Ece Basaran
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ece Basaran has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Ayla Khanmohammadi
Department of Orthodontics, Faculty of Dentistry, İnönü University, Malatya 44280, Türkiye
1 shared publication Beste Ege
1 shared publication- Beste Ege1 shared publication
- Buse Kelemenç1 shared publication
- Deniz Berk Bekar1 shared publication
- Dilara Akyüz1 shared publication
Latest Publications
- 3 April 2026
- Published by Oxford University Press (OUP) in European Journal of Orthodontics
- Vol. 48 (3)
Evaluation of tooth discoloration and bleaching response in the presence of clear aligners and attachments
Objective: To evaluate the influence of clear aligners with and without attachments on tooth discoloration after exposure to common staining beverages, and to assess the bleaching effect of %6 hydrogen peroxide (HP) agent applied through aligners. Methods: Forty extracted human premolars were allocated into four groups (n = 10): attachments only, no aligners or attachments, aligners with attachments, and aligners only. Specimens mounted on typodont models and fitted with Invisalign aligners. Typodont models were sequentially immersed in artificial saliva, tea, coffee, and red wine for 6 days each, simulating 6 months of consumption. Aligners were replaced every 12 hours, and staining solutions were renewed daily. Color measurements were recorded at baseline and after each experimental stage using standardized digital photography, and color differences were calculated using the CIEDE2000 (ΔE00) formula. Following the staining protocol, bleaching was performed for 6 days using a 6% HP based gel applied through aligners. Statistical analysis was performed using the Kruskal–Wallis H test (P < .05). Results: All groups demonstrated clinically perceptible discoloration after staining. The greatest mean color change was observed in the attachment only group (ΔE00 = 23.30), whereas the lowest discoloration occurred in the aligners only group (ΔE00 = 6.60). Red wine produced the greatest color change among staining agents, while tea and coffee produced comparable staining. Bleaching significantly reduced discoloration in all groups. Conclusion: Commonly consumed staining agents produced clinically perceptible tooth discoloration. Composite attachments increased susceptibility to tooth discoloration, whereas aligners showed a protective effect by limiting color change. Bleaching with 6% HP agent applied through aligners significantly reduced discoloration. Dietary habits and the presence of attachments should be considered when managing esthetic concerns during clear aligner therapy (CAT), and bleaching may be recommended without waiting for attachment removal.
- 3 April 2026
- Published by Oxford University Press (OUP) in European Journal of Orthodontics
- Vol. 48 (3)
Evaluation of tooth discoloration and bleaching response in the presence of clear aligners and attachments
Objective: To evaluate the influence of clear aligners with and without attachments on tooth discoloration after exposure to common staining beverages, and to assess the bleaching effect of %6 hydrogen peroxide (HP) agent applied through aligners. Methods: Forty extracted human premolars were allocated into four groups (n = 10): attachments only, no aligners or attachments, aligners with attachments, and aligners only. Specimens mounted on typodont models and fitted with Invisalign aligners. Typodont models were sequentially immersed in artificial saliva, tea, coffee, and red wine for 6 days each, simulating 6 months of consumption. Aligners were replaced every 12 hours, and staining solutions were renewed daily. Color measurements were recorded at baseline and after each experimental stage using standardized digital photography, and color differences were calculated using the CIEDE2000 (ΔE00) formula. Following the staining protocol, bleaching was performed for 6 days using a 6% HP based gel applied through aligners. Statistical analysis was performed using the Kruskal–Wallis H test (P < .05). Results: All groups demonstrated clinically perceptible discoloration after staining. The greatest mean color change was observed in the attachment only group (ΔE00 = 23.30), whereas the lowest discoloration occurred in the aligners only group (ΔE00 = 6.60). Red wine produced the greatest color change among staining agents, while tea and coffee produced comparable staining. Bleaching significantly reduced discoloration in all groups. Conclusion: Commonly consumed staining agents produced clinically perceptible tooth discoloration. Composite attachments increased susceptibility to tooth discoloration, whereas aligners showed a protective effect by limiting color change. Bleaching with 6% HP agent applied through aligners significantly reduced discoloration. Dietary habits and the presence of attachments should be considered when managing esthetic concerns during clear aligner therapy (CAT), and bleaching may be recommended without waiting for attachment removal.
