Hong-Jae Jeong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hong-Jae Jeong has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Jae-Won Kim
Department of Electronic Engineering, Engineering Research Institute (ERI), Gyeongsang National University, Jinju, South Korea
2 shared publications - Hyeon-Bhin Lee
Department of Electronic Engineering, Engineering Research Institute (ERI), Gyeongsang National University, Jinju, South Korea
1 shared publication
Latest Publications
- 6 May 2026
- Published by Elsevier in Physical Communication
- Vol. 77
Construction of protograph-based PD-GLDPC codes over non-uniform channel
- 6 May 2026
- Published by Elsevier in Physical Communication
- Vol. 77
Construction of protograph-based PD-GLDPC codes over non-uniform channel
- 28 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Green Communications and Networking
- Vol. 10, 2026-2036
Decoding of LDPC Codes Using Singularity of SNR Mismatch Over AWGN Channel
In this paper, we propose a new decoding algorithm that guarantees superior decoding performances for low-density parity-check (LDPC) codes without knowledge of channel parameters. Although obtaining correct channel parameters is very difficult in low-latency and energy-efficient communication systems, most studies on LDPC codes assume perfect knowledge of channel parameters. While receivers can obtain correct channel parameters by utilizing numerous pilot signals, increased overhead makes them infeasible in practical systems. In addition, using incorrect channel parameters for decoding usually degrades decoding performances. These challenges highlight the need for a new decoder that performs reliably without correct channel parameters. Meanwhile, the previous studies on repeat-accumulate (RA) codes and LDPC codes have observed that the signal-to-noise ratio (SNR) mismatch sometimes enhances decoding performances when the maximum number of decoding iterations is small. Inspired by these observations, we investigate singularity of the SNR mismatch in LDPC codes from numerous frame error rate (FER) simulations. By utilizing this singularity, we propose a new decoding algorithm for the energy-efficient communication system, where correct channel parameters are not available at receivers. The proposed decoder shows a performance gain of 0.25 dB at FER = 10−6 compared to the conventional belief propagation (BP) algorithm.
- 28 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Green Communications and Networking
- Vol. 10, 2026-2036
Decoding of LDPC Codes Using Singularity of SNR Mismatch Over AWGN Channel
In this paper, we propose a new decoding algorithm that guarantees superior decoding performances for low-density parity-check (LDPC) codes without knowledge of channel parameters. Although obtaining correct channel parameters is very difficult in low-latency and energy-efficient communication systems, most studies on LDPC codes assume perfect knowledge of channel parameters. While receivers can obtain correct channel parameters by utilizing numerous pilot signals, increased overhead makes them infeasible in practical systems. In addition, using incorrect channel parameters for decoding usually degrades decoding performances. These challenges highlight the need for a new decoder that performs reliably without correct channel parameters. Meanwhile, the previous studies on repeat-accumulate (RA) codes and LDPC codes have observed that the signal-to-noise ratio (SNR) mismatch sometimes enhances decoding performances when the maximum number of decoding iterations is small. Inspired by these observations, we investigate singularity of the SNR mismatch in LDPC codes from numerous frame error rate (FER) simulations. By utilizing this singularity, we propose a new decoding algorithm for the energy-efficient communication system, where correct channel parameters are not available at receivers. The proposed decoder shows a performance gain of 0.25 dB at FER = 10−6 compared to the conventional belief propagation (BP) algorithm.