Rinat Ilesibekov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rinat Ilesibekov has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Aigerim Issimova
Department of Electronics and Astrophysics, Al-Farabi Kazakh National University, Almaty, Kazakhstan, Kazakhstan
1 shared publication - Bekbolat Medetov
Faculty of Physics and Engineering, Department of Radio Engineering, Electronics and Telecommunications, Gumilyov Eurasian National University, Satpayev 2, Astana 010008, Kazakhstan
1 shared publication - Elvira Kadylbekkyzy
Department of Telecommunication Engineering, Almaty University of Power Engineering and Telecommunications, Baitursynuly Street 126/1, Almaty 050013, Kazakhstan
1 shared publication - Madina Alimova
Department of Telecommunication Engineering, Almaty University of Power Engineering and Telecommunications, Baitursynuly Street 126/1, Almaty 050013, Kazakhstan
1 shared publication - Nurtay Albanbay
Institute of Automation and Information Technologies, Satbayev University, Almaty, Kazakhstan, Kazakhstan
1 shared publication
Latest Publications
- Open Access
- 13 December 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (12) , 1404
Optimizing Magnet Spacing to Enhance Power and Energy Density in Magnetically Levitated Electromagnetic Vibration Energy Harvesters
In this study, we investigate a magnetically levitated electromagnetic vibration energy harvester (EMEH), in which a movable permanent magnet levitates between two fixed magnets with like poles facing the central magnet. We develop a nonlinear EMEH model and validate it experimentally, achieving strong agreement with the prototype (R2 = 0.95 for RMS EMF). Using this model, we perform a parametric analysis of excitation frequency and the spacing between the fixed magnets (d), yielding practical design criteria for geometry selection. The validated model predicts a narrow maximum; for the present configuration and parameter bounds, it occurs at d ≈ 28 mm with Pout ≈ 151.94 mW, and the corresponding energy density is ρE ≈ 9.84 mW cm−3. These results yield a practical design rule for selecting d given target metrics and dimensional constraints, providing guidance for the design of compact, low-frequency harvesters powering autonomous sensor nodes.
- 13 December 2025
- Published by MDPI AG in Micromachines
- Vol. 16 (12) , 1404
Open AccessOptimizing Magnet Spacing to Enhance Power and Energy Density in Magnetically Levitated Electromagnetic Vibration Energy Harvesters
In this study, we investigate a magnetically levitated electromagnetic vibration energy harvester (EMEH), in which a movable permanent magnet levitates between two fixed magnets with like poles facing the central magnet. We develop a nonlinear EMEH model and validate it experimentally, achieving strong agreement with the prototype (R2 = 0.95 for RMS EMF). Using this model, we perform a parametric analysis of excitation frequency and the spacing between the fixed magnets (d), yielding practical design criteria for geometry selection. The validated model predicts a narrow maximum; for the present configuration and parameter bounds, it occurs at d ≈ 28 mm with Pout ≈ 151.94 mW, and the corresponding energy density is ρE ≈ 9.84 mW cm−3. These results yield a practical design rule for selecting d given target metrics and dimensional constraints, providing guidance for the design of compact, low-frequency harvesters powering autonomous sensor nodes.