Julie-Ann Hoffman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Julie-Ann Hoffman has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Eric van Steen
University of Cape Town (UCT)
4 shared publications - Felix Studt
Karlsruhe Institute of Technology Hermann-von-Helmholtz-Platz 1
3 shared publications - Catalina Elena Jimenez
Department of Interface Design and Energy Materials In Situ Laboratory Berlin (EMIL) Helmholtz‐Zentrum Berlin für Materialien und Energie GmbH Berlin Germany
2 shared publications - Enrico Sireci
Karlsruhe Institute of Technology Hermann-von-Helmholtz-Platz 1
2 shared publications - Pinar Sakoglu
Helmholtz-Zentrum Berlin für Materialien und Energie GmbH, HZB
2 shared publications - Thobani G. Gambu
Catalysis Institute, Department of Chemical Engineering, University of Cape Town (UCT), P.O. Box X3, Rondebosch 7701, Cape Town, South Africa
2 shared publications
Latest Publications
- Open Access
- 14 September 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (19) , 19336-19351
Elucidating Mn Promoter Structures and Stability on Co Nanoparticles through a Machine Learning Potential-Powered Genetic Algorithm
Mn promotion has emerged as a prominent route to deliver the next-generation Co Fischer–Tropsch (FT) catalysts, urgently needed to scale up the production of aviation fuels. Nonetheless, to date, the underlying promotional mechanism has not been fully understood. While theoretical calculations have been previously carried out to address this task, the choice of the models has so far been limited, leaving possibly important factors unexplored. In this work, we have employed a genetic algorithm (GA) powered by machine learning potential (MLP) to optimize Mn structures on realistic models of 6–8 nm fcc and hcp Co nanoparticles (NPs) obtained via our recently published DFT–Monte Carlo (MC) approach. The resulting phase diagrams indicate that Mn structures are hydroxylated during FT, while their stoichiometry after activation is MnO–MnO1.5. Mn was found to strongly bind to the Co NPs, although increasing loading considerably weakened the metal–promoter interactions. The structural characterization of the low-energy candidates produced during the GA runs revealed that Mn forms monolayer-like, mostly amorphous patches on the Co surface, which largely influences the promoter structures. Furthermore, we observed that Mn preferentially binds to the Co low-coordinate sites (LCS), which become almost fully covered already at the lowest investigated promoter loading. Last, we employed a magnetic moment–oxidation state correlation to predict the charge of Mn in our models, which was found to always be roughly 2+ regardless of the NP model, Mn phase, and loading. This was ascribed to a charge compensation mechanism involving the Co surface, which keeps Mn in the particularly favorable 2+ electronic configuration despite the actual promoter phase stoichiometry.
- 14 September 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (19) , 19336-19351
Open AccessElucidating Mn Promoter Structures and Stability on Co Nanoparticles through a Machine Learning Potential-Powered Genetic Algorithm
Mn promotion has emerged as a prominent route to deliver the next-generation Co Fischer–Tropsch (FT) catalysts, urgently needed to scale up the production of aviation fuels. Nonetheless, to date, the underlying promotional mechanism has not been fully understood. While theoretical calculations have been previously carried out to address this task, the choice of the models has so far been limited, leaving possibly important factors unexplored. In this work, we have employed a genetic algorithm (GA) powered by machine learning potential (MLP) to optimize Mn structures on realistic models of 6–8 nm fcc and hcp Co nanoparticles (NPs) obtained via our recently published DFT–Monte Carlo (MC) approach. The resulting phase diagrams indicate that Mn structures are hydroxylated during FT, while their stoichiometry after activation is MnO–MnO1.5. Mn was found to strongly bind to the Co NPs, although increasing loading considerably weakened the metal–promoter interactions. The structural characterization of the low-energy candidates produced during the GA runs revealed that Mn forms monolayer-like, mostly amorphous patches on the Co surface, which largely influences the promoter structures. Furthermore, we observed that Mn preferentially binds to the Co low-coordinate sites (LCS), which become almost fully covered already at the lowest investigated promoter loading. Last, we employed a magnetic moment–oxidation state correlation to predict the charge of Mn in our models, which was found to always be roughly 2+ regardless of the NP model, Mn phase, and loading. This was ascribed to a charge compensation mechanism involving the Co surface, which keeps Mn in the particularly favorable 2+ electronic configuration despite the actual promoter phase stoichiometry.
