YLYue Lang

Yue Lang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yue Lang has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Bubble-Point Pressure Deviations and Metastable Nucleation in Nanoconfined CO2–Shale Oil Systems: Effects of Temperature, Composition, Gas–Oil Ratio, and Pore-Scale Coupling

    by Dongyan Qi, Jiawei Li, Qiang Liu, Shuang Wang, Siyuan Cui, Yue Lang, Jiayi Zhao, Xiaozhe Liang, Junjie Zhong

    Bubble-point behavior of shale oil under nanoconfinement is critical for understanding phase evolution during CO2-enhanced shale-oil recovery. In this study, visual micro/nanofluidic PVT experiments were conducted to systematically investigate bubble-point pressure deviations of pentane–CO2, hexadecane–CO2, pentane/decane/hexadecane–CO2, and shale oil–CO2 systems. Measurements were performed at gas–oil ratios of 130 and 260 and temperatures of 65–125 °C using a 10 nm single-scale pore model and a coupled 10 μm–10 nm pore-network model. Experimental results were compared with theoretical predictions from a confinement-modified Peng–Robinson equation of state incorporating capillary pressure, surface adsorption, and critical-property shifts. Furthermore, a metastable nucleation limit was introduced to describe the experimentally observed phase-transition pressure below the equilibrium bubble-point boundary. Pronounced downward deviations toward the metastable region were observed in isolated 10 nm pores. For the pentane–CO2 system at 65 °C and GOR = 130, the experimentally observed phase-transition pressure was approximately 3.5 MPa, compared with an equilibrium prediction of 4.3 MPa, corresponding to a relative deviation of 18.35%. The deviation decreased as temperature approached the critical region and was reduced at higher GOR. For example, at GOR = 260, the deviation of the hexadecane–CO2 system decreased from 40.63% at 65 °C to 10.01% at 125 °C. Fluid composition also strongly affected confinement sensitivity, with heavier hydrocarbon systems exhibiting stronger shifts toward metastable behavior. In contrast, bubble-point pressures in the coupled 10 μm–10 nm network remained close to the equilibrium predictions of the micrometer-scale pores and deviated significantly from the metastable limit. For the shale oil–CO2 system at 65 °C and GOR = 130, the relative deviation decreased from 29.77% in the isolated 10 nm pore model to only 2.43% in the coupled 10 μm–10 nm network. These results demonstrate that nanoconfined bubble-point behavior is governed by the coupled effects of thermodynamic conditions, fluid composition, metastability, and pore-scale connectivity.

  • Open Access

    Performance and Numerical Simulation of Gel–Foam Systems for Profile Control and Flooding in Fractured Reservoirs

    by Junhui Bai, Yingwei He, Jiawei Li, Yue Lang, Zhengxiao Xu, Tongtong Zhang, Qiao Sun, Xun Wei, Fengrui Yang

    Enhanced oil recovery (EOR) in fractured reservoirs presents significant challenges due to fluid channeling and poor sweep efficiency. In this study, a synergistic EOR system was developed with polymer-based weak gel as the primary component and foam as the auxiliary enhancer. The system utilizes a low-concentration polymer (1000 mg·L−1) that forms a weakly cross-linked three-dimensional viscoelastic gel network in the aqueous phase, inheriting the core functions of viscosity enhancement and profile control from polymer flooding. Foam acts as an auxiliary component, leveraging the high sweep efficiency and strong displacement capability of gas in fractures. These two components synergistically create a multiscale enhancement mechanism of “bulk-phase stability control and interfacial-driven displacement.” Systematic screening of seven foaming agents identified an optimal formulation of 0.5% SDS and 1000 mg·L−1 polymer. Two-dimensional visual flow experiments demonstrated that the polymer-induced gel network significantly improves mobility control and sweep efficiency under various injection volumes (0.1–0.7 PV) and gravity segregation conditions. Numerical simulation in a 3D fractured network model confirmed the superiority of this enhanced system, achieving a final oil recovery rate of 75%, significantly outperforming gas flooding (65%) and water flooding (59%). These findings confirm that weakly cross-linked polymer gels serve as the principal EOR material, with foam providing complementary reinforcement, offering robust conformance control and enhanced recovery potential in fracture-dominated reservoirs.