Yichen Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Yichen Yang has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Olivier N. Pierron
George W. Woodruff School of Mechanical Engineering Georgia Institute of Technology Atlanta Georgia USA
8 shared publications - Ting Zhu
Georgia Institute of Technology
5 shared publications - Josh Kacher
School of Materials Science and Engineering, Georgia Institute of Technology, Atlanta, USA
4 shared publications Kunqing Ding
4 shared publicationsAlejandro Barrios
3 shared publications- Kyle Rhys Dorman
Sandia National Laboratories (SNL-NM), Albuquerque, NM (United States)
3 shared publications
Latest Publications
- 13 November 2026
- Published by Wiley in Advanced Materials
Gigacycle Fatigue Resistance and Cyclic Phase Separation in Metastable Nanocrystalline Cu–Ag Alloy Thin Films
Nanocrystalline metals derive their exceptional strength from a high density of grain boundaries (GBs), but under cyclic loading those same boundaries are unstable, driving abnormal grain growth that seeds fatigue cracking. Solute‐mediated grain boundary stabilization is shown here to extend nanocrystalline fatigue life by orders of magnitude. A metastable nanocrystalline Cu–42 at.% Ag alloy thin film survives 1.2 billion cycles at strain amplitudes exceeding 1.1%. To our knowledge, no other metallic thin film has shown gigacycle fatigue resistance at such extreme strain amplitudes, while comparison with literature data requires care given differences in testing conditions. A combination of microresonator‐based very‐high‐cycle fatigue testing, electron microscopy, and atomistic simulations reveals a composition‐dependent transition in the governing mechanism. In dilute Cu–3Ag, solute clusters kinetically pin interfacial disconnections and slow boundary migration, extending fatigue life but not preventing eventual failure via abnormal grain growth. In contrast, concentrated Cu–42Ag exhibits stable grain boundaries for over a billion cycles. Fatigue damage is ultimately associated with a previously unreported fatigue‐induced phase separation: strain‐enhanced transport decomposes the metastable solid solution into semi‐coherent Cu‐ and Ag‐rich domains. Solute‐stabilized nanocrystalline alloy thin films thus offer a route to gigacycle fatigue resistance in microdevices, and cyclic phase separation emerges as a distinct damage mode.
- 13 November 2026
- Published by Wiley in Advanced Materials
Gigacycle Fatigue Resistance and Cyclic Phase Separation in Metastable Nanocrystalline Cu–Ag Alloy Thin Films
Nanocrystalline metals derive their exceptional strength from a high density of grain boundaries (GBs), but under cyclic loading those same boundaries are unstable, driving abnormal grain growth that seeds fatigue cracking. Solute‐mediated grain boundary stabilization is shown here to extend nanocrystalline fatigue life by orders of magnitude. A metastable nanocrystalline Cu–42 at.% Ag alloy thin film survives 1.2 billion cycles at strain amplitudes exceeding 1.1%. To our knowledge, no other metallic thin film has shown gigacycle fatigue resistance at such extreme strain amplitudes, while comparison with literature data requires care given differences in testing conditions. A combination of microresonator‐based very‐high‐cycle fatigue testing, electron microscopy, and atomistic simulations reveals a composition‐dependent transition in the governing mechanism. In dilute Cu–3Ag, solute clusters kinetically pin interfacial disconnections and slow boundary migration, extending fatigue life but not preventing eventual failure via abnormal grain growth. In contrast, concentrated Cu–42Ag exhibits stable grain boundaries for over a billion cycles. Fatigue damage is ultimately associated with a previously unreported fatigue‐induced phase separation: strain‐enhanced transport decomposes the metastable solid solution into semi‐coherent Cu‐ and Ag‐rich domains. Solute‐stabilized nanocrystalline alloy thin films thus offer a route to gigacycle fatigue resistance in microdevices, and cyclic phase separation emerges as a distinct damage mode.
