Hilal Aybüke Yıldız
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hilal Aybüke Yıldız has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Mert Ersan
Department of Plastic, Reconstructive and Aesthetic Surgery, Yeditepe University, Istanbul, Turkey
4 shared publications Begüm Bengisu Bozkurt
1 shared publication- Begüm Kolcu
Department of Plastic, Reconstructive and Aesthetic Surgery, Şanlıurfa Mehmet Akif İnan Training and Research Hospital, University of Health Sciences
1 shared publication - Cihan Dural
Hamidiye International School of Medicine, University of Health Sciences, Istanbul, TR
1 shared publication - Ece Belen Türkkan
İstanbul Profesör Dr. Cemil Taşçıoğlu Şehir Hastanesi, Plastik, Rekonstrüktif ve Estetik Cerrahi Departmanı
1 shared publication - Efe Yavuz
Department of Plastic, Reconstructive and Aesthetic Surgery, Yeditepe University Faculty of Medicine, İstanbul, Türkiye
1 shared publication
Latest Publications
- 30 September 2026
- Published by Ankara University in Ankara Üniversitesi Tıp Fakültesi Mecmuası
- Vol. 79 (3) , 276-283
Anthropometric Analysis Supported by Digital Simulation in Turkish Rhinoplasty Patients
Objective: Three-dimensional (3D) simulation analyses used to evaluate nasal morphology support the surgeon’s visual assessment using digital measurements. This study aimed to perform a 3D simulation-supported anthropometric analysis of nasal structures in Turkish patients presenting for rhinoplasty, compare the obtained data with established aesthetic norms, and examine correlations between nasal anthropometric measurements.Materials and Methods: A total of 315 patients (257 females, 58 males) aged 18–65 years who presented for primary rhinoplasty were included. Interpupillary distances were measured manually and integrated into the Crisalix (Crisalix SA, Switzerland) 3D simulation system. The nasofrontal angle, nasolabial angle, nasal bridge length, alar width, and nasal projection parameters were recorded and analyzed.Results: The mean interpupillary distance was 6.23 ± 0.18 cm in males and 6.10 ± 0.26 cm in females. The mean anthropometric values were 151.44° ± 6.27° for the nasofrontal angle, 111.89° ± 10.97° for the nasolabial angle, 4.53 ± 0.33 cm for nasal bridge length, 5.80 ± 0.41 cm for alar width, and 2.88 ± 0.29 cm for nasal projection. Nasal bridge length, alar width, and nasal projection were higher in males than in females, whereas no significant difference was found in angular measurements. Strong positive correlations were observed between the parameters.Conclusion: This study provides patient-centered three-dimensional anthropometric data for Turkish individuals seeking rhinoplasty. The use of 3D analysis systems may support traditional subjective and two-dimensional surgical assessments with objective digital measurements, thereby improving the predictability of preoperative planning and facilitating individualized, patient-centered approaches.
- 30 September 2026
- Published by Ankara University in Ankara Üniversitesi Tıp Fakültesi Mecmuası
- Vol. 79 (3) , 276-283
Anthropometric Analysis Supported by Digital Simulation in Turkish Rhinoplasty Patients
Objective: Three-dimensional (3D) simulation analyses used to evaluate nasal morphology support the surgeon’s visual assessment using digital measurements. This study aimed to perform a 3D simulation-supported anthropometric analysis of nasal structures in Turkish patients presenting for rhinoplasty, compare the obtained data with established aesthetic norms, and examine correlations between nasal anthropometric measurements.Materials and Methods: A total of 315 patients (257 females, 58 males) aged 18–65 years who presented for primary rhinoplasty were included. Interpupillary distances were measured manually and integrated into the Crisalix (Crisalix SA, Switzerland) 3D simulation system. The nasofrontal angle, nasolabial angle, nasal bridge length, alar width, and nasal projection parameters were recorded and analyzed.Results: The mean interpupillary distance was 6.23 ± 0.18 cm in males and 6.10 ± 0.26 cm in females. The mean anthropometric values were 151.44° ± 6.27° for the nasofrontal angle, 111.89° ± 10.97° for the nasolabial angle, 4.53 ± 0.33 cm for nasal bridge length, 5.80 ± 0.41 cm for alar width, and 2.88 ± 0.29 cm for nasal projection. Nasal bridge length, alar width, and nasal projection were higher in males than in females, whereas no significant difference was found in angular measurements. Strong positive correlations were observed between the parameters.Conclusion: This study provides patient-centered three-dimensional anthropometric data for Turkish individuals seeking rhinoplasty. The use of 3D analysis systems may support traditional subjective and two-dimensional surgical assessments with objective digital measurements, thereby improving the predictability of preoperative planning and facilitating individualized, patient-centered approaches.
