Alan Sulato De Andrade
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Alan Sulato De Andrade has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Alexandre Behling
UFPR
1 shared publication - Alexandre Behling
ForestEyes Research Group, Department of Forest Sciences, Federal University of Paraná, Curitiba 80210-170, PR, Brazil
1 shared publication - Ana Paula Dalla Corte
Universidade Federal do Paraná
1 shared publication - André Simon De Oliveira1 shared publication
- Carla Talita Pertille
ForestEyes Research Group, Department of Forest Sciences, Federal University of Paraná, Curitiba 80210-170, PR, Brazil
1 shared publication - Carlos Roberto Sanquetta
BIOFIX Research Center, Federal University of Parana, Curitiba, Brazil
1 shared publication
Latest Publications
- Open Access
Quantitative Structure Modeling of Excavated Stump-Root Systems from Terrestrial Laser Scanning Point Clouds: Formulation and Destructive Validation in Pinus taeda
Belowground biomass (BGB) is an important component of forest carbon stocks but remains poorly quantified owing to the difficulty of measuring it directly. This study evaluated terrestrial laser scanning (TLS) combined with quantitative structure models (QSM) to estimate root volume, biomass and carbon in Pinus taeda. Twelve root systems were excavated, washed, weighed and scanned, then reconstructed using a TreeQSM formulation adapted for stump-root systems. Volume was converted to biomass using mean and diameter class-specific basic density, and to carbon using measured carbon contents. QSM-derived volume showed weak-to-moderate agreement with measured volume (A = 0.6292; CC1 = 0.3916; d = 0.6692), with a systematic underestimation of 43.6%. BGB estimates using mean density showed comparable agreement (A = 0.7339; bias 37.9%), while diameter class-specific densities slightly reduced it (A = 0.7126; bias 40.7%). Basic density was lowest in the finest and highest in the coarsest class (0.224–0.298 g·cm−3), whereas carbon content varied only slightly among classes (43.73–44.62%). Belowground carbon showed agreement comparable to BGB and higher than volume (A = 0.7093–0.7308; bias 37.9–40.7%), with no gain from class-specific carbon contents. A single mean density was sufficient to estimate BGB. This simplification is appropriate as long as the error in volume estimation is greater than the error introduced by using a mean density, but this may change as reconstruction methods improve. In addition, the method requires root systems to be excavated and does not allow the assessment of roots in situ.
Open AccessQuantitative Structure Modeling of Excavated Stump-Root Systems from Terrestrial Laser Scanning Point Clouds: Formulation and Destructive Validation in Pinus taeda
Belowground biomass (BGB) is an important component of forest carbon stocks but remains poorly quantified owing to the difficulty of measuring it directly. This study evaluated terrestrial laser scanning (TLS) combined with quantitative structure models (QSM) to estimate root volume, biomass and carbon in Pinus taeda. Twelve root systems were excavated, washed, weighed and scanned, then reconstructed using a TreeQSM formulation adapted for stump-root systems. Volume was converted to biomass using mean and diameter class-specific basic density, and to carbon using measured carbon contents. QSM-derived volume showed weak-to-moderate agreement with measured volume (A = 0.6292; CC1 = 0.3916; d = 0.6692), with a systematic underestimation of 43.6%. BGB estimates using mean density showed comparable agreement (A = 0.7339; bias 37.9%), while diameter class-specific densities slightly reduced it (A = 0.7126; bias 40.7%). Basic density was lowest in the finest and highest in the coarsest class (0.224–0.298 g·cm−3), whereas carbon content varied only slightly among classes (43.73–44.62%). Belowground carbon showed agreement comparable to BGB and higher than volume (A = 0.7093–0.7308; bias 37.9–40.7%), with no gain from class-specific carbon contents. A single mean density was sufficient to estimate BGB. This simplification is appropriate as long as the error in volume estimation is greater than the error introduced by using a mean density, but this may change as reconstruction methods improve. In addition, the method requires root systems to be excavated and does not allow the assessment of roots in situ.
- Open Access
- 2 October 2023
- Published by Brazilian Journals in Contribuciones A Las Ciencias Sociales
- Vol. 16 (10) , 19097-19114
Dielectric meter for moisture content determination of wood chips
The aim of this study was to evaluate the efficiency of the dielectric meter in predicting moisture content in wood chips based on the input parameter (capacitance) which yields the measured value (moisture). A database was constructed from twelve sets of measurements using the dielectric moisture meter on wood chips of Pinus sp. and Eucalyptus sp. from eight different suppliers. This database was then used to produce a specific curve for each supplier through linear regression. Consequently, a positive linear correlation was observed, with the data points showing a 45° trend in their dispersion on the graph for each curve. It was noted that the dielectric constant decreased as the moisture content reduced during the drying process. With a determination coefficient R² exceeding 80% on the curves, it's feasible to predict the moisture content based on the dielectric properties of each group of wood chips in a swift, practical, and cost-effective manner.
- 2 October 2023
- Published by Brazilian Journals in Contribuciones A Las Ciencias Sociales
- Vol. 16 (10) , 19097-19114
Open AccessDielectric meter for moisture content determination of wood chips
The aim of this study was to evaluate the efficiency of the dielectric meter in predicting moisture content in wood chips based on the input parameter (capacitance) which yields the measured value (moisture). A database was constructed from twelve sets of measurements using the dielectric moisture meter on wood chips of Pinus sp. and Eucalyptus sp. from eight different suppliers. This database was then used to produce a specific curve for each supplier through linear regression. Consequently, a positive linear correlation was observed, with the data points showing a 45° trend in their dispersion on the graph for each curve. It was noted that the dielectric constant decreased as the moisture content reduced during the drying process. With a determination coefficient R² exceeding 80% on the curves, it's feasible to predict the moisture content based on the dielectric properties of each group of wood chips in a swift, practical, and cost-effective manner.