- Open Access
- 7 November 2026
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 219
Phase-field modeling of elastically driven abnormal grain growth
- 7 November 2026
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 219
Open AccessPhase-field modeling of elastically driven abnormal grain growth
- 9 September 2026
- Published by Elsevier in Journal of the Mechanical Behavior of Biomedical Materials
- Vol. 184
Rotational impact orientation effects traumatic brain injury severity, a biomimetic study
- 9 September 2026
- Published by Elsevier in Journal of the Mechanical Behavior of Biomedical Materials
- Vol. 184
Rotational impact orientation effects traumatic brain injury severity, a biomimetic study
- 8 September 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (5)
NLSTEM: Nonlocal Denoising for Enhanced 4D-STEM Pattern Indexing
4D-STEM-based orientation and phase mapping has enabled rapid microstructure quantification that can be directly combined with standard TEM- and STEM-based imaging modes. Typically, orientation mapping is coupled with beam precession (i.e., precession electron diffraction) to achieve high indexing rates, adding to the cost and often decreasing the spatial resolution of the approach. This paper introduces a new postprocessing approach modeled after the nonlocal pattern averaging and reindexing algorithm developed for the electron backscatter diffraction community, wherein postcollection patterns are averaged using a distance similarity parameter. Results from Ni and Au thin films show that indexing rates can be significantly improved using this postprocessing technique due to improved signal-to-noise ratios in the diffraction patterns. Interestingly, the highest indexing rates are achieved in samples heavily damaged via ion irradiation, suggesting that averaging over curved lattices further improves indexing rates. The source code is made freely available at https://github.com/USNavalResearchLaboratory/PyEBSDIndex.
- 8 September 2026
- Published by Oxford University Press (OUP) in Microscopy and Microanalysis
- Vol. 32 (5)
NLSTEM: Nonlocal Denoising for Enhanced 4D-STEM Pattern Indexing
4D-STEM-based orientation and phase mapping has enabled rapid microstructure quantification that can be directly combined with standard TEM- and STEM-based imaging modes. Typically, orientation mapping is coupled with beam precession (i.e., precession electron diffraction) to achieve high indexing rates, adding to the cost and often decreasing the spatial resolution of the approach. This paper introduces a new postprocessing approach modeled after the nonlocal pattern averaging and reindexing algorithm developed for the electron backscatter diffraction community, wherein postcollection patterns are averaged using a distance similarity parameter. Results from Ni and Au thin films show that indexing rates can be significantly improved using this postprocessing technique due to improved signal-to-noise ratios in the diffraction patterns. Interestingly, the highest indexing rates are achieved in samples heavily damaged via ion irradiation, suggesting that averaging over curved lattices further improves indexing rates. The source code is made freely available at https://github.com/USNavalResearchLaboratory/PyEBSDIndex.
- Open Access
- 7 September 2026
- Published by Elsevier in Acta Materialia
- Vol. 321
Grain boundary stability dictates the rate-limiting deformation process in nanocrystalline metals
- 7 September 2026
- Published by Elsevier in Acta Materialia
- Vol. 321
Open AccessGrain boundary stability dictates the rate-limiting deformation process in nanocrystalline metals
- Open Access
- 2 May 2026
- Published by Elsevier in Acta Materialia
- Vol. 313
Decoupling the effects of temperature and stress on grain growth in nanocrystalline Ni films
- 2 May 2026
- Published by Elsevier in Acta Materialia
- Vol. 313
Open AccessDecoupling the effects of temperature and stress on grain growth in nanocrystalline Ni films
- Open Access
- 30 April 2026
- Published by Elsevier in Acta Materialia
- Vol. 313
Elucidating the origins of grain growth in the high cycle fatigue degradation of Au thin films
- 30 April 2026
- Published by Elsevier in Acta Materialia
- Vol. 313
Open AccessElucidating the origins of grain growth in the high cycle fatigue degradation of Au thin films
- Open Access
- 29 January 2026
- Published by Elsevier in Materials Today
- Vol. 93
Putting fatigue to rest via solute-pinned boundaries
- 29 January 2026
- Published by Elsevier in Materials Today
- Vol. 93
Open AccessPutting fatigue to rest via solute-pinned boundaries
- Open Access
- 15 January 2026
- Published by Elsevier in Scripta Materialia
- Vol. 275
The role of grain size distribution on the anomalous yielding of ultrafine-grained Au thin films
- 15 January 2026
- Published by Elsevier in Scripta Materialia
- Vol. 275
Open AccessThe role of grain size distribution on the anomalous yielding of ultrafine-grained Au thin films
- Open Access
- 23 December 2025
- Published by Elsevier in Acta Materialia
- Vol. 306
In situ TEM measurement of strain rate-dependent activation volume of ultrafine-grained Au films
- 23 December 2025
- Published by Elsevier in Acta Materialia
- Vol. 306
Open AccessIn situ TEM measurement of strain rate-dependent activation volume of ultrafine-grained Au films