- Open Access
- 30 March 2026
- Published by Springer Nature in BMC Oral Health
- Vol. 26 (1)
Investigation of temperature change during interproximal reduction and subsequent polishing
Background: Interproximal reduction (IPR) is widely used in orthodontics, but the heat generated during this procedure may affect pulp tissue. The aim of this study is to evaluate the temperature changes in the pulp chamber of lower incisor teeth during IPR process and subsequent polishing, by simulating the pulpal microcirculation, with a thermal camera. Methods: Intact and extracted 21 lower incisors were prepared and placed on the pulpal microcirculation model were treated with 0.3 mm IPR with perforated diamond-coated disc. As second step, the samples were polished for 80 s with fine Sof-Lex discs. On one surface of the teeth, the polishing process was carried out dry, on the other surface with water cooling. The initial pulp chamber temperature (T 0 ), 45th second (T 1 ), 60th second (T 2 ), and 80th second (T 3 ) temperatures were recorded with a thermal camera. Results: The temperature change (∆T) at the IPR was measured as 2.74 ± 1.4 °C. ∆T were measured as 2.74 °C and 3.73 °C, respectively, at the water cooling and dry polishing groups. T 1 , T 2 , T 3 , T max and ∆T temperature measurements of water cooling and dry polishing groups show statistically significant differences ( p < 0.001). ∆T measurement of the dry polishing group was found higher, but temperature increase above the critical value of 5.5 °C was not detected in both groups. Conclusions: Statistically significant temperature increase occurs in both IPR and polishing application. As a result of the polishing with or without water cooling, no temperature increase above 5.5 °C occurred. The temperature increase recorded during the 80 s polishing with Sof-Lex discs following IPR was not sufficient enough to harm pulp tissue. Practical implications: Although a statistically significant temperature increase was observed during both IPR and polishing, no temperature increase above 5.5°C was detected during IPR. The higher temperature increase observed with dry polishing compared to water cooling suggests that water cooling is an effective method to reduce temperature increase. The temperature change during the 80 second polishing with Sof-Lex discs following IPR is not at a level that would harm the pulp tissue.
- 30 March 2026
- Published by Springer Nature in BMC Oral Health
- Vol. 26 (1)
Open AccessInvestigation of temperature change during interproximal reduction and subsequent polishing
Background: Interproximal reduction (IPR) is widely used in orthodontics, but the heat generated during this procedure may affect pulp tissue. The aim of this study is to evaluate the temperature changes in the pulp chamber of lower incisor teeth during IPR process and subsequent polishing, by simulating the pulpal microcirculation, with a thermal camera. Methods: Intact and extracted 21 lower incisors were prepared and placed on the pulpal microcirculation model were treated with 0.3 mm IPR with perforated diamond-coated disc. As second step, the samples were polished for 80 s with fine Sof-Lex discs. On one surface of the teeth, the polishing process was carried out dry, on the other surface with water cooling. The initial pulp chamber temperature (T 0 ), 45th second (T 1 ), 60th second (T 2 ), and 80th second (T 3 ) temperatures were recorded with a thermal camera. Results: The temperature change (∆T) at the IPR was measured as 2.74 ± 1.4 °C. ∆T were measured as 2.74 °C and 3.73 °C, respectively, at the water cooling and dry polishing groups. T 1 , T 2 , T 3 , T max and ∆T temperature measurements of water cooling and dry polishing groups show statistically significant differences ( p < 0.001). ∆T measurement of the dry polishing group was found higher, but temperature increase above the critical value of 5.5 °C was not detected in both groups. Conclusions: Statistically significant temperature increase occurs in both IPR and polishing application. As a result of the polishing with or without water cooling, no temperature increase above 5.5 °C occurred. The temperature increase recorded during the 80 s polishing with Sof-Lex discs following IPR was not sufficient enough to harm pulp tissue. Practical implications: Although a statistically significant temperature increase was observed during both IPR and polishing, no temperature increase above 5.5°C was detected during IPR. The higher temperature increase observed with dry polishing compared to water cooling suggests that water cooling is an effective method to reduce temperature increase. The temperature change during the 80 second polishing with Sof-Lex discs following IPR is not at a level that would harm the pulp tissue.
