Effect of Phosphorus and Sulfur along with Bismuth
- 9 February 2026
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 9 (4) , 2172-2183
Two-Dimensional BiPS 4 -Derived Catalyst for the Selective Electroreduction of CO 2 : The Synergistic Effect of Phosphorus and Sulfur along with Bismuth
- 5 December 2025
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 25 (50) , 17475-17484
Water-Assisted Concerted Layer Growth of T d -Phase WTe 2 for Nonlinear Hall Effect and Microwave Rectification
The Td phase of tungsten ditelluride (WTe2), a noncentrosymmetric transition metal dichalcogenide, hosts rich correlated phenomena, topological states, and nonlinear transport responses. However, the scalable synthesis of high-quality few-layer WTe2 with precise layer control remains challenging. Here, we report a water-assisted chemical vapor deposition approach that deterministically grows monolayer to trilayer Td-WTe2 with controlled flake size and density. Moisture-mediated precursor liquefaction through salt-assisted intermediates enables vapor-liquid-solid growth and tunable layer numbers through a concerted layer growth mode. Transport studies reveal that trilayer WTe2 exhibits a nonlinear Hall effect susceptibility of 1.1 μm·V-1 at 10 K and 0.5 μm·V-1 at 50 K, nearly an order of magnitude higher than that in bilayers, consistent with the calculated Berry curvature dipole enhancement. Layer-dependent microwave rectification further highlights the influence of topological band structure and interlayer coupling. These results establish layer-engineered Td-WTe2 as a promising platform for nonlinear quantum transport and high-frequency optoelectronic applications.
- 5 December 2025
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 25 (50) , 17475-17484
Water-Assisted Concerted Layer Growth of T d -Phase WTe 2 for Nonlinear Hall Effect and Microwave Rectification
The Td phase of tungsten ditelluride (WTe2), a noncentrosymmetric transition metal dichalcogenide, hosts rich correlated phenomena, topological states, and nonlinear transport responses. However, the scalable synthesis of high-quality few-layer WTe2 with precise layer control remains challenging. Here, we report a water-assisted chemical vapor deposition approach that deterministically grows monolayer to trilayer Td-WTe2 with controlled flake size and density. Moisture-mediated precursor liquefaction through salt-assisted intermediates enables vapor-liquid-solid growth and tunable layer numbers through a concerted layer growth mode. Transport studies reveal that trilayer WTe2 exhibits a nonlinear Hall effect susceptibility of 1.1 μm·V-1 at 10 K and 0.5 μm·V-1 at 50 K, nearly an order of magnitude higher than that in bilayers, consistent with the calculated Berry curvature dipole enhancement. Layer-dependent microwave rectification further highlights the influence of topological band structure and interlayer coupling. These results establish layer-engineered Td-WTe2 as a promising platform for nonlinear quantum transport and high-frequency optoelectronic applications.