- 23 February 2026
- Published by Vizetek Publishing Company
RİNOPLASTİ ARAŞTIRMA GÖREVLİLERİ İÇİN TEMEL RİNOPLASTİ
- 23 February 2026
- Published by Vizetek Publishing Company
RİNOPLASTİ ARAŞTIRMA GÖREVLİLERİ İÇİN TEMEL RİNOPLASTİ
- Top Cited PapersOpen Access
- 10 January 2026
- Published by Taylor & Francis in Computer Assisted Surgery
- Vol. 31 (1) , 2614532
The impact of three-dimensional simulation and virtual reality technologies on surgical decision-making and postoperative satisfaction in aesthetic surgery: a preliminary study
Three-dimensional (3D) simulation and virtual reality (VR) technologies are increasingly used in aesthetic surgery consultations to enhance decision-making and expectation management. However, their impact on surgical decision-making and postoperative satisfaction across different procedures remains unclear. This study aimed to evaluate the influence of 3D simulation and VR technology in patients undergoing rhinoplasty, breast augmentation, mastopexy, augmentation-mastopexy and breast reduction. A retrospective study was conducted with 75 female patients who underwent primary aesthetic surgery. Preoperative 3D simulations and VR visualizations were generated using the Crisalix Virtual Esthetics system (Crisalix S.A., Switzerland). Patients were assessed postoperatively at one year using structured surveys to evaluate the influence of 3D simulation and VR technology on their decision-making and satisfaction. Statistical analyses included the Kruskal-Wallis H test, the Chi-Square test, and Spearman's correlation. 3D simulation had the greatest influence on breast augmentation (8.4/10), rhinoplasty (7.6/10), and augmentation-mastopexy (7.1/10) patients but was less impactful for mastopexy (6.6/10) and breast reduction (3.8/10) patients (p < 0.001). The most decisive factors were previous patient photos (30.7%) and communication with the surgeon (29.3%), with simulation ranking third (18.7%). Postoperative similarity ratings were highest in breast augmentation (7.9/10) and rhinoplasty (7.5/10) patients. While 70.7% of patients would recommend 3D simulation, VR headset use did not influence decisions (p < 0.001). 3D simulation enhances patient engagement and expectation management across various aesthetic procedures. While its influence is more significant in surgeries primarily focused on aesthetic outcomes, it serves as a complementary tool rather than a definitive factor in decision-making.