- 15 April 2025
- Published by Academician Publishing
- p. 187-212
Ortodontide Ototransplantasyon
- Open Access
- 15 April 2025
- Published by Academician Publishing
Güncel Ortodonti Çalışmaları V (Bahar)
Şeffaf Plaklar ve Sabit Apareylerin Periodontal Sağlık Üzerine Etkileri Ezgi Dilara BARLAS Dijital Ortodonti: Üç Boyutlu Yazıcılar Farhad SALMANPOUR Kapaklı Braketler Deniz Berk BEKAR Sanaz SADRY Şeffaf Plaklarda Ataşman Kullanımı Özge ÜNLÜOĞLU Yazgı AY ÜNÜVAR Ortodontide Yapay Zekâ Mümine GÖKYER ŞEVİK Hatice KÖK Ortodontide Genetik Bilgi & Klinik Uygulamadaki Yeri Taha GÜMÜŞCAN Hatice KÖK Gömülü Kaninler ve Tedavi Alternatifleri Tuğçe Esra GÜNEŞ Mehmet AKIN Retansiyon Eda YILDIRIM Mine GEÇGELEN CESUR Ortognatik Cerrahide Tedavi Aşamaları ve Yumuşak Dokulara Etkisi Dilara AKYÜZ Hatice KÖK Ortodontik Tedavilerde Şeffaf Plaklar Handan Göze OĞUZ Ortodontide Mikrosensör Kullanımı Serpil ÇOKAKOĞLU Ortodontide Ototransplantasyon Ece BAŞARAN Beste EGE Ortodontide Botulinum Toksinin Yeri Neslihan KARAOĞLAN Hakan KARAOĞLAN Dudak Damak Yarıklı Hastalarda Ortodontik Yaklaşım Ayla KHANMOHAMMADİ Sabahattin BOR Sınıf II Maloklüzyonların Tedavisinde İntraoral Maksiller Molar Distalizasyon Yöntemleri Buse KELEMENÇE Yazgı AY ÜNÜVAR Ortodontik Diş Hareketini Hızlandırma Yöntemleri Mehman AMİRASLANLI Fırat OĞUZ
- 15 April 2025
- Published by Academician Publishing
Open AccessGüncel Ortodonti Çalışmaları V (Bahar)
Şeffaf Plaklar ve Sabit Apareylerin Periodontal Sağlık Üzerine Etkileri Ezgi Dilara BARLAS Dijital Ortodonti: Üç Boyutlu Yazıcılar Farhad SALMANPOUR Kapaklı Braketler Deniz Berk BEKAR Sanaz SADRY Şeffaf Plaklarda Ataşman Kullanımı Özge ÜNLÜOĞLU Yazgı AY ÜNÜVAR Ortodontide Yapay Zekâ Mümine GÖKYER ŞEVİK Hatice KÖK Ortodontide Genetik Bilgi & Klinik Uygulamadaki Yeri Taha GÜMÜŞCAN Hatice KÖK Gömülü Kaninler ve Tedavi Alternatifleri Tuğçe Esra GÜNEŞ Mehmet AKIN Retansiyon Eda YILDIRIM Mine GEÇGELEN CESUR Ortognatik Cerrahide Tedavi Aşamaları ve Yumuşak Dokulara Etkisi Dilara AKYÜZ Hatice KÖK Ortodontik Tedavilerde Şeffaf Plaklar Handan Göze OĞUZ Ortodontide Mikrosensör Kullanımı Serpil ÇOKAKOĞLU Ortodontide Ototransplantasyon Ece BAŞARAN Beste EGE Ortodontide Botulinum Toksinin Yeri Neslihan KARAOĞLAN Hakan KARAOĞLAN Dudak Damak Yarıklı Hastalarda Ortodontik Yaklaşım Ayla KHANMOHAMMADİ Sabahattin BOR Sınıf II Maloklüzyonların Tedavisinde İntraoral Maksiller Molar Distalizasyon Yöntemleri Buse KELEMENÇE Yazgı AY ÜNÜVAR Ortodontik Diş Hareketini Hızlandırma Yöntemleri Mehman AMİRASLANLI Fırat OĞUZ