- Open Access
- 7 September 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (18) , 18151-18162
MnO Decoration on Co(0001): Charge Transfer, Surface Restructuring, and Enhanced CO Dissociation in Fischer–Tropsch Synthesis
Mn is a well-established promoter of Co-based catalysts for enhancing the production of long-chain hydrocarbons via Fischer–Tropsch synthesis (FTS). Revealing mechanistic insights into metal–promoter interactions requires atomically defined Co surfaces with highly controlled addition of Mn. In this study, Mn was deposited onto Co(0001) single crystals to tune Mn:Co ratios relevant to FTS, while X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy were used to access the electronic and chemical alterations. Scanning tunneling microscopy revealed the MnO decoration on Co(0001) while density functional theory (DFT) was employed to correlate the atomic structure of MnO on Co(0001) and its effect on the valence band spectra. Solid–gas interactions were investigated in various atmospheres enabling in situ correlation among surface composition, structure, and catalytic conditions. We find a substrate-induced growth of MnO clusters on the Co(0001) surface. Valence band spectra and DFT calculations reveal a charge transfer between Mn and Co at the MnO–Co interface and alterations of the chemical structures. Moreover, in the presence of Mn under relevant FT reaction conditions, CO dissociation and formation of carbonaceous intermediates (–C/–CH) are enhanced, which highlights the promotional role of Mn in facilitating key steps of the Fischer–Tropsch reaction.
- 7 September 2026
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 16 (18) , 18151-18162
Open AccessMnO Decoration on Co(0001): Charge Transfer, Surface Restructuring, and Enhanced CO Dissociation in Fischer–Tropsch Synthesis
Mn is a well-established promoter of Co-based catalysts for enhancing the production of long-chain hydrocarbons via Fischer–Tropsch synthesis (FTS). Revealing mechanistic insights into metal–promoter interactions requires atomically defined Co surfaces with highly controlled addition of Mn. In this study, Mn was deposited onto Co(0001) single crystals to tune Mn:Co ratios relevant to FTS, while X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy were used to access the electronic and chemical alterations. Scanning tunneling microscopy revealed the MnO decoration on Co(0001) while density functional theory (DFT) was employed to correlate the atomic structure of MnO on Co(0001) and its effect on the valence band spectra. Solid–gas interactions were investigated in various atmospheres enabling in situ correlation among surface composition, structure, and catalytic conditions. We find a substrate-induced growth of MnO clusters on the Co(0001) surface. Valence band spectra and DFT calculations reveal a charge transfer between Mn and Co at the MnO–Co interface and alterations of the chemical structures. Moreover, in the presence of Mn under relevant FT reaction conditions, CO dissociation and formation of carbonaceous intermediates (–C/–CH) are enhanced, which highlights the promotional role of Mn in facilitating key steps of the Fischer–Tropsch reaction.
- 23 January 2026
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 16 (5) , 1488-1530
Manganese-enhanced cobalt catalysts for Fischer–Tropsch synthesis: a review of structural and electronic promotion effects
This review explores the benefits of Mn promotion in Co catalysts for FTS applications, delving into the mechanistic insights and identifying key research questions for future investigation.
- 23 January 2026
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 16 (5) , 1488-1530
Manganese-enhanced cobalt catalysts for Fischer–Tropsch synthesis: a review of structural and electronic promotion effects
This review explores the benefits of Mn promotion in Co catalysts for FTS applications, delving into the mechanistic insights and identifying key research questions for future investigation.
- Open Access
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 28 (27) , 17025-17033
Bridging calculated charges and formal oxidation state of manganese oxides: a DFT/DFT+ U study
Bridging the gap between theoretically predicted and measured metal oxides charges is crucial when using synergistically computational and experimental techniques to ensure reliability of the models.
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 28 (27) , 17025-17033
Open AccessBridging calculated charges and formal oxidation state of manganese oxides: a DFT/DFT+ U study
Bridging the gap between theoretically predicted and measured metal oxides charges is crucial when using synergistically computational and experimental techniques to ensure reliability of the models.