Hyun Woo Jeong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hyun Woo Jeong has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Min Hyuk Park
Seoul National University
4 shared publications - Dong Hee Han
Department of Materials Science and Engineering and Research Institute of Advanced Materials Inter‐University Semiconductor Research Center Seoul National University Seoul Republic of Korea
2 shared publications Geun Hyeong Park
2 shared publicationsHeejin Hong
2 shared publications- Hyojun Choi
Department of Materials Science and Engineering and Research Institute of Advanced Materials Inter‐University Semiconductor Research Center Seoul National University Seoul Republic of Korea
2 shared publications Jaewook Lee
2 shared publications
Latest Publications
- 5 November 2026
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 295, 297-305
Substrate thermal expansion shaping phase competition in ferroelectric hafnia-zirconia
- 5 November 2026
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 295, 297-305
Substrate thermal expansion shaping phase competition in ferroelectric hafnia-zirconia
- Open Access
- 24 August 2026
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (77) , e77918
Oxygen‐Vacancy‐Regulated Crystallization and Ferroelectric Phase Stabilization in Hf 0.5 Zr 0.5 O 2 Thin Films
Defect‐regulated crystallization pathways govern metastable phase formation in functional oxides, yet the role of oxygen‐vacancy‐related oxygen deficiency in crystallization and ferroelectric phase stabilization in ultrathin Hf 0.5 Zr 0.5 O 2 remains unresolved. This work combines atomic‐layer‐deposition ozone‐dose tuning with temperature‐resolved in situ grazing‐incidence wide‐angle X‐ray scattering reciprocal‐space mapping to track crystallization in 10 nm Hf 0.5 Zr 0.5 O 2 thin films with systematically varied, X‐ray Photoelectron Spectroscopy‐inferred relative oxygen‐deficiency levels. Vacancy‐lean films crystallize at lower temperatures than vacancy‐rich films (370°C vs. 400°C) and exhibit a lower comparative apparent activation energy for crystallization (3.6 × 10 2 vs. 4.4 × 10 2 kJ mol −1 ), together with more efficient lateral crystallite growth and a larger strain‐free d‐spacing consistent with an increased orthorhombic‐phase contribution. In contrast, vacancy‐rich films show delayed crystallization, suppressed lateral coarsening, and stronger tetragonal‐phase retention. The vacancy‐lean film achieves a switchable polarization, 2P r , of 19.9 µC cm −2 after annealing at 400°C, within a back‐end‐of‐line‐relevant thermal budget; higher annealing temperatures induce partial monoclinic transformation and reduce polarization. These results identify oxygen‐deficiency control as a practical route to tune crystallization pathways and low‐temperature ferroelectric phase formation in HfO 2 ‐based thin films.
- 24 August 2026
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (77) , e77918
Open AccessOxygen‐Vacancy‐Regulated Crystallization and Ferroelectric Phase Stabilization in Hf 0.5 Zr 0.5 O 2 Thin Films
Defect‐regulated crystallization pathways govern metastable phase formation in functional oxides, yet the role of oxygen‐vacancy‐related oxygen deficiency in crystallization and ferroelectric phase stabilization in ultrathin Hf 0.5 Zr 0.5 O 2 remains unresolved. This work combines atomic‐layer‐deposition ozone‐dose tuning with temperature‐resolved in situ grazing‐incidence wide‐angle X‐ray scattering reciprocal‐space mapping to track crystallization in 10 nm Hf 0.5 Zr 0.5 O 2 thin films with systematically varied, X‐ray Photoelectron Spectroscopy‐inferred relative oxygen‐deficiency levels. Vacancy‐lean films crystallize at lower temperatures than vacancy‐rich films (370°C vs. 400°C) and exhibit a lower comparative apparent activation energy for crystallization (3.6 × 10 2 vs. 4.4 × 10 2 kJ mol −1 ), together with more efficient lateral crystallite growth and a larger strain‐free d‐spacing consistent with an increased orthorhombic‐phase contribution. In contrast, vacancy‐rich films show delayed crystallization, suppressed lateral coarsening, and stronger tetragonal‐phase retention. The vacancy‐lean film achieves a switchable polarization, 2P r , of 19.9 µC cm −2 after annealing at 400°C, within a back‐end‐of‐line‐relevant thermal budget; higher annealing temperatures induce partial monoclinic transformation and reduce polarization. These results identify oxygen‐deficiency control as a practical route to tune crystallization pathways and low‐temperature ferroelectric phase formation in HfO 2 ‐based thin films.