- 10 January 2026
- Published by Taylor & Francis in Computer Assisted Surgery
- Vol. 31 (1) , 2614532
Top Cited PapersOpen AccessThe impact of three-dimensional simulation and virtual reality technologies on surgical decision-making and postoperative satisfaction in aesthetic surgery: a preliminary study
Three-dimensional (3D) simulation and virtual reality (VR) technologies are increasingly used in aesthetic surgery consultations to enhance decision-making and expectation management. However, their impact on surgical decision-making and postoperative satisfaction across different procedures remains unclear. This study aimed to evaluate the influence of 3D simulation and VR technology in patients undergoing rhinoplasty, breast augmentation, mastopexy, augmentation-mastopexy and breast reduction. A retrospective study was conducted with 75 female patients who underwent primary aesthetic surgery. Preoperative 3D simulations and VR visualizations were generated using the Crisalix Virtual Esthetics system (Crisalix S.A., Switzerland). Patients were assessed postoperatively at one year using structured surveys to evaluate the influence of 3D simulation and VR technology on their decision-making and satisfaction. Statistical analyses included the Kruskal-Wallis H test, the Chi-Square test, and Spearman's correlation. 3D simulation had the greatest influence on breast augmentation (8.4/10), rhinoplasty (7.6/10), and augmentation-mastopexy (7.1/10) patients but was less impactful for mastopexy (6.6/10) and breast reduction (3.8/10) patients (p < 0.001). The most decisive factors were previous patient photos (30.7%) and communication with the surgeon (29.3%), with simulation ranking third (18.7%). Postoperative similarity ratings were highest in breast augmentation (7.9/10) and rhinoplasty (7.5/10) patients. While 70.7% of patients would recommend 3D simulation, VR headset use did not influence decisions (p < 0.001). 3D simulation enhances patient engagement and expectation management across various aesthetic procedures. While its influence is more significant in surgeries primarily focused on aesthetic outcomes, it serves as a complementary tool rather than a definitive factor in decision-making.
- Open Access
- 25 December 2025
- Published by Galenos Yayinevi in European Journal of Breast Health
- Vol. 22 (1) , 72-77
Detection of the Superior Perforator with Doppler Ultrasonography in Superomedial Pedicle Reduction Mammaplasty: A Retrospective Evaluation of Vascular Safety
The superomedial pedicle technique combines aesthetic advantages with reliable vascularity in reduction mammaplasty. This study evaluated the safety and clinical outcomes of Doppler ultrasonography-guided identification of the superior perforator in the superomedial pedicle design. This retrospective study included 22 female patients who underwent bilateral superomedial pedicle reduction mammaplasty between April 2023 and April 2025. In all patients, the superior perforator was detected preoperatively using a portable handheld Doppler ultrasonography device and was incorporated into the pedicle design. All patients underwent surgery via an inverted-T pattern with the superomedial pedicle. The mean follow-up period was 1.2 years. The superior perforator was identified in all patients (mean time: 3.0±0.4 minutes). No partial or total necrosis of the nipple-areola complex was observed in any patient. Wound dehiscence occurred at the T-incision site in four patients, transient areolar hypoesthesia was observed in three patients, and hypertrophic scarring developed in one patient. Aesthetic outcomes were evaluated in all patients by physical examination and standardized photography. Detection of the superior perforator with Doppler ultrasonography enables individualized planning of the superomedial pedicle and enhances vascular safety. This approach provides a feasible, individualized, and reliable surgical technique for reduction mammaplasty, thereby reducing complication rates.
- 25 December 2025
- Published by Galenos Yayinevi in European Journal of Breast Health
- Vol. 22 (1) , 72-77
Open AccessDetection of the Superior Perforator with Doppler Ultrasonography in Superomedial Pedicle Reduction Mammaplasty: A Retrospective Evaluation of Vascular Safety
The superomedial pedicle technique combines aesthetic advantages with reliable vascularity in reduction mammaplasty. This study evaluated the safety and clinical outcomes of Doppler ultrasonography-guided identification of the superior perforator in the superomedial pedicle design. This retrospective study included 22 female patients who underwent bilateral superomedial pedicle reduction mammaplasty between April 2023 and April 2025. In all patients, the superior perforator was detected preoperatively using a portable handheld Doppler ultrasonography device and was incorporated into the pedicle design. All patients underwent surgery via an inverted-T pattern with the superomedial pedicle. The mean follow-up period was 1.2 years. The superior perforator was identified in all patients (mean time: 3.0±0.4 minutes). No partial or total necrosis of the nipple-areola complex was observed in any patient. Wound dehiscence occurred at the T-incision site in four patients, transient areolar hypoesthesia was observed in three patients, and hypertrophic scarring developed in one patient. Aesthetic outcomes were evaluated in all patients by physical examination and standardized photography. Detection of the superior perforator with Doppler ultrasonography enables individualized planning of the superomedial pedicle and enhances vascular safety. This approach provides a feasible, individualized, and reliable surgical technique for reduction mammaplasty, thereby reducing complication rates.