Hui Zeng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hui Zeng has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Hao Liu
School of Bailie Mechanical Engineering, Lanzhou City University, No. 572, Anning East Road, Anning District, Lanzhou 730070, China
1 shared publication - Longfei Fu
School of Electrical Engineering, Lanzhou Institute of Technology, No. 1942, East Section of Changjiang Avenue, Lanzhou New Area, Lanzhou 730050, China
1 shared publication - Qiang Cao
School of Intelligent Manufacturing and Robotics, Shanghai Dianji University, Shanghai 201306, China
1 shared publication
Latest Publications
- Open Access
- 1 February 2026
- Published by MDPI AG in Biomimetics
- Vol. 11 (2) , 97
Experimental Evaluation of Kinematic Compatibility in Three Upper Limb Exoskeleton Configurations Using Interface Force and Torque
Upper limb rehabilitation exoskeletons form a spatial closed kinematic chain with the human arm, where inevitable joint-center and axis misalignment can generate hyperstatic interaction forces and torques. Passive degrees of freedom (DOF) are widely introduced to improve kinematic compatibility, yet different compatible configurations may exhibit distinct wearable performance. This study experimentally compares three compatible four-degree-of-freedom exoskeleton configurations derived from the synthesis of Li et al. using a single reconfigurable rehabilitation robot. The platform is assembled into each configuration through modular passive units and instrumented with two six-axis force–torque sensors at the upper-arm and forearm interfaces. Interaction forces and torques are measured in passive training mode during eating and combing trajectories. For each configuration, tests are performed with passive joints released and with passive joints locked to quantify the effect of passive motion accommodation. Directional and resultant metrics are computed using mean and peak values over movement cycles. Results show that releasing passive joints consistently reduces interaction loading, and Category 2 achieves the lowest forces and torques with the strongest peak suppression, indicating the best practical compatibility.
- 1 February 2026
- Published by MDPI AG in Biomimetics
- Vol. 11 (2) , 97
Open AccessExperimental Evaluation of Kinematic Compatibility in Three Upper Limb Exoskeleton Configurations Using Interface Force and Torque
Upper limb rehabilitation exoskeletons form a spatial closed kinematic chain with the human arm, where inevitable joint-center and axis misalignment can generate hyperstatic interaction forces and torques. Passive degrees of freedom (DOF) are widely introduced to improve kinematic compatibility, yet different compatible configurations may exhibit distinct wearable performance. This study experimentally compares three compatible four-degree-of-freedom exoskeleton configurations derived from the synthesis of Li et al. using a single reconfigurable rehabilitation robot. The platform is assembled into each configuration through modular passive units and instrumented with two six-axis force–torque sensors at the upper-arm and forearm interfaces. Interaction forces and torques are measured in passive training mode during eating and combing trajectories. For each configuration, tests are performed with passive joints released and with passive joints locked to quantify the effect of passive motion accommodation. Directional and resultant metrics are computed using mean and peak values over movement cycles. Results show that releasing passive joints consistently reduces interaction loading, and Category 2 achieves the lowest forces and torques with the strongest peak suppression, indicating the best practical compatibility.