Zunaira Javaid
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zunaira Javaid has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Guangchao Han
School of Mechanical Engineering and Electronic Information, China University of Geosciences, Wuhan, China
1 shared publication - Liang Hao
Institute of Applied Physics and Computational Mathematics
1 shared publication - Qiaoyu Chen
Gemmological Institute, China University of Geosciences, Wuhan 430074, China
1 shared publication - Shamoon Al Islam
Gemmological Institute, China University of Geosciences, Wuhan 430074, China
1 shared publication - Wei Xiong
Gemmological Institute, China University of Geosciences, Wuhan 430074, China
1 shared publication - Yan Li
Institute for Advanced Marine Research, China University of Geosciences, Guangzhou, China
1 shared publication
Latest Publications
- Open Access
- 29 February 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (3) , 348
Surface Roughness of Interior Fine Flow Channels in Selective Laser Melted Ti-6Al-4V Alloy Components
A challenge remains in achieving adequate surface roughness of SLM fabricated interior channels, which is crucial for fuel delivery in the space industry. This study investigated the surface roughness of interior fine flow channels (1 mm diameter) embedded in SLM fabricated TC4 alloy space components. A machine learning approach identified layer thickness as a significant factor affecting interior channel surface roughness, with an importance score of 1.184, followed by scan speed and laser power with scores of 0.758 and 0.512, respectively. The roughness resulted from thin layer thickness of 20 µm, predominantly formed through powder adherence, while from thicker layer of 50 µm, the roughness was mainly due to the stair step effect. Slow scan speeds increased melt pools solidification time at roof overhangs, causing molten metal to sag under gravity. Higher laser power increased melt pools temperature and led to dross formation at roof overhangs. Smaller hatch spaces increased roughness due to overlapping of melt tracks, while larger hatch spaces reduced surface roughness but led to decreased part density. The surface roughness was recorded at 34 µm for roof areas and 26.15 µm for floor areas. These findings contribute to potential adoption of TC4 alloy components in the space industry.
- 29 February 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (3) , 348
Open AccessSurface Roughness of Interior Fine Flow Channels in Selective Laser Melted Ti-6Al-4V Alloy Components
A challenge remains in achieving adequate surface roughness of SLM fabricated interior channels, which is crucial for fuel delivery in the space industry. This study investigated the surface roughness of interior fine flow channels (1 mm diameter) embedded in SLM fabricated TC4 alloy space components. A machine learning approach identified layer thickness as a significant factor affecting interior channel surface roughness, with an importance score of 1.184, followed by scan speed and laser power with scores of 0.758 and 0.512, respectively. The roughness resulted from thin layer thickness of 20 µm, predominantly formed through powder adherence, while from thicker layer of 50 µm, the roughness was mainly due to the stair step effect. Slow scan speeds increased melt pools solidification time at roof overhangs, causing molten metal to sag under gravity. Higher laser power increased melt pools temperature and led to dross formation at roof overhangs. Smaller hatch spaces increased roughness due to overlapping of melt tracks, while larger hatch spaces reduced surface roughness but led to decreased part density. The surface roughness was recorded at 34 µm for roof areas and 26.15 µm for floor areas. These findings contribute to potential adoption of TC4 alloy components in the space industry.