KTKarina Mayumi Tsuruta

Karina Mayumi Tsuruta

*This is an algorithmically generated author record based on publicly available information.

Karina Mayumi Tsuruta has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    DESENVOLVIMENTO DE UMA BANCADA EXPERIMENTAL PARA REDUC¸ AO DA UMIDADE EM ˜ OLEO LUBRIFICANTE POR MEIO DE ´ HIDROGEL

    by Eduardo de Sousa Barbosa, Karina Mayumi Tsuruta, Aldemir Aparecido Cavallini Junior

    A qualidade dos ´oleos lubrificantes ´e cr´ıtica para o desempenho e a confiabilidade de equipamentos industriais e motores. A umidade ´e um dos principais contaminantes, acelerando a degradac¸ ˜ao, promovendo corros˜ao e aumentando custos de manutenc¸ ˜ao. Este estudo investiga um m´etodo de baixo custo e n˜ao invasivo para reduzir o teor de ´agua em ´oleos lubrificantes utilizando materiais `a base de hidrogel. Hidrog´eis s˜ao estruturas polim´ericas hidrof´ılicas capazes de absorver ´agua de forma eficiente sem se dissolver ou alterar propriedades essenciais do oleo.´ Experimentos em bancada, projetados para simular condic¸ ˜oes industriais reais, foram realizados em escala laboratorial. Os resultados mostraram que o hidrogel reduziu efetivamente o teor de ´agua, preservando viscosidade, densidade e estabilidade qu´ımica, sugerindo uma alternativa promissora e sustent´avel para sistemas de lubrificac¸ ˜ao, especialmente em ambientes offshore.

  • Open Access

    Calibration of a low-cost electromechanical impedance-based structural health monitoring device

    by Bruno Pereira Barella, Stanley Washington Ferreira de Rezende, Karina Mayumi Tsuruta, Roberto Mendes Finzi Neto, Jose dos Reis Vieira De Moura Junior

    Steel structures undergo loads and stresses during service life, subject to structural damages such as fatigue, corrosion, cracks, and plastic deformations. Therefore, to detect damage, the dynamic responses of the structures are used, comparing two states: with and without damage. These dynamic responses are obtained from a signal representing the structure's electromechanical impedance. Thus, these impedance signatures must accurately represent the analyzed structure. By comparing the impedance signatures of the low-cost device used at UFG/UFCAT with the SySHM system developed by LMEst/UFU, it can be observed that the low-cost equipment requires calibration in its impedance measurements. This work proposes a method based on the Least-Squares approach to determine a mathematical model to convert the signals acquired by the low-cost device into signals suitable for analysis. In conclusion, it was feasible to demonstrate the utilization potential of the cost-effective device under impedance-based monitoring conditions.