- Open Access
- 3 August 2026
- Published by Elsevier in Applied Surface Science Advances
- Vol. 34
A sacrificial HfN interlayer enables oxygen-buffered Mo electrodes for sub‑0.4nm equivalent oxide thickness of HfO2/ZrO2 nanolaminates for DRAM capacitors
- 3 August 2026
- Published by Elsevier in Applied Surface Science Advances
- Vol. 34
Open AccessA sacrificial HfN interlayer enables oxygen-buffered Mo electrodes for sub‑0.4nm equivalent oxide thickness of HfO2/ZrO2 nanolaminates for DRAM capacitors
- Open Access
- 26 January 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (4)
High-performance annealing-free InGaZnOx thin film transistors by thermal ALD
We report indium–gallium–zinc oxide (IGZO) thin-film transistors (TFTs) fabricated entirely by thermal atomic layer deposition (TALD) within a low thermal budget (≤300 °C) and without post-deposition annealing. A targeted O3 overdose step integrated into the Ga2O3 sub-cycles of the IGZO TALD super-cycle raises the local oxygen chemical potential and helps suppress inter-sub-cycle redox reactions and vacancy formation. Structural and chemical analyses confirm smooth, fully amorphous Al2O3/IGZO stacks with abrupt interfaces and reduced oxygen-vacancy signatures, while cation states remain stable. Standard TFTs fabricated from these layer stacks exhibit excellent device performance, including near-ideal subthreshold swing (SS) values of 66.4–70 mV/dec, operation windows within 3 V, field-effect mobilities ranging between μFE = 23.6–25.6 cm2/Vs, threshold voltages (VTH) close to 0 V, and negligible hysteresis. Under positive-bias temperature stress, ΔVTH remains small across 25–85 °C, indicating good device reliability. A holistic comparison with prior ALD-based oxide TFTs shows that the combination of low temperature processing, near-ideal SS, and small drift under stress places our devices on the favorable end of performance–stability trade-off. The O3 overdose concept presented here provides a generalizable lever for oxygen vacancy control in the TALD of multi-cation oxides and is naturally compatible with BEOL and monolithic 3D integration.
- 26 January 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 128 (4)
Open AccessHigh-performance annealing-free InGaZnOx thin film transistors by thermal ALD
We report indium–gallium–zinc oxide (IGZO) thin-film transistors (TFTs) fabricated entirely by thermal atomic layer deposition (TALD) within a low thermal budget (≤300 °C) and without post-deposition annealing. A targeted O3 overdose step integrated into the Ga2O3 sub-cycles of the IGZO TALD super-cycle raises the local oxygen chemical potential and helps suppress inter-sub-cycle redox reactions and vacancy formation. Structural and chemical analyses confirm smooth, fully amorphous Al2O3/IGZO stacks with abrupt interfaces and reduced oxygen-vacancy signatures, while cation states remain stable. Standard TFTs fabricated from these layer stacks exhibit excellent device performance, including near-ideal subthreshold swing (SS) values of 66.4–70 mV/dec, operation windows within 3 V, field-effect mobilities ranging between μFE = 23.6–25.6 cm2/Vs, threshold voltages (VTH) close to 0 V, and negligible hysteresis. Under positive-bias temperature stress, ΔVTH remains small across 25–85 °C, indicating good device reliability. A holistic comparison with prior ALD-based oxide TFTs shows that the combination of low temperature processing, near-ideal SS, and small drift under stress places our devices on the favorable end of performance–stability trade-off. The O3 overdose concept presented here provides a generalizable lever for oxygen vacancy control in the TALD of multi-cation oxides and is naturally compatible with BEOL and monolithic 3D integration.