Alexandru Dalin Drăgoi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Alexandru Dalin Drăgoi has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Ioan Lie
Politehnica University Timisoara,Applied Electronics Department,Timisoara,Romania
1 shared publication- Ioan Lie
Applied Electronics Department, Politehnica University Timișoara, 300 223 Timișoara, Romania
1 shared publication - Mihai Vasile Popescu
Applied Electronics Department, Faculty of Electronics, Telecommunications and Information Technologies, Politehnica University Timișoara, 300223 Timișoara, Romania
1 shared publication Septimiu Lica
Politehnica University Timisoara,Applied Electronics Department,Timisoara,Romania
1 shared publication- Septimiu Lica
Applied Electronics Department, Politehnica University Timisoara, 300006 Timisoara, Romania
1 shared publication
Latest Publications
- Open Access
High Voltage Flyback Converter for Safety Indicators in Electrical Testing Laboratories
High voltage (HV) test environments require dependable visual status indicators to maintain operator safety; however, directly supplying these indicators from HV sources introduces substantial electrical and operational hazards. This work addresses these challenges through the design and implementation of a compact Flyback DC–DC converter that provides galvanic isolation and a stable low-power output specifically intended for LED-based safety beacons. While utilizing Discontinuous Conduction Mode (DCM) and valley-switching to minimize thermal stress, the primary innovation of this design lies in the rigorous optimization of the isolation barrier and PCB architecture to meet HV safety standards (such as IEC 60950-1) within a minimal physical footprint. Transformer parameters were determined using analytical design procedures and subsequently verified by circuit-level simulations, which confirmed correct DCM operation as well as rapid startup behavior without output overshoot. A two-layer PCB was designed in accordance with IPC-2221B standard, with particular emphasis on minimizing parasitic effects and thereby improving overall performance. Experimental characterization demonstrated stable output regulation and a strong correlation between measured and simulated waveforms. The proposed system enhances safety in HV laboratory settings while achieving a compact form factor and supporting a wide input voltage range.
Open AccessHigh Voltage Flyback Converter for Safety Indicators in Electrical Testing Laboratories
High voltage (HV) test environments require dependable visual status indicators to maintain operator safety; however, directly supplying these indicators from HV sources introduces substantial electrical and operational hazards. This work addresses these challenges through the design and implementation of a compact Flyback DC–DC converter that provides galvanic isolation and a stable low-power output specifically intended for LED-based safety beacons. While utilizing Discontinuous Conduction Mode (DCM) and valley-switching to minimize thermal stress, the primary innovation of this design lies in the rigorous optimization of the isolation barrier and PCB architecture to meet HV safety standards (such as IEC 60950-1) within a minimal physical footprint. Transformer parameters were determined using analytical design procedures and subsequently verified by circuit-level simulations, which confirmed correct DCM operation as well as rapid startup behavior without output overshoot. A two-layer PCB was designed in accordance with IPC-2221B standard, with particular emphasis on minimizing parasitic effects and thereby improving overall performance. Experimental characterization demonstrated stable output regulation and a strong correlation between measured and simulated waveforms. The proposed system enhances safety in HV laboratory settings while achieving a compact form factor and supporting a wide input voltage range.
- 7 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
High Voltage DC-DC Converter for Safety Beacons
- 7 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
High Voltage DC-DC Converter for Safety Beacons