Yunzhao Zang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Yunzhao Zang has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Shuai Yao
Research Center for Space Optical Engineering, Harbin Institute of Technology, Harbin 150001, China
3 shared publications - Hongyuan Wang
School of Astronautics, Harbin Institute of Technology, Harbin 150001, China
2 shared publications - Zhen Liao
Research Center of Space Optical Engineering, Harbin Institute of Technology, Harbin 150001, China
2 shared publications - Zhiqiang Yan
Research Center for Space Optical Engineering, Harbin Institute of Technology, Harbin 150001, China
2 shared publications - Boqi Liu
Research Center of Space Optical Engineering, Harbin Institute of Technology, Harbin 150001, China
1 shared publication Hongyuan Wang
1 shared publication
Latest Publications
- 8 October 2026
- Published by Elsevier in Optics and Lasers in Engineering
- Vol. 208
Simulation method for all-time polarization star sensor star maps in short-wave infrared near-Earth space
- 8 October 2026
- Published by Elsevier in Optics and Lasers in Engineering
- Vol. 208
Simulation method for all-time polarization star sensor star maps in short-wave infrared near-Earth space
- Open Access
Research on Star Sensor Imaging Simulation Under Near-Space Hypersonic Non-Equilibrium Flow Conditions
In order to address the difficulty in acquiring degraded images for star sensors under hypersonic conditions, this paper proposes a star sensor imaging simulation model which can effectively analyze the influence of thermochemical non-equilibrium flow on the star sensor. Firstly, the two-temperature model is adopted to describe the relaxation phenomenon of hypersonic non-equilibrium flow, and the chemical reaction is simulated by Arrhenius law. Then, the effects of optical transmission and thermal radiation on star sensor imaging are quantitatively analyzed. Based on this degradation model, the degraded star images under two typical working conditions are simulated. The simulation results show that the radiation of the solid media has the most significant influence on the imaging of the star sensor. The detectable limit magnitudes of the star sensor obtained under the two working conditions are 3.28 and 4.55, respectively. The research results can provide important theory and technical support for the system design and algorithm testing of star sensors on near-space hypersonic platforms.
Open AccessResearch on Star Sensor Imaging Simulation Under Near-Space Hypersonic Non-Equilibrium Flow Conditions
In order to address the difficulty in acquiring degraded images for star sensors under hypersonic conditions, this paper proposes a star sensor imaging simulation model which can effectively analyze the influence of thermochemical non-equilibrium flow on the star sensor. Firstly, the two-temperature model is adopted to describe the relaxation phenomenon of hypersonic non-equilibrium flow, and the chemical reaction is simulated by Arrhenius law. Then, the effects of optical transmission and thermal radiation on star sensor imaging are quantitatively analyzed. Based on this degradation model, the degraded star images under two typical working conditions are simulated. The simulation results show that the radiation of the solid media has the most significant influence on the imaging of the star sensor. The detectable limit magnitudes of the star sensor obtained under the two working conditions are 3.28 and 4.55, respectively. The research results can provide important theory and technical support for the system design and algorithm testing of star sensors on near-space hypersonic platforms.
- 15 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 75 (00189456) , 1-12
A Phase-Compensation-Based Method for Improving the Centroiding Accuracy of Interferometric Star Trackers
For interferometric star trackers operating under broadband conditions, the zeroth-order diffraction from the Ronchi grating significantly degrades centroiding accuracy. To address this, we present a solution based on a hardware–software codesign. First, we systematically investigate this issue and establish a stellar interference imaging model using the angular spectrum propagation theory. The model accounts for stellar radiation characteristics, grating diffraction properties, and the performance of the beam-splitter assembly. Guided by this model, we introduce a phase-compensated multiwedge beam-splitter architecture together with a centroiding algorithm specifically tailored to the resulting interference modulation. This joint optical algorithm design effectively suppresses the zeroth-order diffraction component at the physical level and maximizes the utilization of the compensated interference signal. Numerical simulations incorporating detector noise are conducted to obtain the star spot energy distribution for centroid evaluation. Simulation results show that, along the grating interference direction, the mean absolute error (MAE) of centroid localization decreases from 0.169 to 0.147 arcsec, while the root-mean-squared error (RMSE) decreases from 0.211 to 0.186 arcsec, indicating a significant improvement in overall accuracy. The proposed method effectively mitigates the adverse effects of the zeroth-order diffraction and serves as an important reference for the design and performance optimization of interferometric star trackers.
- 15 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 75 (00189456) , 1-12
A Phase-Compensation-Based Method for Improving the Centroiding Accuracy of Interferometric Star Trackers
For interferometric star trackers operating under broadband conditions, the zeroth-order diffraction from the Ronchi grating significantly degrades centroiding accuracy. To address this, we present a solution based on a hardware–software codesign. First, we systematically investigate this issue and establish a stellar interference imaging model using the angular spectrum propagation theory. The model accounts for stellar radiation characteristics, grating diffraction properties, and the performance of the beam-splitter assembly. Guided by this model, we introduce a phase-compensated multiwedge beam-splitter architecture together with a centroiding algorithm specifically tailored to the resulting interference modulation. This joint optical algorithm design effectively suppresses the zeroth-order diffraction component at the physical level and maximizes the utilization of the compensated interference signal. Numerical simulations incorporating detector noise are conducted to obtain the star spot energy distribution for centroid evaluation. Simulation results show that, along the grating interference direction, the mean absolute error (MAE) of centroid localization decreases from 0.169 to 0.147 arcsec, while the root-mean-squared error (RMSE) decreases from 0.211 to 0.186 arcsec, indicating a significant improvement in overall accuracy. The proposed method effectively mitigates the adverse effects of the zeroth-order diffraction and serves as an important reference for the design and performance optimization of interferometric star trackers.